SearcharxivSearch

arXiv subjects

Toshihiko Kadono

Publications and source records attributed to Toshihiko Kadono.

5 recordsLinked to original sources

The dust-rich, gas-depleted protosolar disk as the birthplace of chondrules

Chondrules are the primary components of primitive meteorites known as chondrites, and understanding their formation and accumulation is essential for elucidating the history of planet formation in the Solar System. Although a variety of chondrule formation mechanisms have been proposed, it remains challenging to satisfy the key constraints on chondrule abundance, formation timing, and mineralogical and chemical characteristics within a single model. In particular, the planetesimal bow-shock model, once considered one of the leading candidates, now faces a fundamental difficulty: Jupiter's formation likely depleted gas in the protosolar disk, potentially lowering the gas density below that required for efficient chondrule formation by planetesimal bow shocks. Here we propose an alternative mechanism that can occur in a gas-depleted environment: heavy bombardment of eccentric planetesimals by debris dust. After Jupiter formed in the protosolar disk, the region interior to its orbit became gas-depleted, leading to the formation of a geometrically thin debris-dust layer. When planetesimals enter the dust layer at high speed, large quantities of molten silicate droplets are produced. These droplets cool and solidify into chondrules and are reincorporated into the dust layer. Using analytical calculations, we find that our model can potentially explain the abundance, formation timing, and mineralogical and chemical characteristics of chondrules. This study links the formation of Jupiter and the accompanying evolution of the protosolar disk to the origin of terrestrial planets, asteroids, and meteorites, thereby offering a new framework for the formation of the Solar System.

astro-ph.EP

Crater-ray formation through mutual collisions of hypervelocity-impact induced ejecta particles

We investigate the patterns observed in ejecta curtain induced by hypervelocity impact (2-6 km/s) with a variety of the size and shape of target particles. We characterize the patterns by an angle, defined as the ratio of the characteristic length of the pattern obtained by Fourier transformation to the distance from the impact point. This angle is found to be almost the same as that obtained by the reanalysis of the patterns in the previous study at lower impact velocities (Kadono et al., 2015, Icarus 250, 215-221), which are consistent with lunar crater-ray systems. Assuming that the pattern is formed by mutual collision of particles with fluctuation velocity in excavation flow, we evaluate an angle at which the pattern growth stops and show that this angle is the same in the order of magnitude as the ratio of the fluctuation velocity and the radial velocity. This relation is confirmed in the results of experiments and numerical simulations. Finally, we discuss the dependence of the patterns on impact conditions. The experiments show no dependence of the angle on impact velocity. This indicates that the ratio between the fluctuation and radial velocity components in excavation flow does not depend on impact velocity. Moreover, the independences on particle size and particle shape suggest that the angle characterizing the structure of the patterns does not depend on cohesive force. Since cohesive forces should be related with elastic properties of particles, the structure does not depend on elastic properties, though inelastic collisions are important for the persistence and contrast of the patterns.

astro-ph.EP

Pattern of Impact-Induced Ejecta from Granular Targets with Large Inclusions

We performed impact experiments to observe patterns in an ejecta curtain with targets consisting of small sand particles and large inclusions comparable to or smaller than the size of the projectiles. The spatial intensity distributions in the ejecta at early stages of crater formation depend on the size of the inclusions. Our numerical simulations of radially spreading particles with different sizes support this result. Based on the results, we proposed a procedure for evaluating the subsurface structures of celestial bodies from the images of ejecta curtains obtained from space-impact experiments.

astro-ph.EP

Increase in cratering efficiency with target curvature in strength-controlled craters

Impact-cratering processes on small bodies are thought to be mainly controlled by the local material strength because of their low surface gravity, and craters that are as large as the parent bodies should be affected by the target curvature. Although cratering processes on planar surfaces in the strength-controlled regime have been studied extensively, the mechanism by which target curvature affects the cratering processes remains unclear. Herein, we report on a series of impact experiments that used spherical targets with various diameters. The resultant craters consisted of a deep circular pit and an irregular-shaped spall region around the pit, which is consistent with the features reported in a number of previous cratering experiments on planar surfaces. However, the volume and radius of the craters increased with the normalized curvature. The results indicate that the increase in the spall-region volume and radius mainly contributes to the increase in the whole crater volume and radius, although the volume, depth, and radius of pits remain constant with curvature. The results of our model indicate that the geometric effect due to curvature (i.e., whereby the distance from the equivalent center to the target free surface is shorter for higher curvature values) contributes to increases in the cratering efficiency. Our results suggest that the impactors that produce the largest craters (basins) on some asteroids are thus smaller than what is estimated by current scaling laws, which do not take into account the curvature effects.

astro-ph.EP

Recovery of entire shocked samples in a range of pressure from ~100 GPa to Hugoniot Elastic Limit

We carried out laser shock experiments and wholly recovered shocked olivine and quartz samples. We investigated the petrographic features based on optical micrographs of sliced samples and found that each recovered sample comprises three regions, I (optically dark), II (opaque) and III (transparent). Scanning electron microscopy combined with electron back-scattered diffraction shows that there are no crystal features in the region I; the materials in the region I have once melted. Moreover, numerical calculations performed with the iSALE shock physics code suggest that the boundary between regions II and III corresponds to Hugoniot Elastic Limit (HEL). Thus, we succeeded in the recovery of the entire shocked samples experienced over a wide range of pressures from HEL (~ 10 GPa) to melting pressure (~ 100 GPa) in a hierarchical order.

astro-ph.EP