arXiv subjects

T. Junginger

Publications and source records attributed to T. Junginger.

10 recordsLinked to original sources

arXiv2024

The Belle II Detector Upgrades Framework Conceptual Design Report

We describe the planned near-term and potential longer-term upgrades of the Belle II detector at the SuperKEKB electron-positron collider operating at the KEK laboratory in Tsukuba, Japan. These upgrades will allow increasingly sensitive searches for possible new physics beyond the Standard Model in flavor, tau, electroweak and dark sector physics that are both complementary to and competitive with the LHC and other experiments.

hep-ex↗

arXiv2023

Statement from the American Linear Collider Committee to the P5 subpanel

This statement from the American Linear Collider Committee to the P5 subpanel has three purposes. It presents a brief summary of the case for an $e^+e^-$ Higgs factory that has emerged from Snowmass 2021. It highlights the special virtues of the ILC that are shared with other linear colliders but not with circular colliders. Finally, it calls attention to the resources available in the ILC White Paper for Snowmass (arXiv:2203.07622). The ALCC urges P5 to move the Higgs factory forward as a global project by assigning the idea of an $e^+e^-$ Higgs factory high priority, initiating a global discussion of the technology choice and cost sharing, and offering the option of siting the Higgs factory in the U.S.

hep-ph↗

arXiv2022

Modelling dielectric loss in superconducting resonators: Evidence for interacting atomic two-level systems at the Nb/oxide interface

While several experiments claim that two-level system (TLS) defects in amorphous surfaces/interfaces are responsible for energy relaxation in superconducting resonators and qubits, none can provide quantitative explanation of their data in terms of the conventional noninteracting TLS model. Here a model that interpolates between the interacting and noninteracting TLS loss tangent is proposed to perform numerical analysis of experimental data and extract information about TLS parameters and their distribution. As a proof of principle, the model is applied to TESLA cavities that contain only a single lossy material in their interior, the niobium/niobium oxide interface. The best fits show interacting TLSs with a sharp modulus of electric dipole moment for both thin (5 nm) and thick (100 nm) oxides, indicating that the TLSs are "atomic" instead of "glassy". The proposed method can be applied to other devices with multiple material interfaces and substrates, with the goal of elucidating the nature of TLSs causing energy loss in resonators and qubits.

quant-ph↗

arXiv2022

Snowmass 2021 White Paper on Upgrading SuperKEKB with a Polarized Electron Beam: Discovery Potential and Proposed Implementation

Upgrading the SuperKEKB electron-positron collider with polarized electron beams opens a new program of precision physics at a center-of-mass energy of 10.58 GeV. This white paper describes the physics potential of this `Chiral Belle' program. It includes projections for precision measurements of $\sin^2θ_W$ that can be obtained from independent left-right asymmetry measurements of $e^+e^-$ transitions to pairs of electrons, muons, taus, charm and b-quarks. The $\sin^2θ_W$ precision obtainable at SuperKEKB will match that of the LEP/SLC world average, but at the centre-of-mass energy of 10.58 GeV. Measurements of the couplings for muons, charm, and $b$-quarks will be substantially improved and the existing $3σ$ discrepancy between the SLC $A_{LR}$ and LEP $A_{FB}^b$ measurements will be addressed. Precision measurements of neutral current universality will be more than an order of magnitude more precise than currently available. As the energy scale is well away from the $Z^0$-pole, the precision measurements will have sensitivity to the presence of a parity-violating dark sector gauge boson, $Z_{\rm dark}$. The program also enables the measurement of the anomalous magnetic moment $g-2$ form factor of the $τ$ to be made at an unprecedented level of precision. A precision of $10^{-5}$ level is accessible with 40~ab$^{-1}$ and with more data it would start to approach the $10^{-6}$ level. This technique would provide the most precise information from the third generation about potential new physics explanations of the muon $g-2$ $4σ$ anomaly. Additional $τ$ and QCD physics programs enabled or enhanced with having polarized electron beams are also discussed in this White Paper. This paper includes a summary of the path forward in R&D and next steps required to implement this upgrade and access its exciting discovery potential.

physics.acc-ph↗

arXiv2022

Next-Generation Superconducting RF Technology based on Advanced Thin Film Technologies and Innovative Materials for Accelerator Enhanced Performance and Energy Reach

Superconducting RF is a key technology for future particle accelerators, now relying on advanced surfaces beyond bulk Nb for a leap in performance and efficiency. The SRF thin film strategy aims at transforming the current SRF technology by using highly functional materials, addressing all the necessary functions. The community is deploying efforts in three research thrusts to develop next-generation thin-film based cavities. Nb on Cu cavities are developed to perform as good as or better than bulk Nb at reduced cost and with better thermal stability. Recent results showing improved accelerating field and dramatically reduced Q slope show their potential for many applications. The second research thrust is to develop cavities coated with materials that can operate at higher temperatures or sustain higher fields. Proof of principle has been established for the merit of Nb3Sn for SRF application. Research is now needed to further exploit the material and reach its full potential with novel deposition techniques. The third line of research is to push SRF performance beyond the capabilities of the superconductors alone with multilayered coatings. In parallel, developments are needed to provide quality substrates, cooling schemes and cryomodule design tailored to thin film cavities. Recent results in these three research thrusts suggest that SRF thin film technologies are at the eve of a technological revolution. For them to mature, active community support and sustained funding are needed to address fundamental developments supporting material deposition techniques, surface and RF research, technical challenges associated with scaling and industrialization. With dedicated and sustained investment, next-generation thin-film based cavities will become a reality with high performance and efficiency, facilitating energy sustainable science while enabling higher luminosity, and higher energy.

physics.acc-ph↗

arXiv2020

Coaxial multi-mode cavities for fundamental SRF research in an unprecedented parameter space

Recent developments in superconducting radio-frequency (SRF) research have focused primarily on high frequency elliptical cavities for electron accelerators. Advances have been made in both reducing RF surface resistance and pushing the readily achievable accelerating gradient by using novel SRF cavity treatments including surface processing, custom heat treatments, and flux expulsion. Despite the global demand for SRF based hadron accelerators, the advancement of TEM mode cavities has lagged behind. To address this, two purpose-built research cavities, one quarter-wave and one half-wave resonator, have been designed and built to allow characterization of TEM-mode cavities with standard and novel surface treatments. The cavities are intended as the TEM mode equivalent to the 1.3GHz single cell cavity, which is the essential tool for high frequency cavity research. Given their coaxial structure, the cavities allow testing at the fundamental mode and higher harmonics, giving unique insight into the role of RF frequency on fundamental loss mechanisms from intrinsic and extrinsic sources. In this paper, the cavities and testing infrastructure are described and the first performance measurements of both cavities are presented.

physics.acc-ph↗

arXiv2019

Critical Fields of Nb$_3$Sn Prepared for Superconducting Cavities

Nb$_3$Sn is currently the most promising material other than niobium for future superconducting radiofrequency cavities. Critical fields above 120 mT in pulsed operation and about 80 mT in CW have been achieved in cavity tests. This is large compared to the lower critical field as derived from the London penetration depth, extracted from low field surface impedance measurements. In this paper direct measurements of the London penetration depth from which the lower critical field and the superheating field are derived are presented. The field of first vortex penetration is measured under DC and RF fields. The combined results confirm that Nb$_3$Sn cavities are indeed operated in a metastable state above the lower critical field but are currently limited to a critical field well below the superheating field.

physics.acc-ph↗

arXiv2017

Field of first flux entry and pinning strength of superconductors for RF application measured with muon spin rotation

The performance of superconducting radiofrequency (SRF) cavities used for particle accelerators depends on two characteristic material parameters: field of first flux entry $H_{entry}$ and pinning strength. The former sets the limit for the maximum achievable accelerating gradient, while the latter determines how efficiently flux can be expelled related to the maximum achievable quality factor. In this paper, a method based on muon spin rotation ($μ$SR) is developed to probe these parameters on samples. It combines measurements from two different spectrometers, one being specifically built for these studies and samples of different geometries. It is found that annealing at 1400°C virtually eliminates all pinning. Such an annealed substrate is ideally suited to measure $H_{entry}$ of layered superconductors, which might enable accelerating gradients beyond bulk niobium technology.

cond-mat.supr-con↗

arXiv2017

A low energy muon spin rotation and point contact tunneling study of niobium films prepared for superconducting cavities

Point contact tunneling (PCT) and low energy muon spin rotation (LE-muSR) are used to probe, on the same samples, the surface superconducting properties of micrometer thick niobium films deposited onto copper substrates using different sputtereing techniques: diode, dc magnetron (dcMS) and HIPIMS. The combined results are compared to radio-frequency tests performances of RF cavities made with the same processes. Degraded surface superconducting properties are found to yield lower quality factors and stronger Q slope. In addition, both techniques find evidence for surface paramagnetism on all samples and particularly on Nb films prepared by HIPIMS.

cond-mat.supr-con↗

arXiv2017

Superheating in coated niobium

Using muon spin rotation it is shown that the field of first flux penetration H_entry in Nb is enhanced by about 30% if coated with an overlayer of Nb_3Sn or MgB_2. This is consistent with an increase from the lower critical magnetic field H_c1 up to the superheating field H_sh of the Nb substrate. In the experiments presented here coatings of Nb_3Sn and MgB_2 with a thickness between 50 and 2000nm have been tested. H_entry does not depend on material or thickness. This suggests that the energy barrier at the boundary between the two materials prevents flux entry up to H_sh of the substrate. A mechanism consistent with these findings is that the proximity effect recovers the stability of the energy barrier for flux penetration, which is suppressed by defects for uncoated samples. Additionally, a low temperature baked Nb sample has been tested. Here a 6% increase of H_entry was found, also pushing H_entry beyond H_c1.

cond-mat.supr-con↗