arXiv subjects

U. Greuter

Publications and source records attributed to U. Greuter.

6 recordsLinked to original sources

arXiv2016

A 16-ch module for thermal neutron detection using ZnS:${}^6$LiF scintillator with embedded WLS fibers coupled to SiPMs and its dedicated readout electronics

A scalable 16-ch thermal neutron detection system has been developed in the framework of the upgrade of a neutron diffractometer. The detector is based on ZnS:${}^6$LiF scintillator with embedded WLS fibers which are read out with SiPMs. In this paper, we present the 16-ch module, the dedicated readout electronics, a direct comparison between the performance of the diffractometer obtained with the current ${}^3$He detector and with the 16-ch detection module, and the channel-to-channel uniformity.

physics.ins-det↗

arXiv2015

Digital signal processing for a thermal neutron detector using ZnS(Ag):6LiF scintillating layers read out with WLS fibers and SiPMs

We present a digital signal processing system based on a photon counting approach which we developed for a thermal neutron detector consisting of ZnS(Ag):6LiF scintillating layers read out with WLS fibers and SiPMs. Three digital filters have been evaluated: a moving sum, a moving sum after differentiation and a digital CR-RC^4 filter. The performances of the detector with these filters are presented. A full analog signal processing using a CR-RC^4 filter has been emulated digitally. The detector performance obtained with this analog approach is compared with the one obtained with the best performing digital approach.

physics.ins-det↗

arXiv2014

A SiPM-based ZnS:$^6$LiF scintillation neutron detector

In the work presented here we built and evaluated a single-channel neutron detection unit consisting of a ZnS:$^6$LiF scintillator with embedded WLS fibers readout by a SiPM. The unit has a sensitive volume of 2.4 x 2.8 x 50 mm$^3$; 12 WLS fibers of diameter 0.25 mm are uniformly distributed over this volume and are coupled to a 1 x 1 mm$^2$ active area SiPM. We report the following performance parameters: neutron detection efficiency $\sim 65\,$% at $1.2\,Å$, background count rate $< 10^{-3}$ Hz, gamma-sensitivity with $^{60}$Co source $< 10^{-6}$, dead time $\sim 20\,μ$s, multi-count ratio $< 1\,$%. All these parameters were achieved up to the SiPM dark count rate of $\sim 2\,$MHz. We consider such detection unit as an elementary building block for realization of one-dimensional multichannel detectors for applications in the neutron scattering experimental technique. The dimensions of the unit and the number of embedded fibers can be varied to meet the specific application requirements. The upper limit of $\sim 2\,$MHz on the SiPM dark count rate allows to use SiPMs with larger active areas if required.

physics.ins-det↗

arXiv2014

Evaluation of two thermal neutron detection units consisting of ZnS/${}^6$LiF scintillating layers with embedded WLS fibers read out with a SiPM

Two single channel detection units for thermal neutron detection are investigated in a neutron beam. They consist of two ZnS/${}^6$LiF scintillating layers sandwiching an array of WLS fibers. The pattern of this units can be repeated laterally and vertically in order to build up a one dimensional position sensitive multi-channel detector with the needed sensitive surface and with the required neutron absorption probability. The originality of this work arises from the fact that the WLS fibers are read out with SiPMs instead of the traditionally used PMTs or MaPMTs. The signal processing system is based on a photon counting approach. For SiPMs with a dark count rate as high as 0.7 MHz, a trigger efficiency of 80% is achieved together with a system background rate lower than ${10}^{-3}$ Hz and a dead time of 30 $μ$s. No change of performance is observed for neutron count rates of up to 3.6 kHz.

physics.ins-det↗

arXiv2014

Use of Silicon Photomultipliers in ZnS:6LiF scintillation neutron detectors: signal extraction in presence of high dark count rates

We report on the possibility of using Silicon Photomultipliers (SiPMs) to detect the scintillation light from neutron conversion in ZnS:6LiF scintillators. The light is collected by wavelength-shifting fibers embedded into the scintillator. The difficulty of extracting neutron signals in the presence of high dark count rates of the SiPMs is addressed by applying a dedicated processing algorithm to analyze the temporal distribution of the SiPM pulses. With a single-channel prototype detection unit we demonstrate a very good neutron signal extraction at SiPM dark count rates of about 1 MHz.

physics.ins-det↗

arXiv2012

The 10 Tesla muSR instrument: detector solutions

Solutions to the detector system of the High-Field muSR instrument at the Paul Scherrer Institut (PSI) in Switzerland are presented. The strict technical requirements are fulfilled through the application of Geiger-mode Avalanche Photodiodes.

physics.ins-det↗