arXiv subjects

T. Endo

Publications and source records attributed to T. Endo.

11 recordsLinked to original sources

arXiv2023

Electrical transport properties of atomically thin WSe2 using perpendicular magnetic anisotropy metal contacts

Tungsten diselenide, WSe2 shows excellent properties and become very promising material among two dimensional semiconductors. Wide band gap and large spin-orbit coupling along with naturally lacking inversion symmetry in the monolayer WSe2 make it efficient material for spintronics, optoelectronics and valleytronics applications. In this work, we report electrical transport properties of monolayer WSe2 based field effect transistor with most needed multilayer Co/Pt ferromagnetic electrodes exhibiting perpendicular magnetic anisotropy. We studied contacts behaviour by performing I-V curve measurements and estimating Schottky barrier heights (SBHs). SBHs estimated from experimental data are found to be comparatively small, without using any tunnel barrier. This work expands the current understanding of WSe2 based devices and gives insight into the electrical behaviour of Co/Pt metal contacts, which can open great possibilities for spintronic/valleytronic applications.

cond-mat.mtrl-sci↗

arXiv2019

Monolayer MoS2 field effect transistor with low Schottky barrier height with ferromagnetic metal contacts

Two-dimensional MoS2 has emerged as promising material for nanoelectronics and spintronics due to its exotic properties. However, high contact resistance at metal semiconductor MoS2 interface still remains an open issue. Here, we report electronic properties of field effect transistor devices using monolayer MoS2 channels and permalloy (Py) as ferromagnetic (FM) metal contacts. Monolayer MoS2 channels were directly grown on SiO2/Si substrate via chemical vapor deposition technique. The increase in current with back gate voltage shows the tunability of FET characteristics. The Schottky barrier height (SBH) estimated for Py/MoS2 contacts is found to be +28.8 meV (zero-bias), which is the smallest value reported so-far for any direct metal (magnetic or non-magnetic)/monolayer MoS2 contact. With the application of gate voltage (+10 V), SBH shows a drastic reduction down to a value of -6.8 meV. The negative SBH reveals ohmic behavior of Py/MoS2 contacts. Low SBH with controlled ohmic nature of FM contacts is a primary requirement for MoS2 based spintronics and therefore using directly grown MoS2 channels in the present study can pave a path towards high performance devices for large scale applications.

physics.app-ph↗

arXiv2016

Integrated simulation of magnetic-field-assist fast ignition laser fusion

To enhance the core heating efficiency in fast ignition laser fusion, the concept of relativistic electron beam guiding by external magnetic fields was evaluated by integrated simulations for FIREX class targets. For the cone-attached shell target case, the core heating performance is deteriorated by applying magnetic fields since the core is considerably deformed and the most of the fast electrons are reflected due to the magnetic mirror formed through the implosion. On the other hand, in the case of cone-attached solid ball target, the implosion is more stable under the kilo-tesla-class magnetic field. In addition, feasible magnetic field configuration is formed through the implosion. As the results, the core heating efficiency becomes double by magnetic guiding. The dependence of core heating properties on the heating pulse shot timing was also investigated for the solid ball target.

physics.plasm-ph↗

arXiv2015

Measurement and comparison of individual external doses of high-school students living in Japan, France, Poland and Belarus -- the "D-shuttle" project --

Twelve high schools in Japan (of which six are in Fukushima Prefecture), four in France, eight in Poland and two in Belarus cooperated in the measurement and comparison of individual external doses in 2014. In total 216 high-school students and teachers participated in the study. Each participant wore an electronic personal dosimeter "D-shuttle" for two weeks, and kept a journal of his/her whereabouts and activities. The distributions of annual external doses estimated for each region overlap with each other, demonstrating that the personal external individual doses in locations where residence is currently allowed in Fukushima Prefecture and in Belarus are well within the range of estimated annual doses due to the background radiation level of other regions/countries.

physics.med-ph↗

arXiv2011

Laser-Shock Compression and Hugoniot Measurements of Liquid Hydrogen to 55 GPa

The principal Hugoniot for liquid hydrogen was obtained up to 55 GPa under laser-driven shock loading. Pressure and density of compressed hydrogen were determined by impedance-matching to a quartz standard. The shock temperature was independently measured from the brightness of the shock front. Hugoniot data of hydrogen provide a good benchmark to modern theories of condensed matter. The initial number density of liquid hydrogen is lower than that for liquid deuterium, and this results in shock compressed hydrogen having a higher compression and higher temperature than deuterium at the same shock pressure.

cond-mat.mtrl-sci↗

arXiv2006

Phase Transition of Extrinsic Curvature Surface Model on a Disk

An extrinsic curvature surface model is investigated by Monte Carlo simulations on a disk. We found that the model undergoes a first-order transition separating the smooth phase from the collapsed phase. The results in this paper together with the previous ones suggest that the order of the transition is independent of whether the surface is compact (closed) or non-compact (open).

cond-mat.stat-mech↗

arXiv2006

Phase transitions of an intrinsic curvature model on dynamically triangulated spherical surfaces with point boundaries

An intrinsic curvature model is investigated using the canonical Monte Carlo simulations on dynamically triangulated spherical surfaces of size upto N=4842 with two fixed-vertices separated by the distance 2L. We found a first-order transition at finite curvature coefficient α, and moreover that the order of the transition remains unchanged even when L is enlarged such that the surfaces become sufficiently oblong. This is in sharp contrast to the known results of the same model on tethered surfaces, where the transition weakens to a second-order one as L is increased. The phase transition of the model in this paper separates the smooth phase from the crumpled phase. The surfaces become string-like between two point-boundaries in the crumpled phase. On the contrary, we can see a spherical lump on the oblong surfaces in the smooth phase. The string tension was calculated and was found to have a jump at the transition point. The value of σis independent of L in the smooth phase, while it increases with increasing L in the crumpled phase. This behavior of σis consistent with the observed scaling relation σ\sim (2L/N)^ν, where ν\simeq 0 in the smooth phase, and ν=0.93\pm 0.14 in the crumpled phase. We should note that a possibility of a continuous transition is not completely eliminated.

cond-mat.stat-mech↗

arXiv2006

Phase transition of triangulated spherical surfaces supported by elastic chains with rigid junctions

A surface model with skeletons is investigated by using the canonical Monte Carlo simulations. The skeleton is composed of linear chains, which are joined to each other at the rigid junctions. A one-dimensional bending energy is defined on the linear chains, and no two-dimensional curvature energy is assumed on the surface. The model undergoes a first-order transition between the smooth phase and the crumpled phase. We conclude that the first-order transition of the surface model with skeletons is independent of whether the junctions are elastic or rigid.

cond-mat.stat-mech↗

arXiv2004

Study of the Sigma-nucleus potential by the (pi^-,K^+) reaction on medium-to-heavy nuclear targets

In order to study the Sigma-nucleus optical potential, we measured inclusive (pi^-,K^+) spectra on medium-to-heavy nuclear targets: CH_2, Si, Ni, In and Bi. The CH_2 target was used to calibrate the excitation energy scale by using the elementary process p + pi^- -> K^+ + Sigma^-, where the C spectrum was also extracted. The calibration was done with +-0.1 MeV precision. The angular distribution of the elementary cross section was measured, and agreed well with the previous bubble chamber data, but with better statistics, and the magnitudes of the cross sections of the measured inclusive (pi^-,K^+) spectra were also well calibrated. All of the inclusive spectra were found to be similar in shape at a region near to the Sigma^- binding energy threshold, showing a weak mass-number dependence on the magnitude of the cross section. The measured spectra were compared with a theoretical calculation performed within the framework of the Distorted Wave Impulse Approximation (DWIA). It has been demonstrated that a strongly repulsive \sig-nucleus potential with a non-zero size of the imaginary part is required to reproduce the shape of the measured spectra.

nucl-ex↗

arXiv2002

Nature of the Soft Spectral Component in the X-ray Pulsars SMC X-1 and LMC X-4

We present here the results of an investigation of the pulse averaged and pulse phase resolved energy spectra of two high luminosity accretion powered X-ray pulsars SMC X-1 and LMC X-4 made with ASCA. The phase averaged energy spectra definitely show the presence of a soft excess in both the sources. If the soft excess is modeled as a separate black-body or thermal bremsstrahlung type component, pulse phase resolved spectroscopy of SMC X-1 shows that the soft component also has a pulsating nature. Same may be true for LMC X-4, though a very small pulse fraction limits the statistical significance. The pulsating soft component is found to have a nearly sinusoidal profile, dissimilar to the complex profile seen at higher energies, which can be an effect of smearing. Due to very high luminosity of these sources, the size of the emission zone required for the soft component is large (radius ~300-400 km). We show that the pulsating nature of the soft component is difficult to explain if a thermal origin is assumed for it. We further investigated with alternate models, like inversely broken power-law or two different power-law components and found that these models can also be used to explain the excess at low energy. A soft power-law component may be a common feature of the accreting X-ray pulsars, which is difficult to detect because most of the HMXB pulsars are in the Galactic plane and experience large interstellar absorption. In LMC X-4, we have also measured two additonal mid-eclipse times, which confirm the known orbital decay.

astro-ph↗

arXiv2000

Diamagnetic Response of Normal-Superconducting Double Layers

The diamagnetism of a normal metal (N: Cu or Au), which is induced by the proximity effect of a superconductor (S: Nb), has been investigated for N-S double layers, which are formed by a thin-film deposition process. Detailed studies of samples, which have different electronic mean-free path \ell_N in N, suggest that \ell_N should be controlled by the impurity concentration rather than the mechanical imperfections in the lattice in order to clarify the \ell_N dependence of the proximity effect. Both the screening distance ρin N and the parameter νin ρ\propto T^-νincrease with an increase in \ell_N. This result can be understood on the assumption that the normal metal changes its behavior from the "dirty" limit (ξ_N>\ell_N) to the "clean" limit (ξ_N<\ell_N), where ξ_N is the coherence length in N.

cond-mat.supr-con↗