arXiv subjects

U. Huebner

Publications and source records attributed to U. Huebner.

9 recordsLinked to original sources

arXiv2014

Broadband Sample Holder for Microwave Spectroscopy of Superconducting Qubits

We present a practical design and implementation of a broadband sample holder suitable for microwave experiments with superconducting integrated circuits at millikelvin temperatures. Proposed design can be easily integrated in standard dilution cryostats, has flat pass band response in a frequency range from 0 to 32 GHz, allowing the RF testing of the samples with substrate size up to 4x4 mm. The parasitic higher modes interference in the holder structure is analyzed and prevented via design considerations. The developed setup can be used for characterization of superconducting parametric amplifiers, bolometers and qubits. We tested the designed sample holder by characterizing of a superconducting flux qubit at 20 mK temperature.

cond-mat.supr-con↗

arXiv2011

Spectroscopy of a Qubit Array via a Single Transmission Line

Frequency-selective readout for superconducting qubits opens the way towards scaling qubit circuits up without increasing the number of measurement lines. Here we demonstrate the readout of an array of 7 flux qubits located on the same chip. Each qubit is placed near an individual lambda/4 resonator which, in turn, is coupled to a common microwave transmission line. We performed spectroscopy of all qubits and determined their parameters in a single measurement run.

cond-mat.supr-con↗

arXiv2009

Doubly resonant optical nanoantenna arrays for polarization resolved measurements of surface-enhanced Raman scattering

We report that rhomb-shaped metal nanoantenna arrays support multiple plasmonic resonances, making them favorable bio-sensing substrates. Besides the two localized plasmonic dipole modes associated with the two principle axes of the rhombi, the sample supports an additional grating-induced surface plasmon polariton resonance. The plasmonic properties of all modes are carefully studied by far-field measurements together with numerical and analytical calculations. The sample is then applied to surface-enhanced Raman scattering measurements. It is shown to be highly efficient since two plasmonic resonances of the structure were simultaneously tuned to coincide with the excitation and the emission wave- length in the SERS experiment. The analysis is completed by measuring the impact of the polarization angle on the SERS signal.

physics.optics↗

arXiv2007

Controllable coupling of superconducting flux qubits

We have realized controllable coupling between two three-junction flux qubits by inserting an additional coupler loop between them, containing three Josephson junctions. Two of these are shared with the qubit loops, providing strong qubit--coupler interaction. The third junction gives the coupler a nontrivial current--flux relation; its derivative (i.e., the susceptibility) determines the coupling strength J, which thus is tunable in situ via the coupler's flux bias. In the qubit regime, J was varied from ~45 (antiferromagnetic) to ~ -55 mK (ferromagnetic); in particular, J vanishes for an intermediate coupler bias. Measurements on a second sample illuminate the relation between two-qubit tunable coupling and three-qubit behavior.

cond-mat.supr-con↗

arXiv2007

Adiabatic quantum computation with flux qubits, first experimental results

Controllable adiabatic evolution of a multi-qubit system can be used for adiabatic quantum computation (AQC). This evolution ends at a configuration where the Hamiltonian of the system encodes the solution of the problem to be solved. As a first steps towards realization of AQC we have investigated two, three and four flux qubit systems. These systems were characterized by making use of a radio-frequency method. We designed two-qubit systems with coupling energies up to several kelvins. For the three-flux-qubit systems we determined the complete ground-state flux diagram in the three dimensional flux space around the qubits common degeneracy point. We show that the system`s Hamiltonian can be completely reconstructed from our measurements. Our concept for the implementation of AQC, by making use of flux qubits, is discussed.

cond-mat.supr-con↗

arXiv2006

Measurement of the ground-state flux diagram of three coupled qubits as a first step towards the demonstration of adiabatic quantum computation

The ground state susceptibility of a system consisting of three flux-qubits was measured in the complete three dimensional flux space around the common degeneracy point of the qubits. The system's Hamiltonian could be completely reconstructed from measurements made far away from the common degeneracy point. The subsequent measurements made around this point show complete agreement with the theoretical predictions which follow from this Hamiltonian. The ground state anti-crossings of the system could be read-out directly from these measurements. This allows one to determine the ground-state flux diagram, which provides the solution for the non-polynomial optimization problem MAXCUT encoded in the Hamiltonian of the three-flux-qubit system. Our results show that adiabatic quantum computation can be demonstrated with this system provided that the energy gap and/or the speed of the read-out is increased.

cond-mat.supr-con↗

arXiv2006

Four-qubit device with mixed couplings

We present the first experimental results on a device with more than two superconducting qubits. The circuit consists of four three-junction flux qubits, with simultaneous ferro- and antiferromagnetic coupling implemented using shared Josephson junctions. Its response, which is dominated by the ground state, is characterized using low-frequency impedance measurement with a superconducting tank circuit coupled to the qubits. The results are found to be in excellent agreement with the quantum-mechanical predictions.

cond-mat.supr-con↗

arXiv2004

Reading-out the state inductively and microwave spectroscopy of an interferometer-type charge qubit

We implemented experimentally an interferometer-type charge qubit consisting of a single-Cooper-pair transistor closed by a superconducting loop that is in flip-chip configuration inductively coupled to a radio frequency tank circuit. The tank permits to readout the qubit state, acting as inductance measuring apparatus. By applying continuous microwave power to the quantum device, we observed inductance alterations caused by redistributions of the energy level populations. From the measured data, we extracted the energy gap between ground and upper levels as a function of the transistor quasicharge as well as the Josephson phase across both junctions.

cond-mat.mes-hall↗

arXiv2004

Low-frequency measurement of the tunneling amplitude in a flux qubit

We have observed signatures of resonant tunneling in an Al three-junction qubit, inductively coupled to a Nb LC tank circuit. The resonant properties of the tank oscillator are sensitive to the effective susceptibility (or inductance) of the qubit, which changes drastically as its flux states pass through degeneracy. The tunneling amplitude is estimated from the data. We find good agreement with the theoretical predictions in the regime of their validity.

cond-mat.supr-con↗