arXiv subjects

Vivek Tallavajhula

Publications and source records attributed to Vivek Tallavajhula.

3 recordsLinked to original sources

arXiv2026

Thin Film AlN Microbolometer for Very Long-Wave Infrared Detection

We demonstrate a suspended thin-film aluminum nitride (AlN) microbolometer for narrowband very long-wave infrared detection. The device uses a 100-nm-thick AlN membrane suspended above a Pt back reflector by a 1-um air gap. Resonant absorption is set by the AlN transverse optical phonon near 15.4 um and is strengthened by suspension above the reflector. A periodic perforation pattern reduces membrane thermal mass and enhances absorption without further thinning the film. DC resistance measurements under tunable infrared illumination verify bolometric operation, and the measured spectral response follows the absorption profile expected from spectroscopic measurement of passive devices. Narrowband response is observed in the 14--18 um range, with peak responsivity of 920.8 ppm/mW at 15.48 um. This platform can enable compact wavelength-selective thermal detectors for multispectral imaging, on-chip infrared spectroscopy, and chemical sensing.

physics.optics↗

arXiv2025

Thermal Endurance of Suspended Thin-Film Lithium Niobate up to 800 °C

The need for high-temperature piezoelectric microelectromechanical systems (MEMS) requires pushing piezoelectric platforms to their thermal limits. In harsh thermal environments, piezoelectric MEMS devices are expected to sustain severe damage because of material degradation and coefficient of thermal expansion (CTE) mismatches between the functional layers and the carrier wafer. This paper investigates the thermal endurance of the suspended thin-film lithium niobate (LN) platform by observing the structural integrity and performance of acoustic Lamb wave resonators after annealing rounds at increasing temperatures, with a focus on temperatures between 550 $^\circ$C and 800 $^\circ$C, with 50 $^\circ$C temperature increments. Fundamental symmetric (S0) mode acoustic resonators are fabricated on 600 nm stoichiometric LN (sLN) with 40 nm thick platinum top electrodes and a thin titanium adhesion layer. After each annealing round, changes in the devices' resonant frequency and quality factor (\emph{Q}) are quantitatively studied. The devices and material stack are further analyzed with resistivity structures, optical microscope images, and X-ray diffraction (XRD) measurements. The results provide valuable insights into the design and material selection necessary to optimize the suspended thin-film LN platform for high temperatures. Understanding the thermal limit of the platform enables its use for sensors, actuators, resonators, and potentially other thin-film LN microsystems, e.g, photonics, electro-optical, and acousto-optical systems in harsh thermal environments.

physics.app-ph↗

arXiv2025

Thermal Resilience of Suspended Thin-Film Lithium Niobate Acoustic Resonators up to 550 °C

This paper reports a suspended thin-film lithium niobate (LN) piezoelectric resonator platform surviving high annealing temperatures of 550 °C, among the highest temperature at which the thermal resilience of suspended LN resonators is studied. Acoustic resonators are built on 600 nm thick transferred stoichiometric LN on silicon wafers with 40 nm thick platinum (Pt) electrodes, selected for high temperature operation. The fabricated resonators are first annealed at 250 °C, and the anneal temperature is incrementally increased to 550 °C after 7 rounds of annealing. The annealing is shown to upshift resonant frequencies and can increase the quality factor (Q), within a temperature range, before it gradually damages the device performance. This work presents promising results for using the suspended thin-film LN platform for resonators, sensors, and transducers in harsh thermal environments.

physics.app-ph↗