arXiv subjects

Takahiro Serikawa

Publications and source records attributed to Takahiro Serikawa.

10 recordsLinked to original sources

arXiv2025

Uni-Traveling-Carrier Photodiode Based on MoS2/GaN van der Waals Heterojunction for High-Speed Visible-Light Detection

Uni-traveling-carrier photodiodes (UTC-PDs), which utilize only electrons as the active carriers, have become indispensable in high-speed optoelectronics due to their unique capabilities, such as high saturation power and broad bandwidth. However, extending the operating wavelengths into the visible region for wider applications is challenging due to the lack of suitable wide-bandgap III-V semiconductor combinations with the necessary band alignment and lattice matching. Here, we show that a UTC-PD based on a van der Waals heterojunction composed of a 2D transition metal dichalcogenide, molybdenum disulfide (MoS2), as a photoabsorption layer and a gallium nitride (GaN) film as a carrier transport layer, offers a solution to this challenge. The fast vertical carrier transport across the heterointerface is enabled by the direct epitaxial growth of a MoS2 layer on a GaN film. Our device demonstrates a frequency response in the several-GHz range with a quantum efficiency on the order of 1% throughout the entire visible spectrum, highlighting the promise for high-speed visible optoelectronics.

cond-mat.mtrl-sci↗

arXiv2019

Extending the PZT bandwidth of an optical interferometer by suppressing resonance using a high dimensional IIR filter implemented on an FPGA

This paper considers the application of FPGA-based IIR filtering to increase the usable bandwidth of a piezoelectric transducer used in optical phase locking. We experimentally perform system identification of the interferometer system with the cross-correlation method integrated on the controller hardware. Our model is then used to implement an inverse filter designed to suppress the low frequency resonant modes of the piezo-electric transducer. This filter is realized as an 24th-order IIR filter on the FPGA, while the total input-output delay is kept at 350ns. The combination of the inverse filter and the piezo-electric transducer works as a nearly-flat response position actuator, allowing us to use PI control in order to achieve stability of the closed-loop system with significant improvements over non filtered PI control. Finally, because this controller is completely digital, it is straight forward to reproduce. Our control scheme is suitable for many experiments which require highly accurate control of flexible structures.

physics.app-ph↗

arXiv2019

Characterization of entangling properties of quantum measurement via two-mode quantum detector tomography using coherent state probes

Entangled measurement is a crucial tool in quantum technology. We propose a new entanglement measure of multi-mode detection, which estimates the amount of entanglement that can be created in a measurement. To illustrate the proposed measure, we perform quantum tomography of a two-mode detector that is comprised of two superconducting nanowire single photon detectors. Our method utilizes coherent states as probe states, which can be easily prepared with accuracy. Our work shows that a separable state such as a coherent state is enough to characterize a potentially entangled detector. We investigate the entangling capability of the detector in various settings. Our proposed measure verifies that the detector makes an entangled measurement under certain conditions, and reveals the nature of the entangling properties of the detector. Since the precise characterization of a detector is essential for applications in quantum information technology, the experimental reconstruction of detector properties along with the proposed measure will be key features in future quantum information processing.

quant-ph↗

arXiv2019

Generation and measurement of a squeezed vacuum up to 100 MHz at 1550 nm with a semi-monolithic optical parametric oscillator designed towards direct coupling with waveguide modules

We report generation and measurement of a squeezed vacuum from a semi-monolithic Fabry-Perot optical parametric oscillator (OPO) up to 100 MHz at 1550 nm. The output coupler of the OPO is a flat surface of a nonlinear crystal with partially reflecting coating, which enables direct coupling with waveguide modules. Using the OPO, we observed 6.2dB of squeezing at 2 MHz and 3.0 dB of squeezing at 100 MHz. The OPO operates at the optimal wavelength to minimize propagation losses in silica waveguides and looks towards solving a bottleneck of downsizing these experiments: that of coupling between a squeezer and a waveguide.

quant-ph↗

arXiv2019

Complete temporal mode characterization of non-Gaussian states by dual homodyne measurement

Optical quantum states defined in temporal modes, especially non-Gaussian states like photon-number states, play an important role in quantum computing schemes. In general, the temporal-mode structures of these states are characterized by one or more complex functions called temporal-mode functions (TMFs). Although we can calculate TMF theoretically in some cases, experimental estimation of TMF is more advantageous to utilize the states with high purity. In this paper, we propose a method to estimate complex TMFs. This method can be applied not only to arbitrary single-temporal-mode non-Gaussian states but also to two-temporal-mode states containing two photons. This method is implemented by continuous-wave (CW) dual homodyne measurement and doesn't need prior information of the target states nor state reconstruction procedure. We demonstrate this method by analyzing several experimentally created non-Gaussian states.

quant-ph↗

arXiv2018

Excess Loss in Homodyne Detection Originating from Distributed Photocarrier Generation in Photodiodes

The distributed absorption of photons in photodiodes induces an excess noise in continuous-wave photodetection above the transit-time roll-off frequency. We show that it can be treated as a frequency-dependent excess optical loss in homodyne detection. This places a limit on the bandwidth of high-accuracy homodyne detection, even if an ideal photodetector circuit is available. We experimentally verify the excess loss in two ways; a comparison of signal gain and shot-noise gain of one-port homodyne detection, and a balanced homodyne detection of squeezed light at 500 MHz sideband. These results agree with an analytic expression we develop, where the randomness of the photoabsorption is directly modeled by an intrusion of vacuum field. At 500 MHz, we estimate the excess loss at 14% for a Si-PIN photodiode with 860 nm incident light, while the numerical simulation predicts much smaller excess loss in InGaAs photodiodes with 1550 nm light.

quant-ph↗

arXiv2018

Schrödinger's cat in an optical sideband

We propose a method to subtract a photon from a double sideband mode of continuous-wave light. The central idea is to use phase modulation as a frequency sideband beamsplitter in the heralding photon subtraction scheme, where a small portion of the sideband mode is downconverted to the carrier frequency to provide a trigger photon. An optical Schrödinger's cat state is created by applying the propesed method to a squeezed state at 500MHz sideband, which is generated by an optical parametric oscillator. The Wigner function of the cat state reconstructed from a direct homodyne measurement of the 500MHz sideband modes shows the negativity of $W(0,0) = -0.088\pm0.001$ without any loss corrections.

quant-ph↗

arXiv2018

500MHz resonant photodetector for high-quantum-effciency, low-noise homodyne measurement

We design and demonstrate a resonant-type differential photodetector for low-noise quantum homodyne measurement at 500MHz optical sideband with 17MHz of bandwidth. By using a microwave monolithic amplifier and a discrete voltage buffer circuit, a low-noise voltage amplifier is realized and applied to our detector. 12dB of signal-to-noise ratio of the shot noise to the electric noise is obtained with 5mW of continuous-wave local oscillator. We analyze the frequency response and the noise characteristics of a resonant photodetector, and the theoretical model agrees with the shot noise measurement.

physics.app-ph↗

arXiv2017

Quantum Nondemolition Gate Operations and Measurements in Real Time on Fluctuating Signals

We demonstrate an optical quantum nondemolition (QND) interaction gate with a bandwidth of about 100 MHz. Employing this gate, we are able to perform QND measurements in real time on randomly fluctuating signals. Our QND gate relies upon linear optics and offline-prepared squeezed states. In contrast to previous demonstrations on narrow sideband modes, our gate is compatible with non-Gaussian quantum states temporally localized in a wave-packet mode, and thus opens the way for universal gate operations and realization of quantum error correction.

quant-ph↗

arXiv2016

Creation and Measurement of Broadband Squeezed Vacuum from a Ring Optical Parametric Oscillator

We report a 65MHz-bandwidth triangular-shaped optical parametric oscillator (OPO) for squeezed vacuum generation at 860nm. The triangle structure of our OPO enables the round-trip length to reach 45mm as a ring cavity, which provides a counter circulating optical path available for introducing a probe beam or generating another squeezed vacuum. Hence our OPO is suitable for the applications in high-speed quantum information processing where two or more squeezed vacua form a complicated interferometer, like continuous-variable quantum teleportation. With a homemade, broadband and low-loss homodyne detector, a direct measurement shows 8.4dB of squeezing at 3MHz and also 2.4dB of squeezing at 100MHz.

quant-ph↗