arXiv subjects

Shumin Xiao

Publications and source records attributed to Shumin Xiao.

27 records · Page 2Linked to original sources

arXiv2015

The combination of directional outputs and single-mode operation in circular microdisk with broken PT symmetry

Monochromaticity and directionality are two key characteristics of lasers. However, the combination of directional emission and single-mode operation is quite challenging, especially for the on-chip devices. Here we propose a microdisk laser with single-mode operation and directional emissions by exploiting the recent developments associated with parity-time (PT) symmetry. This is accomplished by introducing one-dimensional periodic gain and loss into a circular microdisk, which induces a coupling between whispering gallery modes with different radial numbers. The lowest threshold mode is selected at the positions with least initial wavelength difference. And the directional emissions are formed by the introduction of additional grating vectors by the periodic distribution of gain and loss regions. We believe this research will impact the practical applications of on-chip microdisk lasers.

physics.optics↗

arXiv2015

Experimental demonstration of PT-symmetric stripe lasers

Recently, the coexistence of parity-time (PT) symmetric laser and absorber has gained tremendous research attention. While the PT symmetric absorber has been observed in microwave metamaterials, the experimental demonstration of PT symmetric laser is still absent. Here we experimentally study PT-symmetric laser absorber in stripe waveguide. Using the concept of PT symmetry to exploit the light amplification and absorption, PT-symmetric laser absorbers have been successfully obtained. Different from the single-mode PT symmetric lasers, the PT-symmetric stripe lasers have been experimentally confirmed by comparing the relative wavelength positions and mode spacing under different pumping conditions. When the waveguide is half pumped, the mode spacing is doubled and the lasing wavelengths shift to the center of every two initial lasing modes. All these observations are consistent with the theoretical predictions and confirm the PT-symmetry breaking well.

physics.optics↗

arXiv2015

End-fire injection of guided light into optical microcavity

Coupling light into microdisk plays a key role in a number of applications such as resonant filters and optical sensors. While several approaches have successfully coupled light into microdisk efficiently, most of them suffer from the ultrahigh sensitivity to the environmental vibration. Here we demonstrate a robust mechanism, which is termed as end-fire injection. By connecting an input waveguide to a circular microdisk directly, the mechanism shows that light can be efficiently coupled into optical microcavity. The coupling efficiency can be as high as 0.75 when the input signals are on resonances. Our numerical results reveal that the high coupling efficiency is attributed to the constructive interference between the whispering gallery modes and the input signals. We have also shown that the end-fire injection can be further extended to the long-lived resonances with low refractive index such as n = 1.45. We believe our results will shed light on the applications of optical microcavities.

physics.optics↗

arXiv2015

Inversed Vernier effect based single-mode laser emission in coupled microdisks

Recently, on-chip single-mode laser emission has attracted considerable research attention due to its wide applications. While most of single-mode lasers in coupled microdisks or microrings have been qualitatively explained by either Vernier effect or inversed Vernier effect, none of them have been experimentally confirmed. Here, we studied the mechanism for single-mode operation in coupled microdisks. We found that the mode numbers had been significantly reduced to nearly single-mode within a large pumping power range from threshold to gain saturation. The detail laser spectra showed that the largest gain and the first lasing peak were mainly generated by one disk and the laser intensity was proportional to the frequency detuning. The corresponding theoretical analysis showed that the experimental observations were dominated by internal coupling within one cavity, which was similar to the recently explored inversed Vernier effect in two coupled microrings. We believe our finding will be important for understanding the previous experimental findings and the development of on-chip single-mode laser.

physics.optics↗

arXiv2015

Quasi-guiding modes in microfibers on high refractive index substrate

Light confinement and amplification in micro- & nano-fiber have been intensively studied and a number of applications have been developed. However, the typical micro- & anno- fibers are usually free-standing or positioned on a substrate with lower refractive index to ensure the light confinement and guiding mode. Here we numerically and experimentally demonstrate the possibility of confining light within a microfiber on a high refractive index substrate. In contrast to the strong leaky to the substrate, we found that the radiation loss was dependent on the radius of microfiber and the refractive index contrast. Consequently, quasi-guiding modes could be formed and the light could propagate and be amplified in such systems. By fabricating tapered silica fiber and dye-doped polymer fiber and placing them on sapphire substrates, the light propagation, amplification, and laser behaviors have been experimentally studied to verify the quasi-guiding modes in microfer with higher index substrate. We believe that our research will be essential for the applications of micro- and nano-fibers.

physics.optics↗

arXiv2009

Frequency-domain simulations of a negative-index material with embedded gain

We solve the equations governing light propagation in a negative-index material with embedded nonlinearly saturable gain material using a frequency-domain model. We show that available gain materials can lead to complete loss compensation only if they are located in the regions where the field enhancement is maximal. We study the increased enhancement of the fields in the gain composite as well as in the metal inclusions and show analytically that the effective gain is determined by the average near-field enhancement.

physics.optics↗

arXiv2009

Tunable magnetic response of metamaterials

We demonstrate a thermally tunable optical metamaterial with negative permeability working in the visible range. By covering coupled metallic nanostrips with aligned nematic liquid crystals (NLCs), the magnetic response wavelength of the metamaterial is effectively tuned through control of the ambient temperature, changing the refractive index of LC via phase transitions. By increasing the ambient temperature from 20 degree to 50 degree, the magnetic response wavelength shifts from 650nm to 632nm. Numerical simulations confirm our tests and match the experimental observations well.

physics.optics↗

arXiv2009

Yellow-light Negative-index Metamaterials

A well-established, silver fishnet design has been further miniaturized to function as a negative-index material at the shortest wavelength to date. By studying the transmittance, reflectance, and corresponding numerical simulations of the sample, we report in this paper a negative refractive index of -0.25 at the yellow-light wavelength of 580 nm.

physics.optics↗

arXiv2006

Dual-Band Negative Index Metamaterial: Double-Negative at 813 nm and Single-Negative at 772 nm

This work is concerned with the experimental demonstration of a dual-band negative index metamaterial. The sample is double-negative (showing both a negative effective permeability and a negative effective permittivity) for wavelengths between 799 and 818 nm of linearly polarized light with a real part of refractive index of about -1.0 at 813 nm; the ratio -Re(n)/Im(n) is close to 1.3 at that wavelength. For an orthogonal polarization, the same sample also exhibits a negative refractive index in the visible (at 772 nm). The spectroscopic measurements of the material are in good agreement with the results obtained from a finite element electromagnetic solver for the actual geometry of the fabricated sample at both polarizations.

physics.optics↗