Searcharxiv⌕ Search

arXiv subjects

Verónica Rodríguez Tribaldos

Publications and source records attributed to Verónica Rodríguez Tribaldos.

3 recordsLinked to original sources

Cemented fibers as a testbed for distributed acoustic sensing (DAS)

A rigid connection between the optical fiber and the rock makes amplitudes of 'fiber strain' measured with Distributed Acoustic Sensing (DAS) equal to 'rock strain'. We demonstrate this by running four interrogator units (IU) on a DAS testbed with single-fiber patch cables being cemented into a groove in the concrete floor of Black Forest Observatory (BFO). The recorded signals are compared with the recordings of a calibrated Invar wire strain meter array that has been continuously in operation for the last decades. This way we measure 'strain transfer rate' (ratio of 'fiber strain' over 'rock strain') at frequencies below 0.2 Hz. Waveform similarity for strong earthquake signals is high with typical values of the normalized correlation coefficient greater than 0.95. The 'strain transfer rate' is close to 1 for all four IUs, while it was significantly less in a previous study with DAS cables unreeled on the floor and loaded down by sand and sandbags, only. At frequencies up to 14 Hz we make an intercomparison of IUs, showing no significant variation with frequency. The scatter of 'strain transfer rate' in between channels which are spatially near to each other in the same fiber route is about $\pm$10 % in most cases. The variation of median values in between different IUs and earthquakes is less than 5 %. By subtracting the common mode laser noise, which is coherent along the fiber route, we lower the background signal level to an rms-amplitude of 100 pstrain at 0.1 Hz and 5 pstrain at 1 Hz in a bandwidth of 1/6 decade for the best cases. This allows the detection of the marine microseisms during times of moderate amplitude level.

physics.geo-ph↗

Deep Learning for Surface Wave Identification in Distributed Acoustic Sensing Data

Moving loads such as cars and trains are very useful sources of seismic waves, which can be analyzed to retrieve information on the seismic velocity of subsurface materials using the techniques of ambient noise seismology. This information is valuable for a variety of applications such as geotechnical characterization of the near-surface, seismic hazard evaluation, and groundwater monitoring. However, for such processes to converge quickly, data segments with appropriate noise energy should be selected. Distributed Acoustic Sensing (DAS) is a novel sensing technique that enables acquisition of these data at very high spatial and temporal resolution for tens of kilometers. One major challenge when utilizing the DAS technology is the large volume of data that is produced, thereby presenting a significant Big Data challenge to find regions of useful energy. In this work, we present a highly scalable and efficient approach to process real, complex DAS data by integrating physics knowledge acquired during a data exploration phase followed by deep supervised learning to identify "useful" coherent surface waves generated by anthropogenic activity, a class of seismic waves that is abundant on these recordings and is useful for geophysical imaging. Data exploration and training were done on 130~Gigabytes (GB) of DAS measurements. Using parallel computing, we were able to do inference on an additional 170~GB of data (or the equivalent of 10 days' worth of recordings) in less than 30 minutes. Our method provides interpretable patterns describing the interaction of ground-based human activities with the buried sensors.

eess.SP↗

Deep Learning on Real Geophysical Data: A Case Study for Distributed Acoustic Sensing Research

Deep Learning approaches for real, large, and complex scientific data sets can be very challenging to design. In this work, we present a complete search for a finely-tuned and efficiently scaled deep learning classifier to identify usable energy from seismic data acquired using Distributed Acoustic Sensing (DAS). While using only a subset of labeled images during training, we were able to identify suitable models that can be accurately generalized to unknown signal patterns. We show that by using 16 times more GPUs, we can increase the training speed by more than two orders of magnitude on a 50,000-image data set.

cs.LG↗