arXiv subjects

Shuman Sun

Publications and source records attributed to Shuman Sun.

7 recordsLinked to original sources

arXiv2026

Heterogeneously Integrated Squeezed-Light Generation and Detection on a Single Photonic Chip

Squeezed light underpins quantum-enhanced sensing and continuous-variable quantum information processing, and integrated photonics offers a route to producing it at scale. Universal to these applications are squeezed-light generation and measurement. Importantly, quantum measurements serve not only as readout but also as active operations in quantum-state evolution. However, integrating squeezed-light generation and photodetection on the same photonic chip has remained challenging because they impose fundamentally conflicting material requirements: low optical loss to preserve quantum correlations, but efficient photon absorption for photodetection. Here, we demonstrate squeezed-light generation, routing, and balanced homodyne detection integrated on a single photonic chip through heterogeneous integration. A two-mode squeezed quantum microcomb comprising 34 quantum modes is measured with approximately 3 dB squeezing. Our work establishes a scalable architecture for fully integrated squeezed-light quantum photonic systems, unifying quantum-state generation, processing, and detection on a single chip.

quant-ph↗

arXiv2025

Universal loss and gain characterization inside photonic integrated circuits

Integrated photonics has undergone tremendous development in the past few decades, transforming many fields of study in science and technology. Loss and gain are two fundamental elements in photonic circuits and have direct impacts on nearly all key performance metrics. Surprisingly, the tools to characterize the optical loss and gain inside photonic integrated circuits (PICs) are very limited. This is because, unlike free-space or fiber optics, integrated circuits cannot be nondestructively disassembled. Here, we report a universal method to see inside the photonic integrated circuits and measure loss and gain on the component level nondestructively. The method leverages nonlinear optical devices as optical power discriminators to retrieve the loss and gain information inside the PICs. Our method has a precision better than 0.1 dB, and can characterize the loss of individual fiber-chip coupling facet and general unknown devices under test. As a demonstration of applications, we measured the true on-chip quantum efficiency of a quantum PIC consisting of heterogeneously integrated balanced photodiodes, a critical building block for integrated quantum technology. Our method can be implemented on different photonic platforms, and can be used to understand gain and loss in complex photonic circuits, which is essential to optimize circuit design and to create large-scale systems with predictable, reproducible performance.

physics.optics↗

arXiv2025

Photonic chip-based optical frequency division with PZT-integrated soliton microcombs

Optical frequency division (OFD) produces low-noise microwave and millimeter-wave signals by transferring the exceptional stability of optical references to electronic frequency domains. Recent developments in integrated optical references and soliton microcombs have paved the way for miniaturizing OFD oscillators to chip scale. Critical to this realization is a rapid tunable frequency comb that is stabilized to the optical references, thereby coherently linking optical and electronic frequencies. In this work, we advance the on-chip OFD technology using an integrated high-speed PZT stress-optic actuator on the SiN soliton microcomb resonator. The integrated PZT actuator tunes the resonance frequency of the soliton-generating microresonator with a bandwidth exceeding 10s MHz and independently adjusts the soliton repetition rate without perturbing the frequency comb offset. Optical frequency division and low-noise mmWave generation are demonstrated by feedback control of the soliton repetition rate through the integrated PZT-actuator, and the soliton microcomb is stabilized to a pair of reference lasers that are locked to an integrated 4-meter SiN coil reference cavity. Our approach provides a fast, versatile and integrated control mechanism for OFD oscillators and their applications in advanced communications, sensing, and precise timing.

physics.optics↗

arXiv2025

Integrated Architecture for the Automated Generation and Coil Stabilization of a PZT-Enabled Microcomb

Silicon nitride Dissipative Kerr Soliton (DKS) microcombs have emerged as a future solution to bring metrological optical frequency comb capabilities into a photonic integrated platform with mass-scale fabrication benefits. Precision applications demand low comb line phase noise as well as high repetition rate stability, but current approaches to achieve this involve complex architectures, multiple lasers, and high-power components, which are challenging to integrate to the chip scale. To achieve this goal, new architectures are needed to simplify the comb generation, actuation, and pump laser requirements, while enabling chip-integrated solutions. Here we demonstrate a greatly simplified stabilized DKS comb architecture with a single laser and a single point electronic control of both the microcomb generation and its stabilization to a coil-resonator reference. The silicon nitride microcomb is integrated with a low power, broadband PZT actuator that is driven by a simple electronic control sequence that generates a soliton and stabilizes it to the 16-meter silicon nitride coil resonator. PZT-enabled control brings flexibility and simplicity to the soliton generation and stabilization using a single CW pump laser, resulting in significantly reduced electronic and optical infrastructure. We demonstrate coil-resonator locking which suppresses the 1 kHz frequency noise by 40 dB over the 35 nm wide comb spectrum, with comb line linewidths as low as 66 Hz and 108 GHz soliton repetition rate phase noise equivalent to -118 dBc/Hz when divided down to 10 GHz. The low power PZT actuator consumes nW bias power and the coil resonator allows flexible dual locking using arbitrary comb lines. These results show a clear path towards full chip integration of stabilized soliton microcombs with simplicity and versatility absent in other schemes.

physics.optics↗

arXiv2024

Kerr optical frequency division with integrated photonics for stable microwave and mmWave generation

Optical frequency division (OFD) has revolutionized microwave and mmWave generation and set spectral purity records owing to its unique capability to transfer high fractional stability from optical to electronic frequencies. Recently, rapid developments in integrated optical reference cavities and microresonator-based optical frequency combs (microcombs) have created a path to transform OFD technology to chip scale. Here, we demonstrate an ultra-low phase noise mmWave oscillator by leveraging integrated photonic components and Kerr optical frequency division. The oscillator derives its stability from an integrated CMOS-compatible SiN coil cavity, and the optical frequency division is achieved spontaneously through Kerr interaction between the injected reference lasers and soliton microcombs in the integrated SiN microresonator. Besides achieving record-low phase noise for integrated mmWave oscillators, our demonstration greatly simplifies the implementation of integrated OFD oscillators and could be useful in applications of Radar, spectroscopy, and astronomy.

physics.optics↗

arXiv2023

Integrated optical frequency division for stable microwave and mmWave generation

The generation of ultra-low noise microwave and mmWave in miniaturized, chip-based platforms can transform communication, radar, and sensing systems. Optical frequency division that leverages optical references and optical frequency combs has emerged as a powerful technique to generate microwaves with superior spectral purity than any other approaches. We demonstrate a miniaturized optical frequency division system that can potentially transfer the approach to a CMOS-compatible integrated photonic platform. Phase stability is provided by a large-mode-volume, planar-waveguide-based optical reference coil cavity and is divided down from optical to mmWave frequency by using soliton microcombs generated in a waveguide-coupled microresonator. Besides achieving record-low phase noise for integrated photonic microwave/mmWave oscillators, these devices can be heterogeneously integrated with semiconductor lasers, amplifiers, and photodiodes, holding the potential of large-volume, low-cost manufacturing for fundamental and mass-market applications.

physics.optics↗

arXiv2021

A squeezed quantum microcomb on a chip

The optical microresonator-based frequency comb (microcomb) provides a versatile platform for nonlinear physics studies and has wide applications ranging from metrology to spectroscopy. Deterministic quantum regime is an unexplored aspect of microcombs, in which unconditional entanglements among hundreds of equidistant frequency modes can serve as critical ingredients to scalable universal quantum computing and quantum networking. Here, we demonstrate a deterministic quantum microcomb in a silica microresonator on a silicon chip. 40 continuous-variable quantum modes, in the form of 20 simultaneously two-mode squeezed comb pairs, are observed within 1 THz optical span at telecommunication wavelengths. A maximum raw squeezing of 1.6 dB is attained. A high-resolution spectroscopy measurement is developed to characterize the frequency equidistance of quantum microcombs. Our demonstration offers the possibility to leverage deterministically generated, frequency multiplexed quantum states and integrated photonics to open up new avenues in fields of spectroscopy, quantum metrology, and scalable quantum information processing.

physics.optics↗