Searcharxiv⌕ Search

arXiv subjects

T. Thuillier

Publications and source records attributed to T. Thuillier.

7 recordsLinked to original sources
arXiv2025

Meshing method to build a centrosymmetric matrix to solve partial differential equations on an irreducible domain including a planar symmetry

A general method to generate a centrosymmetric matrix associated with the solving of partial differential equation (PDE) on an irreducible domain by means of a linear equation system is proposed. The method applies to any PDE for which both the domain to solve and the boundary condition (BC) type accept a planar symmetry, while no conditions are required on the BC values and the PDE right hand size function. It is applicable to finite element or finite difference method (FDM). It relies both on the specific construction of a mesh having a planar symmetry and a centrosymmetric numbering of the mesh nodes used to solve the PDE on the domain. The method is exemplified with a simple PDE using FDM. The method allows to reduce the numerical problem size to solve by a factor of two, decreasing as much the computing time and the need of computer memory.

math.NA↗
arXiv2021

Method for estimating charge breeder ECR ion source plasma parameters with short pulse 1+ injection

A new method for determining plasma parameters from beam current transients resulting from short pulse 1+ injection into a Charge Breeder Electron Cyclotron Resonance Ion Source (CB-ECRIS) has been developed. The proposed method relies on few assumptions, and yields the ionisation times $1/n_e\left\langleσv\right\rangle^{\text{inz}}_{q\to q+1}$, charge exchange times $1/n_0\left\langleσv\right\rangle^{\text{cx}}_{q\to q-1}$, the ion confinement times $τ^q$, as well as the plasma energy contents $n_e\left\langle E_e\right\rangle$ and the plasma triple products $n_e \left\langle E_e\right\rangle τ^q$. The method is based on fitting the current balance equation on the extracted beam currents of high charge state ions, and using the fitting coefficients to determine the postdictions for the plasma parameters via an optimisation routine. The method has been applied for the charge breeding of injected K$^+$ ions in helium plasma. It is shown that the confinement times of K$^{q+}$ charge states range from 2.6$^{+0.8}_{-0.4}$ ms to 16.4$^{+18.3}_{-6.8}$ ms increasing with the charge state. The ionisation and charge exchange times for the high charge state ions are 2.6$^{+0.5}_{-0.5}$ ms--12.6$^{+2.6}_{-3.2}$ ms and 3.7$^{+5.0}_{-1.6}$ ms--357.7$^{+406.7}_{-242.4}$ ms, respectively. The plasma energy content is found to be $2.5^{+4.3}_{-1.8}\times 10^{15}$ eV/cm$^3$.

physics.plasm-ph↗
arXiv2021

Angular distribution measurement of atoms evaporated from a resistive oven applied to ion beam production

A low temperature oven has been developed to produce calcium beam with Electron Cyclotron Resonance Ion Source (ECRIS). The atom flux from the oven has been studied experimentally as a function of the temperature and the angle of emission by means of a quartz microbalance. The absolute flux measurement permitted to derive Antoine's coefficient for the calcium sample used : A=8.98$\pm$ 0.07 and B=7787$\pm$ 110 in standard unit. The angular FWHM of the atom flux distribution is found to be 53.7°$\pm$7.3 at 848K, temperature at which the gas behaviour is non collisional. The atom flux hysteresis observed experimentally in several laboratories is explained as follows: at first calcium heating, the evaporation comes from the sample only, resulting in a small evaporation rate. once a full calcium layer has formed on the crucible refractory wall, the calcium evaporation surface includes the crucible's enhancing dramatically the evaporation rate for a given temperature. A Monte-Carlo code, developed to reproduce and investigate the oven behaviour as a function of temperature is presented. A discussion on the gas regime in the oven is proposed as a function of its temperature. A fair agreement between experiment and simulation is found.

physics.acc-ph↗
arXiv2013

The EUROnu Project

The EUROnu project has studied three possible options for future, high intensity neutrino oscillation facilities in Europe. The first is a Super Beam, in which the neutrinos come from the decay of pions created by bombarding targets with a 4 MW proton beam from the CERN High Power Superconducting Proton Linac. The far detector for this facility is the 500 kt MEMPHYS water Cherenkov, located in the Fréjus tunnel. The second facility is the Neutrino Factory, in which the neutrinos come from the decay of μ+ and μ- beams in a storage ring. The far detector in this case is a 100 kt Magnetised Iron Neutrino Detector at a baseline of 2000 km. The third option is a Beta Beam, in which the neutrinos come from the decay of beta emitting isotopes, in particular 6He and 18Ne, also stored in a ring. The far detector is also the MEMPHYS detector in the Fréjus tunnel. EUROnu has undertaken conceptual designs of these facilities and studied the performance of the detectors. Based on this, it has determined the physics reach of each facility, in particular for the measurement of CP violation in the lepton sector, and estimated the cost of construction. These have demonstrated that the best facility to build is the Neutrino Factory. However, if a powerful proton driver is constructed for another purpose or if the MEMPHYS detector is built for astroparticle physics, the Super Beam also becomes very attractive.

physics.acc-ph↗
arXiv2002

Experimental study of a proximity focusing Cherenkov counter prototype for the AMS experiment

A study prototype of Proximity Focussing Ring Imaging Cherenkov counter has been built and tested with several radiators using separately cosmic-ray particles and 12C beam fragmentation products at several energies. Counter prototype and experimental setup are described, and the results of measurements reported and compared with simulation results.The performances are discussed in the perspective of the final counter design.

astro-ph↗
arXiv2001

A RICH prototype for the AMS experiment

The AMS spectrometer will be installed on the International Space Station at the end of 2003. Among other improvements over the first version of the instrument, a ring imaging Cherenkov detector (RICH) will be added which latter should open a new window for cosmic-ray physics, allowing isotope separation up to A~25 between 1 and 10 GeV/c and elements identification up to Z~25 between threshold and 1 TeV/c/nucleon. It should also contribute to the high level of redundancy required for AMS and reject efficiency albedo particles. The results of the first generation prototype and the expected results of the new one are discussed.

astro-ph↗