Estimation and Control of Tensegrity Manipulator Kinematics based on Strut Inclination Angles
Unlike conventional rigid-link robots defined by discrete joints, continuum robots pose a fundamental challenge for expressing their complex continuous bending configurations for closed-loop control. Several modelling approaches have been proposed for conventional continuum robots, but tensegrity-based continuum robots remain largely open. Moreover, many of these approaches assume a continuous elastic backbone and are therefore not directly applicable to tensegrity manipulators, whose bodies are networks of rigid struts and tensioned cables. This work presents a reduced-order model for shape and posture control of a tensegrity-based continuum manipulator. The manipulator is modelled as a serially connected parallel-link mechanism. The proposed method is formulated as an optimization problem that uses geometric constraints of the tensegrity structure together with information from the Inertial Measurement Unit (IMU) sensors embedded in the strut elements. To the best of our knowledge, this work presents the first experimental demonstration of a real-time IMU-based shape estimation method on a full-scale tensegrity manipulator and demonstrates posture control using a simple Proportional-Integral (PI) controller. The results show that the proposed method can estimate the shape of both single-module tensegrity structures and multi-module tensegrity manipulators from arbitrary static configurations and achieve desired postures.