arXiv subjects

Stefan Ast

Publications and source records attributed to Stefan Ast.

11 recordsLinked to original sources

arXiv2025

Demonstrating sub-picometer non-reciprocity levels in the Three-Backlink Experiment for LISA

The current planned space-based gravitational-wave detectors require a bidirectional optical connection, referred to as Backlink, between two adjacent optical benches to provide a mutual phase reference for the local interferometric measurements. However, if the Backlink shows asymmetry between the two propagation directions, the effective optical pathlengths of the counter-propagating beams can introduce a differential phase noise, called non-reciprocity, into the main interferometric measurement that will limit the achievable accuracy in time-delay interferometry (TDI) post-processing. Hence, it is important to understand the properties of the Backlink to ensure that it will not compromise the interferometric detection. The Three-Backlink Experiment (3BL), which consists of an optical test facility with two rotatable benches, was designed under the Laser Interferometer Space Antenna (LISA) framework to study the performance of three Backlink configurations: two fiber-based and one free-beam scheme. In this paper, we report recent experimental results from the 3BL. We describe the commissioning and the subsequent noise mitigation. We achieve a setup noise floor below $1\text{ pm}\sqrt{\text{Hz}}$ across most of the LISA measurement band, and provide an understanding of the current technical limitations. With this low-noise baseline, we measured the performance of the three Backlink implementations under non-rotational conditions. We show that all three Backlinks reach sub-picometer non-reciprocity levels across most of the frequency band, with the remaining part dominated by the mentioned testbed noise. This enabled us to conduct a preliminary study of the Backlink inherent noise, where we emphasized on the backscatter noise intrinsic to a straightforward fiber-based Backlink, as this is the current baseline for LISA.

physics.optics↗

arXiv2025

Construction techniques and commissioning of the Three-Backlink Experiment for the LISA mission

Designed to detect gravitational waves in the lower-frequency band, the space mission LISA will open a new window to astronomy after its launch in the 2030s. Each LISA spacecraft houses two optical benches that require the exchange of a phase reference between them via an optical connection, called a Backlink. Here we present the construction and commissioning of an ultra-stable quasi-monolithic optical testbed to investigate different Backlink implementations: a direct fiber, a frequency-separated fiber, and a free-beam link, compared in the Three-Backlink Experiment. Dedicated alignment techniques crucial for the construction of these optical benches are presented together with the development of a high-precision beam alignment and measurement tool - a Calibrated Quadrant Photodiode Singleton. An upper limit for the performance of all three investigated Backlink schemes, as determined by initial experiments, can be set at a $15\text{pm}/\sqrt{\text{Hz}}$-equivalent level within the LISA band, spanning 0.1mHz to 1Hz. Our measurements were able to verify the successful construction and commissioning of this very complex interferometer as an interferometric laboratory testbed for LISA. We find no limitations due to the construction on the here reported performance levels. Our results can support the construction of high-precision metrology testbeds for space-based laser interferometry for future gravitational wave or geodesy missions.

physics.optics↗

arXiv2019

Continuous-wave squeezed states of light via 'up-down' self-phase modulation

Continuous-wave (cw) squeezed states of light have applications in sensing, metrology and secure communication. In recent decades their efficient generation has been based on parametric down-conversion, which requires pumping by externally generated pump light of twice the optical frequency. Currently, there is immense effort in miniaturizing squeezed-light sources for chip-integration. Designs that require just a single input wavelength are favored since they offer an easier realization. Here we report the first observation of cw squeezed states generated by self-phase modulation caused by subsequent up and down conversions. The wavelengths of input light and of balanced homodyne detection are identical, and 1550 nm in our case. At sideband frequencies around 1.075 GHz, a nonclassical noise reduction of (2.4 +/- 0.1) dB is observed. The setup uses a second-order nonlinear crystal, but no externally generated light of twice the frequency. Our experiment is not miniaturized, but might open a route towards simplified chip-integrated realizations.

quant-ph↗

arXiv2019

Generation of very high-order high purity Gaussian modes via spatial light modulation

We experimentally demonstrate the conversion of a fundamental $\text{TEM}_{00}$ laser mode at 1064\,nm to higher order Hermite-Gaussian modes (HG) of arbitrary order via a commercially available liquid crystal Spatial Light Modulator (SLM). We particularly studied the $\text{HG}_{5,5}/\text{HG}_{10,10}/\text{HG}_{15,15}$ modes. A two-mirror plano-spherical cavity filters the higher-order modes spatially. We analyze the cleaned modes via a three-mirror diagnosis cavity and measure a mode purity of 96/93/78\% and a conversion efficiency of 6.6\%/3.7\%/1.7\% respectively. The generated high-purity Hermite-Gaussian modes can be employed for the mitigation of mirror thermal noise in optical cavities for both optical clocks and gravitational wave (GW) detectors. HG modes are then converted into high order LG modes which can be of particular interest in cold atom physics.

gr-qc↗

arXiv2018

Towards the LISA Backlink: Experiment design for comparing optical phase reference distribution systems

LISA is a proposed space-based laser interferometer detecting gravitational waves by measuring distances between free-floating test masses housed in three satellites in a triangular constellation with laser links in-between. Each satellite contains two optical benches that are articulated by moving optical subassemblies for compensating the breathing angle in the constellation. The phase reference distribution system, also known as backlink, forms an optical bi-directional path between the intra-satellite benches. In this work we discuss phase reference implementations with a target non-reciprocity of at most $2π\,\mathrm{μrad/\sqrt{Hz}}$, equivalent to $1\,\mathrm{pm/\sqrt{Hz}}$ for a wavelength of $1064\,\mathrm{nm}$ in the frequency band from $0.1\,\mathrm{mHz}$ to $1\,\mathrm{Hz}$. One phase reference uses a steered free beam connection, the other one a fiber together with additional laser frequencies. The noise characteristics of these implementations will be compared in a single interferometric set-up with a previously successfully tested direct fiber connection. We show the design of this interferometer created by optical simulations including ghost beam analysis, component alignment and noise estimation. First experimental results of a free beam laser link between two optical set-ups that are co-rotating by $\pm 1^\circ$ are presented. This experiment demonstrates sufficient thermal stability during rotation of less than $10^{-4}\,\mathrm{K/\sqrt{Hz}}$ at $1\,\mathrm{mHz}$ and operation of the free beam steering mirror control over more than 1 week.

physics.ins-det↗

arXiv2017

Beating the standard sensitivity-bandwidth limit of cavity-enhanced interferometers with internal squeezed-light generation

The shot-noise limited peak sensitivity of cavity-enhanced interferometric measurement devices, such as gravitational-wave detectors, can be improved by increasing the cavity finesse, even when comparing fixed intra-cavity light powers. For a fixed light power inside the detector, this comes at the price of a proportional reduction in the detection bandwidth. High sensitivity over a large span of signal frequencies, however, is essential for astronomical observations. It is possible to overcome this standard sensitivity-bandwidth limit using non-classical correlations in the light field. Here, we investigate the internal squeezing approach, where the parametric amplification process creates a non-classical correlation directly inside the interferometer cavity. We analyse the limits of the approach theoretically, and measure 36% increase in the sensitivity-bandwidth product compared to the classical case. To our knowledge this is the first experimental demonstration of an improvement in the sensitivity-bandwidth product using internal squeezing, opening the way for a new class of optomechanical force sensing devices.

quant-ph↗

arXiv2016

Gaussian entanglement distribution with gigahertz bandwidth

The distribution of entanglement with Gaussian statistic can be used to generate a mathematically-proven secure key for quantum cryptography. The distributed secret key rate is limited by the {entanglement strength, the entanglement bandwidth and the bandwidth of the photo-electric detectors}. The development of a source for strongly, bi-partite entangled light with high bandwidth promises an increased measurement speed and a linear boost in the secure data rate. Here, we present the experimental realization of a Gaussian entanglement source with a bandwidth of more than 1.25\,GHz. The entanglement spectrum was measured with balanced homodyne detectors and was quantified via the inseparability criterion introduced by Duan and coworkers with a critical value of 4 below which entanglement is certified. Our measurements yielded an inseparability value of about 1.8 at a frequency of 300\,MHz to about 2.8 at 1.2\,GHz extending further to about 3.1 at 1.48\,GHz. In the experiment we used two 2.6\,mm long monolithic periodically poled potassium titanyl phosphate (PPKTP) resonators to generate two squeezed fields at the telecommunication wavelength of 1550\,nm. Our result proves the possibility of generating and detecting strong continuous-variable entanglement with high speed.

quant-ph↗

arXiv2013

High-bandwidth squeezed light at 1550 nm from a compact monolithic PPKTP cavity

We report the generation of squeezed vacuum states of light at 1550 nm with a broadband quantum noise reduction of up to 4.8 dB ranging from 5 MHz to 1.2 GHz sideband frequency. We used a custom-designed 2.6 mm long biconvex periodically-poled potassium titanyl phosphate (PPKTP) crystal. It featured reflectively coated end surfaces, 2.26 GHz of linewidth and generated the squeezing via optical parametric amplification. Two homodyne detectors with different quantum efficiencies and bandwidths were used to characterize the non-classical noise suppression. We measured squeezing values of up to 4.8 dB from 5 to 100 MHz and up to 3 dB from 100 MHz to 1.2 GHz. The squeezed vacuum measurements were limited by detection loss. We propose an improved detection scheme to measure up to 10 dB squeezing over 1 GHz. Our results of GHz bandwidth squeezed light generation provide new prospects for high-speed quantum key distribution.

quant-ph↗

arXiv2012

Continuous-wave non-classical light with GHz squeezing bandwidth

Squeezed states can be employed for entanglement-based continuous-variable quantum key distribution, where the secure key rate is proportional to the bandwidth of the squeezing. We produced a non-classical continuous-wave laser field at the telecommunication wavelength of 1550 nm, which showed squeezing over a bandwidth of more than 2 GHz. The experimental setup used parametric down-conversion via a periodically poled potassium titanyl phosphate crystal (PPKTP). We did not use any resonant enhancement for the funda- mental wavelength, which should in principle allow a production of squeezed light over the full phase-matching bandwidth of several nanometers. We measured the squeezing to be up to 0.3 dB below the vacuum noise from 50 MHz to 2 GHz limited by the measuring bandwidth of the homodyne detector. The squeezing strength was possibly limited by thermal lensing inside the non-linear crystal.

quant-ph↗

arXiv2011

Squeezed light at 1550 nm with a quantum noise reduction of 12.3 dB

Continuous-wave squeezed states of light at the wavelength of 1550 nm have recently been demonstrated, but so far the obtained factors of noise suppression still lag behind today's best squeezing values demonstrated at 1064 nm. Here we report on the realization of a half-monolithic nonlinear resonator based on periodically-poled potassium titanyl phosphate which enabled the direct detection of up to 12.3 dB of squeezing at 5 MHz. Squeezing was observed down to a frequency of 2 kHz which is well within the detection band of gravitational wave interferometers. Our results suggest that a long-term stable 1550 nm squeezed light source can be realized with strong squeezing covering the entire detection band of a 3rd generation gravitational-wave detector such as the Einstein Telescope.

quant-ph↗

arXiv2011

High-efficiency frequency doubling of continuous-wave laser light

We report on the observation of high efficiency frequency doubling of 1550 nm continuous-wave laser light in a nonlinear cavity containing a periodically poled potassium titanyl phosphate crystal (PPKTP). The fundamental field had a power of 1.10 W and was converted into 1.05 W at 775 nm, yielding a total external conversion efficiency of (95 \pm 1)%. The latter value is based on the measured depletion of the fundamental field being consistent with the absolute values derived from numerical simulations. According to our model, the conversion efficiency achieved was limited by the non-perfect mode-matching into the nonlinear cavity and the pump power available. Our result shows that cavity-assisted frequency conversion based on PPKTP is well suited for low-decoherence frequency conversion of quantum states of light.

quant-ph↗