arXiv subjects

Stefan U. Egelhaaf

Publications and source records attributed to Stefan U. Egelhaaf.

25 records · Page 2Linked to original sources

arXiv2012

Tension and stiffness of the hard sphere crystal-fluid interface

A combination of fundamental measure density functional theory and Monte Carlo computer simulation is used to determine the orientation-resolved interfacial tension and stiffness for the equilibrium hard-sphere crystal-fluid interface. Microscopic density functional theory is in quantitative agreement with simulations and predicts a tension of 0.66 kT/σ^2 with a small anisotropy of about 0.025 kT and stiffnesses with e.g. 0.53 kT/σ^2 for the (001) orientation and 1.03 kT/σ^2 for the (111) orientation. Here kT is denoting the thermal energy and σthe hard sphere diameter. We compare our results with existing experimental findings.

cond-mat.soft↗

arXiv2011

Effect of glycerol and dimethyl sulfoxide on the phase behavior of lysozyme: Theory and experiments

Salt, glycerol and dimethyl sulfoxide (DMSO) are used to modify the properties of protein solutions. We experimentally determined the effect of these additives on the phase behavior of lysozyme solutions. Upon the addition of glycerol and DMSO, the fluid-solid transition and the gas-liquid coexistence curve (binodal) shift to lower temperatures and the gap between them increases. The experimentally observed trends are consistent with our theoretical predictions based on the thermodynamic perturbation theory (TPT) and the Derjaguin-Landau-Verwey-Overbeek (DLVO) model for the lysozyme-lysozyme pair interactions. The values of the parameters describing the interactions, namely the refractive indices, dielectric constants, Hamaker constant and cut-off length, are extracted from literature or are experimentally determined by independent experiments, including static light scattering to determine the second virial coefficient. We observe that both, glycerol and DMSO, render the potential more repulsive, while sodium chloride reduces the repulsion.

cond-mat.soft↗

arXiv2010

Finding bridges in packings of colloidal spheres

We identify putative load-bearing structures (bridges) in experimental colloidal systems studied by confocal microscopy. Bridges are co-operative structures that have been used to explain stability and inhomogeneous force transmission in simulated granular packings with a range of densities. We show that bridges similar to those found in granular simulations are present in real experimental colloidal packings. We describe critically the bridge-finding procedure for real experimental data and propose a new criterion-Lowest Mean Squared Separation (LSQS)-for selecting optimum stabilisations.

cond-mat.soft↗

arXiv2009

Combined holographic-mechanical optical tweezers: Construction, optimisation and calibration

A spatial light modulator (SLM) and a pair of galvanometer-mounted mirrors (GMM) were combined into an optical tweezers set-up. This provides great flexibility as the SLM creates an array of traps which can be moved smoothly and quickly with the GMM. To optimise performance, the effect of the incidence angle on the SLM with respect to phase and intensity response was investigated. Although it is common to use the SLM at an incidence angle of 45 degrees, smaller angles give a full 2pi phase shift and an output intensity which is less dependent on the magnitude of the phase shift. The traps were calibrated using an active oscillatory technique and a passive probability distribution method.

physics.optics↗

arXiv2008

Colloidal suspensions in modulated light fields

Periodically-modulated potentials in the form of light fields have previously been applied to induce reversible phase transitions in dilute colloidal systems with long-range interactions. Here we investigate whether similar transitions can be induced in very dense systems, where inter-particle contacts are important. Using microscopy we show that particles in such systems are indeed strongly affected by modulated potentials. We discuss technical aspects relevant to generating the light-induced potentials and to imaging simultaneously the particles. We also consider what happens when the particle size is comparable with the modulation wavelength. The effects of selected modulation wavelengths as well as pure radiation pressure are illustrated.

cond-mat.soft↗

arXiv2008

Swelling and shrinking kinetics of a lamellar gel phase

We investigate the swelling and shrinking of L_beta lamellar gel phases composed of surfactant and fatty alcohol after contact with aqueous poly(ethylene-glycol) solutions. The height change $Δh(t)$ is diffusion-like with a swelling coefficient, S: $Δh = S \sqrt{t}$. On increasing polymer concentration we observe sequentially slower swelling, absence of swelling, and finally shrinking of the lamellar phase. This behavior is summarized in a non-equilibrium diagram and the composition dependence of S quantitatively described by a generic model. We find a diffusion coefficient, the only free parameter, consistent with previous measurements.

cond-mat.soft↗

arXiv2007

Confocal microscopy of colloidal particles: towards reliable, optimum coordinates

Over the last decade, the light microscope has become increasingly useful as a quantitative tool for studying colloidal systems. The ability to obtain particle coordinates in bulk samples from micrographs is particularly appealing. In this paper we review and extend methods for optimal image formation of colloidal samples, which is vital for particle coordinates of the highest accuracy, and for extracting the most reliable coordinates from these images. We discuss in depth the accuracy of the coordinates, which is sensitive to the details of the colloidal system and the imaging system. Moreover, this accuracy can vary between particles, particularly in dense systems. We introduce a previously unreported error estimate and use it to develop an iterative method for finding particle coordinates. This individual-particle accuracy assessment also allows comparison between particle locations obtained from different experiments. Though aimed primarily at confocal microscopy studies of colloidal systems, the methods outlined here should transfer readily to many other feature extraction problems, especially where features may overlap one another.

cond-mat.soft↗