arXiv subjects

Vladimir Chuvil'deev

Publications and source records attributed to Vladimir Chuvil'deev.

3 recordsLinked to original sources

arXiv2026

Analysis of contributions of plastic deformation and intergranular corrosion to corrosion-fatigue failure of Al-Mg alloys

The article presents the results of corrosion-fatigue tests of industrial Al-Mg alloys were conducted in air and in a 3% NaCl aqueous solution. Fatigue curves can be characterized using the Basquin equation and the plastic deformation model at the crack tip. It has been demonstrated that the primary contributions to corrosion-fatigue failure in the Al-Mg alloys at low stresses are made by the process of pitting and intergranular corrosion, and by the plastic deformation at high stresses.

cond-mat.mtrl-sci↗

arXiv2024

Spark Plasma Sintering for high-speed diffusion welding of the ultrafine grained near-a Ti-5Al-2V alloy with high strength and corrosion resistance for nuclear engineering

The paper demonstrates the prospects of Spark Plasma Sintering (SPS) for the high-speed diffusion welding of the high-strength ultrafine-grained (UFG) near-a Ti-5Al-2V alloy. The effect of increased diffusion welding intensity in the UFG Ti alloys is discussed also. The welds of the UFG near-a-Ti-5Al-2V alloy obtained by SPS are featured by high density, strength, and corrosion resistance. The rate of weld sealing in the UFG alloys has been shown to depend on the heating rate non-monotonously (with a pronounced maximum). At the stage of continuous heating and isothermic holding, the kinetics of the weld sealing was found to be determined by the exponential creep rate, the intensity of which in the coarse-grained (CG) alloys is limited by the diffusion rate in the crystal lattice whereas in the UFG alloys it is limited by the grain boundary diffusion rate.

cond-mat.mtrl-sci↗

arXiv2024

Investigation of Microstructure and Corrosion Resistance of Ti-Al-V Titanium Alloys Obtained by Spark Plasma Sintering

The research results of the microstructure and corrosion resistance of Ti and Ti-Al-V Russian industrial titanium alloys obtained by spark plasma sintering (SPS) are described. Investigations of the microstructure, phase composition, hardness, tensile strength, electrochemical corrosion resistance and hot salt corrosion of Ti-Al-V titanium alloy specimens were carried out. It was shown that the alloy specimens have a uniform highly dense microstructure and high hardness values. The studied alloys also have high resistance to electrochemical corrosion during tests in acidic aqueous solution causing the intergranular corrosion as well as high resistance to the hot salt corrosion. The assumption that the high hardness of the alloys as well as the differences in the corrosion resistance of the central and lateral parts of the specimens are due to the diffusion of carbon from the graphite mold into the specimen surface was suggested.

physics.app-ph↗