arXiv subjects

V. Sushkov

Publications and source records attributed to V. Sushkov.

2 recordsLinked to original sources

arXiv2001

Lock-in detection using a cryogenic low noise looped current preamplifier for the readout of resistive bolometers

We implemented a low noise current preamplifier for the readout of resistive bolometers. We tested the apparatus on thermometer resistances ranging from 10 Ohm to 500 Mohm. The use of current preamplifier overcomes constraints introduced by the readout time constant due to the thermometer resistance and the input capacitance. Using cold JFETs, this preamplifier board is shown to have very low noise: the Johnson noise of the source resistor (1 fA/Hz1/2) dominated in our noise measurements. We also implemented a lock-in chain using this preamplifier. Because of fast risetime, compensation of the phase shift may be unnecessary. If implemented, no tuning is necessary when the sensor impedance changes. Transients are very short, and thus low-passing or sampling of the signal is simplified. In case of spurious noise, the modulation frequency can be chosen in a much wider frequency range, without requiring a new calibration of the apparatus.

physics.ins-det↗

arXiv1999

Low noise cryogenic electronics: preamplifier configurations with feedback on the bolometer

We have developed preamplifier configurations used to readout resistive bolometers such as those based on Neutron Transmuted Doped Germanium thermometers (so called NTD Ge thermometers)[1] or NbSi thin film thermometers [2, 3]. We introduce the impedance regulating preamplifier configuration. This configuration, is compared to previously proposed readout configurations with feedback on the bolometer [4]. It is shown that the impedance regulating preamplifier achieves Extreme Electrothermal Feedback without using transition edge thermometer and SQUID readout. Thus the detector and readout electronics are straightforwardly calibrated and can handle much larger event rates. Looped configurations simplify the design and improve performance of detection such as bandwidth. Finally, we analyse the impedance regulating amplifier noise contributions, with JFETs as front end device, relative to other configurations.

astro-ph↗