arXiv subjects

Simona Pace

Publications and source records attributed to Simona Pace.

5 recordsLinked to original sources

arXiv2021

Unexpected Electron Transport Suppression in a Heterostructures Graphene MoS2 Multiple Field-Effect Transistor Architecture

We demonstrate a graphene-MoS2 architecture integrating multiple field-effect transistors and we independently probe and correlate the conducting properties of van der Waals coupled graphene-MoS2 contacts with the ones of the MoS2 channels. Devices are fabricated starting from high-quality single-crystal monolayers grown by chemical vapor deposition and characterized by scanning Raman and photoluminescence spectroscopies. Transconductance curves of MoS2 are compared with the current-voltage characteristics of graphene contact stripes, revealing a significant suppression of transport on the n-side of the transconductance curve. Based on ab-initio modeling, the effect is understood in terms of trapping by sulfur vacancies, which counter-intuitively depends on the field-effect, even though the graphene contact layer is positioned between the backgate and the MoS2 channel.

cond-mat.mes-hall↗

arXiv2020

Thermal stability of monolayer $WS_2$ in BEOL conditions

Monolayer tungsten disulfide ($WS_2$) has recently attracted large interest as a promising material for advanced electronic and optoelectronic devices such as photodetectors, modulators, and sensors. Since these devices can be integrated in a silicon (Si) chip via back-end-of-line (BEOL) processes, the stability of monolayer $WS_2$ in BEOL fabrication conditions should be studied. In this work, the thermal stability of monolayer single-crystal $WS_2$ at typical BEOL conditions is investigated; namely (i) heating temperature of $300$ $^\circ C$, (ii) pressures in the medium- ($10^{-3}$ mbar) and high- ($10^{-8}$ mbar) vacuum range; (iii) heating times from $30$ minutes to $20$ hours. Structural, optical and chemical analyses of $WS_2$ are performed via scanning electron microscopy (SEM), Raman spectroscopy, photoluminescence (PL) and X-ray photoelectron spectroscopy (XPS). It is found that monolayer single-crystal $WS_2$ is intrinsically stable at these temperature and pressures, even after $20$ hours of thermal treatment. The thermal stability of $WS_2$ is also preserved after exposure to low-current electron beam ($12$ pA) or low-fluence laser ($0.9$ $mJ/\mu m^2$), while higher laser fluencies cause photo-activated degradation upon thermal treatment. These results are instrumental to define fabrication and in-line monitoring procedures that allow the integration of $WS_2$ in device fabrication flows without compromising the material quality.

cond-mat.mes-hall↗

arXiv2020

High-quality electrical transport using scalable CVD graphene

Producing and manipulating graphene on fab-compatible scale, while maintaining its remarkable carrier mobility, is key to finalize its technological application. We show that a large-scale approach (chemical vapor deposition on Cu followed by polymer-mediated semi-dry transfer) yields single-layer graphene crystals fully comparable, in terms of electronic transport, to micro-mechanically exfoliated flakes. hBN is used to encapsulate the graphene crystals $-$ without taking part to their detachment from the growth catalyst $-$ and study their intrinsic properties in field-effect devices. At room temperature, the electron-phonon coupling sets the mobility to $\sim1.3 \times10^5$ cm$^2$V$^{-1}$s$^{-1}$ at $\sim10^{11}$ cm$^{-2}$ concentration. At cryogenic temperatures, the mobility ($ > 6\times10^5$ cm$^2$V$^{-1}$s$^{-1}$ at $\sim10^{11}$ cm$^{-2}$) is limited by the devices' physical edges, and charge fluctuations $ < 7\times10^9$ cm$^{-2}$ are detected. Under perpendicular magnetic fields, we observe early onset of Landau quantization ($B\sim50$ mT) and signatures of electronic correlation, including the fractional quantum Hall effect.

cond-mat.mes-hall↗

arXiv2020

30$^\circ$-twisted bilayer graphene quasicrystals from chemical vapor deposition

The artificial stacking of atomically thin crystals suffers from intrinsic limitations in terms of control and reproducibility of the relative orientation of exfoliated flakes. This drawback is particularly severe when the properties of the system critically depend on the twist angle, as in the case of the dodecagonal quasicrystal formed by two graphene layers rotated by 30$^\circ$. Here we show that large-area 30$^\circ$-rotated bilayer graphene can be grown deterministically by chemical vapor deposition on Cu, eliminating the need of artificial assembly. The quasicrystals are easily transferred to arbitrary substrates and integrated in high-quality hBN-encapsulated heterostructures, which we process into dual-gated devices exhibiting carrier mobility up to $10^5$ cm$^2$/Vs. From low-temperature magnetotransport, we find that the graphene quasicrystals effectively behave as uncoupled graphene layers, showing 8-fold degenerate quantum Hall states: this result indicates that the Dirac cones replica detected by previous photo-emission experiments do not contribute to the electrical transport.

cond-mat.mes-hall↗

arXiv2019

Low-voltage 2D materials-based printed field-effect transistors for integrated digital and analog electronics on paper

Paper is the ideal substrate for the development of flexible and environmentally sustainable ubiquitous electronic systems, which, combined with two-dimensional materials, could be exploited in many Internet-of-Things applications, ranging from wearable electronics to smart packaging. Here we report high-performance MoS2 field-effect transistors on paper fabricated with a channel-array approach, combining the advantages of two large-area techniques: chemical vapor deposition and inkjet-printing.The first allows the pre-deposition of a pattern of MoS2; the second, the printing of dielectric layers, contacts, and connections to complete transistors and circuits fabrication. Average ION/IOFF of 8 x 10^3 (up to 5 x 10^4) and mobility of 5.5 cm2 V-1 s-1 (up to 26 cm2 V-1 s-1) are obtained. Fully functional integrated circuits of digital and analog building blocks, such as logic gates and current mirrors, are demonstrated, highlighting the potential of this approach for ubiquitous electronics on paper.

physics.app-ph↗