arXiv subjects

Sze Yun Set

Publications and source records attributed to Sze Yun Set.

16 recordsLinked to original sources

arXiv2026

Beat-spectrum design for 100-km-range optical correlation-domain reflectometry with localized 15-cm resolution

Conventional optical correlation-domain reflectometry (OCDR) based on sinusoidal frequency modulation exhibits a coupling between measurement range and spatial resolution because both are governed by the modulation frequency. Here, we formulate OCDR for arbitrary periodic frequency modulation and relate the modulation waveform to the resulting beat spectrum. By expressing the instantaneous optical frequency as a Fourier series, the beat spectrum is written as successive convolutions of the spectral contributions from the harmonic components. This formulation relates the harmonic composition of the modulation waveform to the spatial response. Periodic pseudo-random modulation (PPRM) was used to test this relation experimentally. We first measured the full-length reflectivity distribution along an approximately 100-km fiber using sinusoidal modulation and then performed PPRM-based random access interrogation near the fiber end. In the local measurement, two closely spaced reflection points were resolved with a correlation-peak width of approximately 15 cm. These results show that beat-spectrum design can reduce the range-resolution coupling of conventional sinusoidal-modulation OCDR and combine long-range surveying with localized high-resolution interrogation.

physics.optics↗

arXiv2025

High-Spatial-Resolution Optical Correlation-Domain Reflectometry with 100-km Measurement Range

In the maintenance of optical fiber networks, there is a growing demand for high-precision measurement of optical loss distribution and fault locations over long distances. In this study, we propose an OCDR method incorporating periodic pseudo-random modulation (PPRM), and demonstrate that it enables the acquisition of loss distribution based on Rayleigh scattering and the positions of reflection points in an approximately 100-km optical fiber, with a spatial resolution of about 19 cm and a measurement time of about 20 seconds.

physics.optics↗

arXiv2025

Repetition-Rate-Difference Tunable Dual-Comb Fiber Laser Using Bidirectional Lyot filtering

Single cavity dual-comb fiber lasers adopting different multiplexing configurations are benefited from the natures of common-mode noise suppression and superior coherence. Particularly, repetition-rate tunable dual-combs enable non-ambiguous ranging and aliasing-free spectroscopy. However, their sampling rate and spectral resolution is severely restricted by the mechanical delay lines. In a previous work, as rapid as 500 kHz/s tuning rate was realized to address this issue, while the minimum comb frequency difference remained large under the inaccuracy of mechanical DLL. In this work, a dual-comb prototype incorporated with a thermally controlled bidirectional lyot filter is demonstrated with 870-times enhanced tuning precision compared with mechanical schemes. Linear correlation between temperature and repetition-rate-difference of this tuning mechanism is revealed. We achieve a tuning efficiency of 4.4 Hz/°C and a control accuracy of 0.44 Hz/K, denoting a significant advance in operating Hz-scale differential comb lines. This design offers an optimal playground for extending non-ambiguous distance in dead-zone-free dual-comb ranging and eliminating aliasing in spectroscopy.

physics.optics↗

arXiv2025

GHz fundamental mode-locking of a highly integrated Er-doped all-fiber ring laser

High repetition rate ultrafast fiber lasers are important tools for both fundamental science and industry applications. However, achieving over GHz repetition rate in passively mode-locked fiber ring lasers is still challenging. Here, we demonstrate the first ring-cavity Er-doped fiber laser that achieves over GHz fundamental repetition rate by using an all-integration cavity design. In the proposed laser oscillator, all functions are integrated into one device, making it an ultra-compact laser cavity. The laser is mode-locked by carbon nanotubes (CNTs) film that is directly deposited on the pigtail active fiber connectors. The laser produces ultrafast optical pulses at 1562 nm, with a pulse width of 682 fs and a fundamental repetition rate of 1.028 GHz with improved performance. Stable and low-noise mode-locking is characterized by high signal-to-noise ratio (SNR) radiofrequency signal and low relative intensity noise (RIN). The proposed all-integration laser design may serve as a reference for compact fiber ring lasers using other mode-locking mechanisms or at diverse wavelengths.

physics.optics↗

arXiv2024

Design of Fiber-Longitudinal Optical Power Monitor

This paper presents analytical results on the accuracy of fiber-longitudinal optical power monitoring (LPM) at arbitrary positions. To quantify the accuracy, the position-wise variance and power-profile SNR of LPM are defined and analyzed, yielding formulas for these metrics. Using these metrics, we show that various designs and performance predictions of LPM for a given link and estimation conditions are possible in a unified manner. Specifically, the required SNR to detect a given loss event is first presented. Based on this relation, the design parameters of LPM, such as the sample size and optical power required to detect the loss, are explicitly determined. The performance such as the detectable limit of loss events at individual positions and maximum dynamic range are also specified. These results can be used as a basis for establishing a design principle of LPM.

eess.SP↗

arXiv2024

783-MHz fundamental repetition rate all-fiber ring laser mode-locked by carbon nanotubes

We demonstrate a 783-MHz fundamental repetition rate mode-locked Er-doped all-fiber ring laser with a pulse width of 623 fs. By using carbon nanotubes (CNT) saturable absorber (SA), a relatively low self-starting pump threshold of 108 mW is achieved. The laser has a very compact footprint less than 10 cm * 10 cm, benefiting from the all-active-fiber cavity design. The robust mode-locking is confirmed by the low relative intensity noise (RIN) and a long-term stability test. We propose a new scheme for generating high repetition rate femtosecond optical pulses from a compact and stable all-active-fiber ring oscillator.

physics.optics↗

arXiv2024

Mode-Locked Fiber Laser with up to 19 kHz Wavelength Sweep Rate via External Pump LD Modulation

For the first time, we introduce a rapid wavelength-swept, passively mode-locked fiber laser in an all-polarization-maintaining and all-fiber configuration. Achieving an exceptional wavelength sweep rate of up to 19 kHz through external modulation of the LD driver pump current, this laser offers a high sweep rate, simple cavity design, cost-effectiveness, and excellent repeatability.

physics.optics↗

arXiv2024

Rapid-scanned and self-corrected repetition rates enabled in a bidirectional polarization-multiplexed fiber laser

Repetition-rate-scanned lasers are practical in accordion frequency comb generation that serves as a variable gearbox connecting optical and radio wave domains. Rapid and wide-range scanned repetition rate can benefit versatile purposes, however scanning robustness remains unsecured that typically requires complicated feedback loops. Recently, multiplexed lasers have been demonstrated with the nature of common-noise rejection among simultaneously emitted combs. Here, we propose a bidirectional polarization-multiplexed fiber laser that delivers synchronized pulses with rapid-scanned and reference-free repetition rates. Benefiting from the all polarization-maintaining fiber configuration, the laser shows good robustness and inter-comb coherence. As rapid as 493.5 kHz/s scanning rate over 329-kHz scanning range of fundamental repetition rate is realized. The 1-hour and 1-day maximal variations of difference frequency are merely 0.52 Hz and 5.46 Hz. The capability to rebuilt steady state after mode hopping is also demonstrated. These results provide a promising solution for developing high-performance accordion-frequency laser sources.

physics.optics↗

arXiv2024

Pump-power-controlled L-band wavelength-tunable mode-locked fiber laser utilizing all polarization maintaining nonlinear polarization rotation

For the first time, we present the pump power-controlled wavelength-tunable mode-locked fiber laser in the L-band (1565 nm to 1625 nm), achieved by all-polarization maintaining (all-PM) nonlinear polarization rotation (NPR). The wavelength of the laser can be tuned over 20 nm, from 1568.2 nm to 1588.9 nm simply by controlling the pump power from 45 mW to 115 mW. In contrast to conventional wavelength tuning mechanisms such as optical bandpass filters, our tuning method is non-mechanical and electrically controllable, featuring simplicity and cost-effectiveness in a superior all-fiber design.

physics.optics↗

arXiv2021

Design of a passively mode-locking whispering gallery mode microaser

Ultrahigh repetition rate lasers will become vital light sources for many future technologies; however, their realization is challenging because the cavity size must be minimized. Whispering-gallery-mode (WGM) microresonators are attractive for this purpose since they allow the strong light-matter interaction usually needed to enable mode-locking. However, the optimum parameter ranges are entirely unknown since no experiments have yet been conducted. Here, we numerically investigate pulsed operation in a toroidal WGM microresonator with gain and saturable absorption (SA) to study the experimental feasibility. We show that dispersion is the key parameter for achieving passive mode-locking in this system. Moreover, the design guideline provided in this work can apply to any small resonators with gain and SA and is not limited to a specific cavity system.

physics.optics↗

arXiv2020

SWCNT@BNNT with 1D van der Waals Heterostructure with a High Optical Damage Threshold for Laser Mode-locking

Single-walled carbon nanotube encapsulated in boron nitrite nanotube (SWCNT@BNNT) is a novel nanomaterial with a one-dimensional van der Waals (1D-vdW) heterostructure. In this paper, we demonstrated that the SWCNT@BNNT has an enhanced optical power tolerance compared to that of the pristine SWCNT while exhibiting an optical saturable absorption properties. Under optical power intensity of 13kW/cm2, the lifetime of the SWCNT@BNNT is found to be 2,270 times longer than SWCNT for 1% degradation in absorbance. A short-cavity mode-locked laser with a high repetition rate of 1 GHz has been realized using the SWCNT@BNNT as the saturable absorber. We have shown that the technique of fabricating nanomaterial with a 1D-vdW heterostructure can modify and enhance the optical properties of the encapsulated nanomaterials.

physics.optics↗

arXiv2019

Short length Lyot filter utilized in dual-wavelength and wavelength tunable mode-locked fiber laser generation

Dual-wavelength mode-locked fiber laser and wavelength tunable mode-locked fiber laser have emerged as a promising light source. However, there is few reports on generating these two output from just one laser cavity. In this report, we demonstrate a dual-wavelength and wavelength tunable mode-locked fiber laser output from one laser cavity by utilizing short length Lyot filter. The central wavelengths of dual-wavelength mode-locked fiber laser are 1540 nm and 1564 nm and the tunable laser range is about 32 nm. We believe it could provide a simple set-up for generating dual-wavelength and wavelength tunable mode-locked output from one laser cavity.

physics.optics↗

arXiv2019

All-fiber dual-wavelength mode-locked laser using a bend-induced-birefringence Lyot-filter as gain-tilt equalizer

Multi-wavelength fiber lasers have emerged as a promising light source for the application in wavelength division multiplexing communication, terahertz wave generation and optical sensing due to high efficiency and robustness. Lyot-filter emerges as a potential device for multi-wavelength generation application. However, because of the high birefringence of polarization maintaining fiber in Lyot-filter, it is difficult to generate broadband dual-wavelength or multi-wavelength mode-locked fiber laser by using common Lyot-filter. In this paper, for the first time, we propose an idea of using the low birefringence induced by bending the single-mode fiber to form a Lyot-filter for dual-wavelength mode-locked fiber laser generation. The dual-wavelength output centers at 1532 and 1556 nm and it may simplify the set-up for dual-wavelength mode-locked laser.

physics.optics↗

arXiv2018

Spontaneous laser line sweeping in bi-directional ring thulium fiber laser

We report a phenomenon of self-sweeping in a bi-directional ring thulium-doped fiber laser, for the first time. The laser is spontaneously sweeping in both directions at a rate up to 0.2 nm/s with 15 nm sweeping range in 1.95 μm wavelength region. The laser output is switchable between two different working modes: periodical spontaneous laser line sweeping with generation of microsecond pulses in time domain; or static central wavelength with amplitude modulated temporally.

physics.optics↗

arXiv2018

Two-Photon Absorption and Saturable Absorption of Mid-IR in Graphene

We report on the response of graphene to high intensity mid-IR radiation and show that graphene exhibits saturable absorption and significant two-photon absorption in the spectral region from 1.55 $μ$m to 3.50 $μ$m (0.35 eV to 0.80 eV). We find that the effective modulation depth of multilayer graphene is limited by two-photon absorption which will affect its performance as a laser mode-locking element. The measured saturation intensities of femtosecond pulses were found to depend on the third power of photon energy when we combined our results with others reported in literature, while those of longer pulses were found to have a square root dependence.

physics.optics↗

arXiv2018

Fiber-optic cascaded forward Brillouin scattering seeded by backward stimulated Brillouin scattering: conceptual proposal and experimental validation

We propose a method for generating cascaded forward Brillouin scattering (CFBS), based on a counter-propagated pump-probe technique, utilizing backward stimulated Brillouin scattering as its seed. The CFBS, induced by forward stimulated Brillouin scattering (FSBS), is generated via the energy transfer from the probe light to other acoustic resonance frequencies. Experimental results for the CFBS generated in a 390-m-long highly nonlinear fiber indicate that it has a high signal-to-noise ratio (SNR) and that the center frequencies of its acoustic resonance peaks agree with theoretical values. The sensing properties of the generated CFBS were also verified.

physics.optics↗