Viet Dung Pham | Searcharxiv

arXiv2024

Investigation of reflection-based measurements of microwave kinetic inductance detectors in the optical bands

In this paper, we investigate the single photon response from the reflection of the Microwave Kinetic Inductance Detector (MKID) array. Reflection measurements are carried out using two configurations: one is measured simultaneously with the transmission, and the other is obtained with a single-ended MKID array terminated with an open load. Compared with the transmission, reflection measurements significantly reduce the readout noise of the single-ended MKID array. This is also reflected in the improvement of the median energy resolving power by around 20%-30% under pulsed photon illumination at $λ= 405$~nm, mainly due to an increase in the size of the resonance circle on the IQ plane. This method has the potential to be used to read out large MKID arrays.

astro-ph.IM↗

arXiv2023

Development of MKIDs in the Optical and Near-infrared Bands for SPIAKID

SpectroPhotometric Imaging in Astronomy with Kinetic Inductance Detectors (SPIAKID) aims at designing, building, and deploying on the sky a spectrophotometric imager based on microwave kinetic inductance detectors (MKIDs) in the optical and near-infrared bands. MKIDs show a fast response and the ability to resolve photon energy compared to the conventional Charge-coupled Devices (CCDs). In this paper, we present the design and simulation of the MKID arrays for SPIAKID. The detectors consist of four arrays with each array of 20,000 lumped-element pixels, and each array will be read with 10 readout lines. %The array is designed to have resonances between 4-8GHz with a frequency spacing of 2 MHz and a coupling quality factor (Qc) of about 50000. The meander material of the resonators is trilayer TiN/Ti/TiN to have better uniformity of the critical temperature across the array. We also present the measurement result for a test array with $30\times30$ pixels which is a subset of the designed 2000-pixel array to verify the design and fabrication. The current measured best energy resolving power $R = E/ΔE$ is 2.4 at $λ= 405~$nm and the current medium R is around 1.7. We have also observed the response of the TiN/Ti/TiN is much smaller than expected.

astro-ph.IM↗