arXiv subjects

Taegyu Ha

Publications and source records attributed to Taegyu Ha.

4 recordsLinked to original sources

arXiv2025

In-situ tuning of cavity dissipation and a topological transition in an atom-nanotip-cavity system

We theoretically investigate a method for tuning a dissipation rate in an atom-cavity system. By inserting a nanotip into the cavity mode, we estimate that the cavity dissipation rate increases by a factor of approximately 20, due to the scattering loss at the tip. As applications of our in-situ technique, we demonstrate that an exceptional line can be obtained when a single atom or ion is coupled to the resonator. Moreover, the position of an exceptional point is tuned by adjusting the decay rate, enabling a topological transition through dissipation control alone.

quant-ph↗

arXiv2024

Pushing single atoms near an optical cavity

Optical scattering force is used to reduce the loading time of single atoms to a cavity mode. Releasing a cold atomic ensemble above the resonator, we apply a push beam along the direction of gravity, offering fast atomic transport with narrow velocity distribution. We also observe in real time that, when the push beam is illuminated against gravity, single atoms slow down and even turn around in the mode, through the cavity-transmission measurement. Our method can be employed to make atom-cavity experiments more efficient.

quant-ph↗

arXiv2023

Third-order exceptional point in an ion-cavity system

We investigate a scheme for observing the third-order exceptional point (EP3) in an ion-cavity setting. In the lambda-type level configuration, the ion is driven by a pump field, and the resonator is probed with another weak laser field. We exploit the highly asymmetric branching ratio of an ion's excited state to satisfy the weak-excitation limit, which allows us to construct the non-Hermitian Hamiltonian $(H_{\textrm{nH}})$. Via fitting the cavity-transmission spectrum, the eigenvalues of $H_{\textrm{nH}}$ are obtained. The EP3 appears at a point where the Rabi frequency of the pump laser and the atom-cavity coupling constant balance the loss rates of the system. Feasible experimental parameters are provided.

quant-ph↗

arXiv2022

Precise and extensive characterization of an optical resonator for cavity-based quantum networks

Cavity-based quantum node is a competitive platform for distributed quantum networks. Here, we characterize a high-finesse Fabry-Perot optical resonator for coupling single or few atomic quantum registers. Our cavity consists of two mirrors with different reflectivities: One has minimal optical loss, and the other high transmission loss where more than 90% of the intracavity photons would be emitted. Cavity finesse, birefringent effects, and mechanical resonances are measured using the lasers at 780, 782, and 795 nm. In order to obtain cavity geometric parameters, we drive the adjacent longitudinal or transverse modes with two lasers simultaneously, and measure those frequencies using a precision wavelength meter (WLM). A major novelty of this method is that the parameters' uncertainties are solely determined by the resolution of the WLM, eliminating all of the temporal environment fluctuations. Our scheme makes it possible to quantify the atom-cavity coupling constant up to four significant figures, the most precise and accurate estimation so far, which would become a key ingredient for benchmarking a cavity-based quantum node. Furthermore, the distortion of polarized photonic qubits would be minimized owing to the small birefringent splitting, below 4.9% of the cavity linewidth. Our system should operate in the intermediate atom-cavity coupling regime that would allow us to implement various quantum network protocols.

quant-ph↗