SearcharxivSearch

arXiv subjects

Subhojit Dutta

Publications and source records attributed to Subhojit Dutta.

7 recordsLinked to original sources

Cavity-enhanced narrowband spectral filters using rare-earth ions doped in thin-film lithium niobate

On-chip optical filters are fundamental components in optical signal processing. While rare-earth ion-doped crystals offer ultra-narrow optical filtering via spectral hole burning, their applications have primarily been limited to those using bulk crystals, restricting their utility. In this work, we demonstrate cavity-enhanced spectral filtering based on rare-earth ions in an integrated nonlinear optical platform. We incorporate rare-earth ions into high quality-factor ring resonators patterned in thin-film lithium niobate. By spectral hole burning at 4K in a critically coupled resonance mode, we achieve bandpass filters ranging from 7 MHz linewidth, with 13.0 dB of extinction, to 24 MHz linewidth, with 20.4 dB of extinction. By reducing the temperature to 100 mK to eliminate phonon broadening, we achieve an even narrower linewidth of 681 kHz, which is comparable to the narrowest filter linewidth demonstrated in an integrated photonic device, while only requiring a small device footprint. Moreover, the cavity enables reconfigurable filtering by varying the cavity coupling rate. For instance, as opposed to the bandpass filter, we demonstrate a bandstop filter utilizing an under-coupled ring resonator. Such versatile integrated spectral filters with high extinction ratio and narrow linewidth could serve as fundamental components for optical signal processing and optical memories on-a-chip.

physics.optics

An atomic frequency comb memory in rare-earth doped thin-film lithium niobate

Atomic frequency combs memories that coherently store optical signals are a key building block for optical quantum computers and quantum networks. Integrating such memories into compact and chip-scale devices is essential for scalable quantum technology, but to date most demonstrations have been in bulk materials or waveguides with large cross-sections, or using fabrication techniques not easily adaptable to wafer scale processing. We demonstrate compact chip-integrated atomic frequency comb storage in rare earth doped thin-film lithium niobate. Our optical memory exhibits a broad storage bandwidth exceeding 100 MHz, and optical storage time of over 250 ns. The enhanced optical confinement in this device structure enables three orders of magnitude reduction in optical power as compared to large ion-diffused waveguides for the same Rabi frequency. These compact atomic frequency comb memories pave the way towards scalable, highly efficient, electro-optically tunable quantum photonic systems that can store and manipulate light on a compact chip.

quant-ph

An Integrated Photonic Platform for Rare-Earth Ions in Thin Film Lithium Niobate

Rare-earth ion ensembles doped in single crystals are a promising materials system with widespread applications in optical signal processing, lasing, and quantum information processing. Incorporating rare-earth ions into integrated photonic devices could enable compact lasers and modulators, as well as on-chip optical quantum memories for classical and quantum optical applications. To this end, a thin film single crystalline wafer structure that is compatible with planar fabrication of integrated photonic devices would be highly desirable. However, incorporating rare-earth ions into a thin film form-factor while preserving their optical properties has proven challenging. We demonstrate an integrated photonic platform for rare-earth ions doped in a single crystalline thin film on insulator. The thin film is composed of lithium niobate doped with Tm3+. The ions in the thin film exhibit optical lifetimes identical to those measured in bulk crystals. We show narrow spectral holes in a thin film waveguide that require up to 2 orders of magnitude lower power to generate than previously reported bulk waveguides. Our results pave way for scalable on-chip lasers, optical signal processing devices, and integrated optical quantum memories.

physics.optics

Coupling Quantum Emitters in WSe2 Monolayers to a Metal-Insulator-Metal Waveguide

Coupling single photon emitters to surface plasmons provides a versatile ground for on chip quantum photonics. However, achieving good coupling efficiency requires precise alignment of both the position and dipole orientation of the emitter relative to the plasmonic mode. We demonstrate coupling of single emitters in the 2-D semiconductor, WSe2 self-aligned with propagating surface plasmon polaritons in silver-air-silver, metal-insulator-metal waveguides. The waveguide produces strain induced defects in the monolayer which are close to the surface plasmon mode with favorable dipole orientations for optimal coupling. We measure an average enhancement in the rate of spontaneous emission by a factor of 1.89 for coupling the single defects to the plasmonic waveguide. This architecture provides an efficient way of coupling single photon emitters to propagating plasmons which is an important step towards realizing active plasmonic circuits on chip.

physics.app-ph

Radiative enhancement of single quantum emitters in WSe2 monolayers using site-controlled metallic nano-pillars

Plasmonic nano-structures provides an efficient way to control and enhance the radiative properties of quantum emitters. Coupling these structures to single defects in low-dimensional materials provides a particularly promising material platform to study emitter-plasmon interactions because these emitters are not embedded in a surrounding dielectric. They can therefore approach a near-field plasmonic mode to nanoscale distances, potentially enabling strong light-matter interactions. However, this coupling requires precise alignment of the emitters to the plasmonic mode of the structures, which is particularly difficult to achieve in a site-controlled structure. We present a technique to generate quantum emitters in 2D tungsten diselenide (WSe2) coupled to site-controlled plasmonic nano-pillars. The plasmonic nano-pillars induce strain in the two dimensional material which generates quantum emitters near the high-field region of the plasmonic mode. The electric field of the nano-pillar mode lies close to parallel with the two-dimensional material, and is therefore in the correct orientation to couple to quantum emitters. Interactions between the emitter and plasmonic mode result in an enhanced spontaneous emission and increased brightness. This approach may enable bright site-controlled non-classical light sources for applications in quantum communication and optical quantum computing.

cond-mat.mes-hall

Coupling emission from single localized defects in 2D semiconductor to surface plasmon polaritons

Coupling of an atom-like emitter to surface plasmons provides a path toward significant optical nonlinearity, which is essential in quantum information processing and quantum networks. A large coupling strength requires nanometer-scale positioning accuracy of the emitter near the surface of the plasmonic structure, which is challenging. We demonstrate the coupling of single localized defects in a tungsten diselenide (WSe2) monolayer self-aligned to the surface plasmon mode of a silver nanowire. The silver nanowire induces a strain gradient on the monolayer at the overlapping area, leading to the formation of localized defect emission sites that are intrinsically close to the surface plasmon. We measure a coupling efficiency with a lower bound of 39% from the emitter into the plasmonic mode of the silver nanowire. This technique offers a way to achieve efficient coupling between plasmonic structures and localized defects of 2D semiconductors.

cond-mat.mes-hall

High-frequency, scaled MoS2 transistors

The interest in MoS2 for radio-frequency (RF) application has recently increased. However, little is known on the scaling behavior of transistors made from MoS2 for RF applications, which is important for establishing performance limits for electronic circuits based on 2D semiconductors on flexible and rigid substrates. Here, we present a systematic study of top-gated trilayer MoS2 RF transistors with gate lengths scaled down to 70 and 40 nm. In addition, by introducing edge-contacted injection of electrons in trilayer MoS2 devices, we decrease the contact resistance and as a result obtain the highest cutoff frequency of 6 GHz before the de-embedding procedure and 25 GHz after the de-embedding procedure.

cond-mat.mes-hall