Searcharxiv⌕ Search

arXiv subjects

Vicente A. de Sousa Jr.

Publications and source records attributed to Vicente A. de Sousa Jr..

4 recordsLinked to original sources

A Multiarmed Bandit Approach for LTE-U/Wi-Fi Coexistence in a Multicell Scenario

Recent studies and literature reviews have shown promising results for 3GPP system solutions in unlicensed bands when coexisting with Wi-Fi, either by using the duty cycle (DC) approach or licensed-assisted access (LAA). However, it is widely known that general performance in these coexistence scenarios is dependent on traffic and how the duty cycle is adjusted. Most DC solutions configure their parameters statically, which can result in performance losses when the scenario experiences changes on the offered data. In our previous works, we demonstrated that reinforcement learning (RL) techniques can be used to adjust DC parameters. We showed that a Q-learning (QL) solution that adapts the LTE DC ratio to the transmitted data rate can maximize the Wi-Fi/LTE-Unlicensed (LTE-U) aggregated throughput. In this paper, we extend our previous solution by implementing a simpler and more efficient algorithm based on multiarmed bandit (MAB) theory. We evaluate its performance and compare it with the previous one in different traffic scenarios. The results demonstrate that our new solution offers improved balance in throughput, providing similar results for LTE and Wi-Fi, while still showing a substantial system gain. Moreover, in one of the scenarios, our solution outperforms the previous approach by 6% in system throughput. In terms of user throughput, it achieves more than 100% gain for the users at the 10th percentile of performance, while the old solution only achieves a 10% gain.

cs.NI↗

Analysis of Measurements in a Microwave Oven with High Level of Non-Ionizing Radiation (NIR) Before and After Repair

Non-ionizing radiation is the subject of several applications, such as the microwave oven, which is very popular. Its use is characterized by direct user operation and reduced distances between users and the NIR source. Therefore, the level of human exposure in this scenario deserves attention as it is a potential cause of biological effects. In this sense, this paper presents the measurement of a microwave oven with a high level of NIR (above the limit defined by the standard) before and after two types of suggested repairs: the use of epoxy putty (Repair 1) and the replacement of the external surface of the oven (Repair 2). The definitions of measurement methodology, based on FDA and INMETRO standards, are presented and discussed. Finally, we describe an analysis of the efficiency of these repair methods aiming at the safety operation.

cs.NI↗

Microcell Hot Spot and Smart Antennas Evaluation in WCDMA Macrocell System

The purpose of this contribution is to analyze a hierarchical cell structure with a hot spot embedded in a WCDMA macrocellular system. Particular attention is paid to the impact of introducing smart antennas in this context. A system-level simulation approach is employed, in which we consider two main solutions to address hot-spot traffic: the placement of a microcell antenna or the adoption of smart antenna technology at the macrocell. Relative gains in signal-to-interference ratio (SIR) are then evaluated. Distinct scenarios are defined based on the proportion of users of different service classes. An evaluation of which solution is best suited to each scenario is then conducted.

cs.NI↗

Data-Driven Case Study of gNB Placement Optimization in a Private Indoor 5G Testbed

Accurate radio planning is a fundamental requirement for the deployment of wireless networks in indoor environments, where signal propagation is strongly affected by walls, partitions, and other structural obstacles. Despite the availability of standardized propagation models, their ability to represent the characteristics of specific deployment scenarios is often limited, motivating the use of measurement-driven approaches. In this context, this paper presents a data-driven case study of next generation NodeB (gNB) placement optimization in an office using measurements collected from an experimental fifth generation (5G) testbed. A propagation model is trained from reference signal received power (RSRP) measurements using distance and wall count as input features and integrated with a combinatorial search framework. The proposed workflow is used to evaluate alternative deployment strategies under different optimization criteria. Results indicate that satisfactory indoor coverage and improved cell-edge conditions can be achieved with a small number of gNBs.

cs.NI↗