arXiv subjects

Stefania Vecchi

Publications and source records attributed to Stefania Vecchi.

3 recordsLinked to original sources

arXiv2026

Analytical model for the photomultiplier single photoelectron response including the electron back-scattering contribution

Many models exist to describe the single photoelectron response of single photon counting photomultipliers. Generally to describe the spectral region between the fully amplified primary photoelectron peak and the electronics pedestal an ad hoc function is used (often an exponentially modified gaussian) attributing this region to `noise'. In this paper, following the physical description of back-scattered primary photoelectrons at the first dynode described in the "The Photomultiplier Handbook" by A. G. Wright published by Oxford University Press, we derive an analytical function describing these partially amplified primary photoelectron at the first dynode. This function depends only on intrinsic parameters of the photomultiplier such as the gain at the first dynode and the intrinsic resolution of the dynode chain following the first. Furthermore, analytical descriptions of the fully amplified peak and very low charge signals are derived. The model has been successfully validated with data from two different photomultipliers acquired with a low-noise amplifier.

physics.ins-det↗

arXiv2021

Accurate modelling of 3D-trench silicon sensor with enhanced timing performance and comparison with test beam measurements

This paper presents the detailed simulation of a double-pixel structure for charged particle detection based on the 3D-trench silicon sensor developed for the TIMESPOT project and a comparison of the simulation results with measurements performed at $π-$M1 beam at PSI laboratory. The simulation is based on the combined use of several software tools (TCAD, GEANT4, TCoDe and TFBoost) which allow to fully design and simulate the device physics response in very short computational time, O(1-100 s) per simulated signal, by exploiting parallel computation using single or multi-thread processors. This allowed to produce large samples of simulated signals, perform detailed studies of the sensor characteristics and make precise comparisons with experimental results.

physics.ins-det↗

arXiv2020

Intrinsic time resolution of 3D-trench silicon pixels for charged particle detection

In the last years, high-resolution time tagging has emerged as the tool to tackle the problem of high-track density in the detectors of the next generation of experiments at particle colliders. Time resolutions below 50ps and event average repetition rates of tens of MHz on sensor pixels having a pitch of 50$μ$m are typical minimum requirements. This poses an important scientific and technological challenge on the development of particle sensors and processing electronics. The TIMESPOT initiative (which stands for TIME and SPace real-time Operating Tracker) aims at the development of a full prototype detection system suitable for the particle trackers of the next-to-come particle physics experiments. This paper describes the results obtained on the first batch of TIMESPOT silicon sensors, based on a novel 3D MEMS (micro electro-mechanical systems) design. Following this approach, the performance of other ongoing silicon sensor developments has been matched and overcome, while using a technology which is known to be robust against radiation degradation. A time resolution of the order of 20ps has been measured at room temperature suggesting also possible improvements after further optimisations of the front-end electronics processing stage.

physics.ins-det↗