arXiv subjects

T. Okugi

Publications and source records attributed to T. Okugi.

13 recordsLinked to original sources

arXiv2025

Status of the International Linear Collider

This paper is not a proposal for a CERN future project but provides information on the International Linear Collider (ILC) considered for Japan in order to facilitate the European Strategy discussion in a global context. It describes progress to date, ongoing engineering studies, updated cost estimate for the machine at $\sqrt{s}=250~\rm GeV$ and the situation in Japan. The physics of the ILC is not presented here, but jointly for all Linear Collider projects in a separate document ``A Linear Collider Vision for the Future of Particle Physics'' submitted for the forthcoming European Strategy deliberations.

hep-ex↗

arXiv2020

A sub-micron resolution, bunch-by-bunch beam trajectory feedback system and its application to reducing wakefield effects in single-pass beamlines

A high-precision intra-bunch-train beam orbit feedback correction system has been developed and tested in the ATF2 beamline of the Accelerator Test Facility at the High Energy Accelerator Research Organization in Japan. The system uses the vertical position of the bunch measured at two beam position monitors (BPMs) to calculate a pair of kicks which are applied to the next bunch using two upstream kickers, thereby correcting both the vertical position and trajectory angle. Using trains of two electron bunches separated in time by 187.6~ns, the system was optimised so as to stabilize the beam offset at the feedback BPMs to better than 350~nm, yielding a local trajectory angle correction to within 250~nrad. The quality of the correction was verified using three downstream witness BPMs and the results were found to be in agreement with the predictions of a linear lattice model used to propagate the beam trajectory from the feedback region. This same model predicts a corrected beam jitter of c.~1~nm at the focal point of the accelerator. Measurements with a beam size monitor at this location demonstrate that reducing the trajectory jitter of the beam by a factor of 4 also reduces the increase in the measured beam size as a function of beam charge by a factor of c.~1.6.

physics.acc-ph↗

arXiv2018

Evaluation of Beam Halo from Beam-Gas Scattering at the KEK-ATF

In circular colliders, as well as in damping rings and synchrotron radiation light sources, beam halo is one of the critical issues limiting the performance as well as potentially causing component damage and activation. It is imperative to clearly understand the mechanisms that lead to halo formation and to test the available theoretical models. Elastic beam-gas scattering can drive particles to large oscillation amplitudes and be a potential source of beam halo. In this paper, numerical estimation and Monte Carlo simulations of this process at the ATF of KEK are presented. Experimental measurements of beam halo in the ATF2 beam line using a diamond sensor detector are also described, which clearly demonstrates the influence of the beam-gas scattering process on the transverse halo distribution.

physics.acc-ph↗

arXiv2012

Present status and first results of the final focus beam line at the KEK Accelerator Test Facility

ATF2 is a final-focus test beam line which aims to focus the low emittance beam from the ATF damping ring to a vertical size of about 37 nm and to demonstrate nanometer level beam stability. Several advanced beam diagnostics and feedback tools are used. In December 2008, construction and installation were completed and beam commissioning started, supported by an international team of Asian, European, and U.S. scientists. The present status and first results are described.

physics.acc-ph↗

arXiv2010

Shintake Monitor in ATF2: Performance Evaluation

The beam test for the Shintake monitor succeeded in measuring signal modulation with the laser interference fringe pattern in November 2009. We have studied the error sources, and evaluated the systematic error to be less than 30% for 1 minute measurements. This paper centers on the evaluation of the Shintake monitor performance through analyzing beam tests deta. Most systematic error sources are well understood, enabling accurate measurement of the beam size when it reaches 37 nm.

physics.ins-det↗

arXiv2006

Efficient propagation of the polarization from laser photons to positrons through Compton scattering and electron-positron pair creation

We demonstrated for the first time the production of highly polarized short-pulse positrons with a finite energy spread in accordance with a new scheme that consists of two-quantum processes, such as inverse Compton scatterings and electron-positron pair creations. Using a circularly polarized laser beam of 532 nm scattered off a high-quality electron beam with the energy of 1.28 GeV, we obtained polarized positrons with an intensity of 10^4 e+/bunch. Magnitude of positron polarizations was determined as 73+-15(sta) +-19(sys)% by means of a newly designed positron polarimeter.

hep-ex↗

arXiv2005

Design of a Polarised Positron Source Based on Laser Compton Scattering

We describe a scheme for producing polarised positrons at the ILC from polarised X-rays created by Compton scattering of a few-GeV electron beam off a CO2 or YAG laser. This scheme is very energy effective using high finesse laser cavities in conjunction with an electron storage ring.

physics.acc-ph↗

arXiv2002

Intrabeam scattering analysis of measurements at KEK's ATF damping ring

We derive a simple relation for estimating the relative emittance growth in x and y due to intrabeam scattering (IBS) in electron storage rings. We show that IBS calculations for the ATF damping ring, when using the formalism of Bjorken-Mtingwa, a modified formalism of Piwinski (where eta squared divided by beta has been replaced by the dispersion invariant), or a simple high-energy approximate formula all give results that agree well. Comparing theory, including the effect of potential well bunch lengthening, with a complete set of ATF steady-state beam size vs. current measurements we find reasonably good agreement for energy spread and horizontal emittance. The measured vertical emittance, however, is larger than theory in both offset (zero current emittance) and slope (emittance change with current). The slope error indicates measurement error and/or additional current-dependent physics at the ATF; the offset error, that the assumed Coulomb log is correct to within a factor of 1.75.

physics.acc-ph↗

arXiv2001

Intrabeam Scattering Analysis of ATF Beam Measurements

At the Accelerator Test Facility (ATF) at KEK intrabeam scattering (IBS) is a strong effect for an electron machine. It is an effect that couples all dimensions of the beam, and in April 2000, over a short period of time, all dimensions were measured as functions of current. In this report we derive a simple relation for the growth rates of emittances due to IBS. We apply the theories of Bjorken-Mtingwa, Piwinski, and a formula due to Raubenheimer to the ATF parameters, and find that the results all agree (if in Piwinski's formalism we replace the dispersion squared over beta by the dispersion invariant). Finally, we compare theory, including the effect of potential well bunch lengthening, with the April 2000 measurements, and find reasonably good agreement in the energy spread and horizontal emittance dependence on current. The vertical emittance measurement, however, implies that either: there is error in the measurement (equivalent to an introduction of 0.6% x-y coupling error), or the effect of intrabeam scattering is stronger than predicted (35% stronger in growth rates).

physics.acc-ph↗

arXiv2001

Impedance Analysis of Bunch Length Measurements at the ATF Damping Ring

We present energy spread and bunch length measurements at the Accelerator Test Facility (ATF) at KEK, as functions of current, for different ring rf voltages, and with the beam both on and off the coupling resonance. We fit the on-coupling bunch shapes to those of an impedance model consisting of a resistor and an inductor connected in series. We find that the fits are reasonably good, but that the resulting impedance is unexpectedly large.

physics.acc-ph↗

arXiv2000

Intrabeam Scattering Analysis of ATF Beam Data Taken in April 2000

In April 2000 the single bunch energy spread, bunch length, horizontal emittance, and vertical emittance were measured as functions of current in KEK's ATF damping ring. In this report the measurement results are analyzed in light of intrabeam scattering theory. The measurements are found to be relatively consistent with theory, although the measured effects appear to be stronger than theory. In addition, the factor of 3 growth in vertical emittance at a current of 3 mA does not seem to be supported.

physics.acc-ph↗

arXiv2000

Bunch Length Measurements at the ATF Damping Ring in April 2000

This report presents bunch length and energy spread measurements performed in April 2000 at the ATF Damping Ring, at KEK. Measurements were performed with the beam on and then off the linear (difference) coupling resonance. Due to strong intra-beam scattering in the ATF ring, the results depended strongly on the coupling.

physics.acc-ph↗

arXiv2000

Energy stabilization of 1.5 GeV S-Band linac

KEK-ATF is studying low emittance, multi-bunch electron beam for the future linear collider. The energy instability of the 1.5 GeV linac has been a problem making the beam injection to the damping ring unstable. Because the unstable beam generates also large amount of the radiation, the beam current is limited by the KEK radiation safety policy much lower than what we expect. Stabilizing the S-band linac is therefore important not only to improve the beam quality, but also to clear the radiation safety limit to start the multi-bunch operation. We have made various modifications to solve the problem on the electron gun, modulator, klystron etc. For the modulator, we have developed a feed-forward controlled De-Q module. This module compensates the voltage jitter by controlling the deQ timing with a feed-forward circuit because the amount of the excessive charge up is strongly correlated to the charge up slope that can be measured prior to the deQ timing. The energy stability was examined and was improved by a factor of 3, from 0.6% to 0.2% of itself. Modification for the feed-forward circuit to get more stability was made. The test for the new circuit is in progress. For the long term instability, phase-lock system for klystron RF is being installed. In the test operation, it showed a good performance and compensate the phase drift less than 1 deg.

physics.acc-ph↗