arXiv subjects

Soumik Aon

Publications and source records attributed to Soumik Aon.

8 recordsLinked to original sources

arXiv2026

Direct Electrical Detection of Spin Chemical Potential Due to Spin Hall Effect in $β$-Tungsten and Platinum Using a Pair of Ferromagnetic and Normal Metal Voltage Probes

The phenomenon of Spin Hall Effect (SHE) generates a pure spin current transverse to an applied current in materials with strong spin-orbit coupling, although not detectable through conventional electrical measurement. An intuitive Hall effect like measurement configuration is implemented to directly measure pure spin chemical potential of the accumulated spins at the edges of heavy metal (HM) channels that generates large SHE. A pair of transverse linearly aligned voltage probes in placed in ohmic contact with the top surface of HM , one being a ferromagnetic metal (FM) with non-zero spin polarization and other is the reference metal (RM) with zero polarization of carriers. This combination of FM/RM electrodes is shown to induce an additional voltage proportional to a spin accumulation potential, which is anti symmetric with respect to opposite orientations of FM controlled by a 2D vector magnet. Proof of concept of the measurement scheme is verified by comparing the signs of voltages for HM channels of Tungsten (W) and Platinum (Pt) which are known to generate opposite spin accumulation under similar conditions of applied current. The same devices are also able to detect the reciprocal effect, inverse spin Hall effect (ISHE) by swapping the current and voltage leads and the results are consistent with reciprocity principle. Further, exploiting a characteristic feature of W thin film deposition, a series of devices were fabricated with W resistivity varying over a wide range of 10 - 750 $μΩ$-cm and the calculated spin Hall resistivity exhibits a pronounced power law dependence on resistivity. Our measurement scheme combined with almost two decades of HM resistivity variation provides the ideal platform required to test the underlying microscopic mechanism responsible for SHE/ISHE.

cond-mat.mes-hall↗

arXiv2025

Decoupling of Spin-Orbit Torque Components in Py/W Bilayers unveiled through variation of W-resistivity

Harmonic Hall measurements were performed on a series of ferromagnetic metal/heavy metal (FM/HM) bilayers consisting of Permalloy (Py) as the FM and beta-Tungsten (W) as the HM, and the efficiencies of the two orthogonal components of the spin-orbit torque (SOT) were extracted. Two sets of Hall bar-shaped devices, differing in the aspect ratio of the voltage pickup line width and the current channel width, were studied. Within each set, the resistivity of the W layer was systematically varied over a wide range (approximately 150-1000 micro-Ohm-cm). To account for geometry-induced variations in current distribution, numerical simulations were performed, and a correction protocol was developed to normalize the torque efficiencies obtained from the conventional analysis. After applying the correction, the Slonczewski-like (anti-damping, in-plane) torque efficiency exhibited a consistent dependence on W resistivity across both device sets. In contrast, the field-like (out-of-plane) torque efficiency remained largely independent of W resistivity, reinforcing its interfacial character.

cond-mat.mes-hall↗

arXiv2025

Evidence of orbital Hall current induced correlation in second harmonic response of longitudinal and transverse voltage in light metal-ferromagnet bilayers

We investigate the effect of orbital current arising from orbital Hall effect in thin films of Nb and Ti in ohmic contact with ferromagnetic Ni in the second harmonic longitudinal and transverse voltages in response to an a.c. current applied to the bilayer structures. Our experiments were analogous to those on Heavy Metal-Ferromagnet bilayers and we extract the Orbital Hall Torque efficiency and unidirectional magnetoresistance (UMR). Through second-harmonic measurements, we investigate orbital Hall torque and UMR in bilayer devices composed of ferromagnetic materials (FM), such as Ni and NiFe, paired with light metals (LM), such as Ti and Nb. Our results demonstrate that LM/Ni bilayers exhibit enhanced damping-like torque and unidirectional magnetoresistance (UMR) compared to LM/NiFe bilayers. This enhancement suggests that angular momentum is generated via the orbital Hall effect within the light metal, where it undergoes orbital-to-spin conversion within the Ni ferromagnet, ultimately transferring to the magnetization of the ferromagnetic layer. Torque and UMR are also absent in single-layer devices, highlighting the necessity of the bilayer structure for orbital current generation.

cond-mat.mes-hall↗

arXiv2024

Anomalous Inverse Spin Hall Effect (AISHE) due to Unconventional Spin Currents in Ferromagnetic Films with Tailored Interfacial Magnetic Anisotropy

A single layer ferromagnetic film magnetized in the plane of an ac current flow, exhibits a characteristic Hall voltage with harmonic and second harmonic components, which is attributed to the presence of spin currents with polarization non-collinear with the magnetization. A set of 30 nm thick permalloy (Py) films used in this study are deposited at an oblique angle with respect to the substrate plane which induces an in-plane easy axis in the magnetization of the initial nucleating layers of the films which is distinct from the overall bulk magnetic properties of the film. This unusual magnetic texture provides a platform for the direct detection of inverse spin Hall effect in Hall bar shaped macroscopic devices at room temperatures which we denote as Anomalous Inverse Spin Hall Effect (AISHE). Control samples fabricated by normal deposition of permalloy with slow rotation of substrate shows significant reduction of the harmonic Hall signal that further substantiates the model. The analysis of the second harmonic Hall signal corroborates the presence of spin-orbit torque arising from the unconventional spin-currents in the single-layer ferromagnets.

cond-mat.mes-hall↗

arXiv2024

Anisotropic magneto-photothermal voltage in Sb2Te3 topological insulator thin films

We studied longitudinal and Hall photothermal voltages under a planar magnetic field scan in epitaxial thin films of the Topological Insulator (TI) Sb2Te3, grown using pulsed laser deposition (PLD). Unlike prior research that utilised polarised light-induced photocurrent to investigate the TI, our study introduces advancements based on unpolarized light-induced local heating. This method yields a thermoelectric response exhibiting a direct signature of strong spin-orbit coupling. Our analysis reveals three distinct contributions when fitting the photothermal voltage data to the angular dependence of the planar magnetic field. The interaction between the applied magnetic field and the thermal gradient on the bulk band orbitals enables the differentiation between the ordinary Nernst effect from the out-of-plane thermal gradient and an extraordinary magneto-thermal contribution from the planar thermal gradient. The fitting of our data to theoretical models indicates that these effects primarily arise from the bulk states of the TI rather than the surface states. These findings highlight PLD-grown epitaxial topological insulator thin films as promising candidates for optoelectronic devices, including sensors and actuators. Such devices offer controllable responses through position-dependent, non-invasive local heating via focused incident light and variations in the applied magnetic field direction.

cond-mat.mes-hall↗

arXiv2023

Experimental investigation of the effect of topological insulator on the magnetization dynamics of ferromagnetic metal: $BiSbTe_{1.5}Se_{1.5}$ and $Ni_{80}Fe_{20}$ heterostructure

We have studied ferromagnetic metal/topological insulator bilayer system to understand magnetization dynamics of ferromagnetic metal (FM) in contact with a topological insulator (TI). At magnetic resonance condition, the precessing magnetization in the metallic ferromagnet ($Ni_{80}Fe_{20}$) injects spin current into the topological insulator ($BiSbTe_{1.5}Se_{1.5}$), a phenomenon known as spin-pumping. Due to the spin pumping effect, fast relaxation in the ferromagnet results in the broadening of ferromagnetic resonance linewidth ($ΔH$). We evaluated the parameters like effective Gilbert damping coefficient ($α_{eff}$), spin-mixing conductance ($g_{eff}^{\uparrow \downarrow}$) and spin current density ($j_S^0$) to confirm a successful spin injection due to spin-pumping into the $BiSbTe_{1.5}Se_{1.5}$ layer. TIs embody a spin-momentum locked surface state that span the bulk band-gap. It can act differently to the FM magnetization than the other normal metals. To probe the effect of topological surface state, a systematic low temperature study is crucial as surface state of TI dominates at lower temperatures. The exponential growth of $ΔH$ for all different thickness combination of FM/TI bilayers and effective Gilbert damping coefficient ($α_{eff}$) with lowering temperature confirms the prediction that spin chemical bias generated from spin-pumping induces surface current in TI due to spin-momentum locking. The hump-like feature of magnetic anisotropy field ($H_K$)of the bilayer around 60K suggests that the decrease of interfacial in-plane magnetic anisotropy can result from exchange coupling between the TI surface state and the local moments of FM layer.

cond-mat.mes-hall↗

arXiv2023

Modulating Spin Current Induced Effective Damping in $β-W/Py$ Heterostructures by a Systematic Variation in Resistivity of the Sputtered Deposited $β-W$ films

Utilizing the spin-induced pumping from a ferromagnet (FM) into a heavy metal (HM) under the ferromagnetic resonance (FMR) condition, we report an enhancement in effective damping in $β$- W/Py bilayers by systematically varying resistivity ($ρ_{W}$) of $β$-W films. Different resistivity ranging from 100 $μΩ$-cm to 1400 $μΩ$-cm with a thickness of 8 nm can be achieved by varying the argon pressure ($P_{Ar}$) during the growth by the method of sputtering. The coefficient of effective damping $α_{eff}$ is observed to increase from 0.010 to 0.025 with $ρ_{W}$, which can be modulated by $P_{Ar}$. We observe a modest dependence of $α_{eff}$ on the sputtering power ($p_{S}$) while keeping the $P_{Ar}$ constant. $α_{eff}$ dependence on both $P_{Ar}$ and $p_{S}$ suggests that there exists a strong correlation between $α_{eff}$ and $ρ_{W}$. It is thus possible to utilize $ρ_{W}$ as a tuning parameter to regulate the $α_{eff}$, which can be advantageous for faster magnetization dynamics switching. The thickness dependence study of Py in the aforementioned bilayers manifests a higher spin mixing conductance ($g^{\uparrow\downarrow}_{eff}$) which suggests a strong spin pumping from Py into the $β$-W layer. The effective spin current ($J_{S(eff)}$) is also evaluated by considering the spin-back flow in this process. Intrinsic spin mixing conductance ($g^{\uparrow\downarrow}_{W}$) and spin diffusion length ($λ_{SD}$) of $β$-W are additionally investigated using thickness variations in $β$-W. Furthermore, the low-temperature study in $β$-W/Py reveals an intriguing temperature dependence in $α_{eff}$ which is quite different from $α_{b}$ of single Py layer and the enhancement in $α_{eff}$ at low temperature can be attributed to the spin-induced pumping from Py layer into $β$-W.

cond-mat.mes-hall↗

arXiv2022

A short-circuited coplanar waveguide for low-temperature single-port ferromagnetic resonance spectroscopy set-up to probe the magnetic properties of ferromagnetic thin films

A coplanar waveguide shorted in one end is proposed, designed, and implemented successfully to measure the properties of magnetic thin films as a part of the vector network analyzer ferromagnetic resonance (VNA-FMR) spectroscopy set-up. Its simple structure, potential applications and easy installation inside the cryostat chamber made it advantageous especially for low-temperature measurements. It provides a wide band of frequencies in the gigahertz range essential for FMR measurements. Our spectroscopy set-up with short-circuited coplanar waveguide has been used to extract Gilbert damping coefficient and effective magnetization values for standard ferromagnetic thin films like Py and Co. The thickness and temperature dependent studies of those magnetic parameters have also been done here for the afore mentioned magnetic samples.

cond-mat.mtrl-sci↗