arXiv subjects

Volodymyr Yefremenko

Publications and source records attributed to Volodymyr Yefremenko.

6 recordsLinked to original sources

arXiv2026

Development Status of the KIPM Detector Consortium

A Kinetic Inductance Phonon-Mediated Detector is a calorimeter that uses kinetic inductance detectors to read out phonon signals from the device substrate. We have established a consortium comprising university and national lab groups dedicated to advancing the state of the art in these detectors, with the ultimate goal of designing a detector sub-eV threshold on energy deposited in the substrate, enabling searches for both light dark matter and low-energy neutrino interactions. This consortium brings together experts in kinetic inductance detector design, phonon and quasiparticle dynamics, and noise modeling, along with specialized fabrication facilities, test platforms, and unique calibration capabilities. Recently, our consortium has demonstrated a resolution on energy absorbed by the sensor of 2.1 eV, the current record for such devices. The current focus of the consortium is modeling and improving the phonon collection efficiency and implementing low-$\boldsymbol{T_c}$ superconductors, both of which serve to improve the overall energy resolution and threshold of the detectors.

physics.ins-det↗

arXiv2025

Room temperature reactive sputtering deposition of titanium nitride with high sheet kinetic inductance

Superconducting thin films with high intrinsic kinetic inductance $L_{k}$ are important for high-sensitivity detectors, enabling strong coupling in hybrid quantum systems, and enhancing nonlinearities in quantum devices. We report the room-temperature reactive sputtering of titanium nitride thin films with a critical temperature $T_{c}$ of \SI{3.8}{K} and a thickness of \SI{27}{nm}. Fabricated into resonators, these films exhibit a sheet kinetic inductance $L_{k, \square}$ of 394~$\textrm{pH}/\square$, as inferred from resonant frequency measurements. %from this film and measure quality factors of $4\times 10^{4}$; these quality factors are likely limited by the low resistivity wafer. X-ray diffraction analysis confirms the formation of stoichiometric TiN, with no residual unreacted titanium. The films also demonstrate a characteristic sheet resistivity of 475~$Ω/\square$, yielding an impedance an order of magnitude higher than conventional 50~$Ω$ resonators. This property could enhance microwave single\textendash photon coupling strength by an order of magnitude, offering transformative potential for hybrid quantum systems and quantum sensing. Furthermore, the high $L_{k}$ enables Kerr nonlinearities comparable to state\textendash of\textendash the\textendash art quantum devices. Combined with its relatively high $T_{c}$, this thin film presents a promising platform for superconducting devices, including amplifiers and qubits operating at higher temperatures.

cond-mat.supr-con↗

arXiv2024

A Stress Induced Source of Phonon Bursts and Quasiparticle Poisoning

The performance of superconducting qubits is degraded by a poorly characterized set of energy sources breaking the Cooper pairs responsible for superconductivity, creating a condition often called ``quasiparticle poisoning". Both superconducting qubits and low threshold dark matter calorimeters have observed excess bursts of quasiparticles or phonons that decrease in rate with time. Here, we show that a silicon crystal glued to its holder exhibits a rate of low-energy phonon events that is more than two orders of magnitude larger than in a functionally identical crystal suspended from its holder in a low-stress state. The excess phonon event rate in the glued crystal decreases with time since cooldown, consistent with a source of phonon bursts which contributes to quasiparticle poisoning in quantum circuits and the low-energy events observed in cryogenic calorimeters. We argue that relaxation of thermally induced stress between the glue and crystal is the source of these events.

physics.ins-det↗

arXiv2023

Flux coupled tunable superconducting resonator

We present a design and implementation of frequency-tunable superconducting resonator. The resonance frequency tunability is achieved by flux-coupling a superconducting LC-loop to a current-biased feedline; the resulting screening current leads to a change of the kinetic inductance and shift in the resonance frequency. The thin film aluminum resonator consists of an interdigitated capacitor and thin line inductors forming a closed superconducting loop. The magnetic flux from the nearby current feedline induces Meissner shielding currents in the resonator loop leading to change in the kinetic part of the total inductance of the resonator. We demonstarte continuous frequency tuning within 160 MHz around the resonant frequency of 2.7 GHz. We show that: (1) frequency upconversion is achieved when kHz AC modulation signal is superimposed onto the DC bias resulting in sidebands to the resonator tone; (2) three-wave mixing is attained by parametrically pumping the nonlinear kinetic inductance using a strong RF pump signal in the feedline. The simple architecture is amenable to large array multiplexing and on-chip integration with other circuit components. The concept could be applied in flux magnetometers, upconverters, and parametric amplifiers operating above 4 Kelvin cryogenic temperatures when alternative high critical temperature material with high kinetic inductance is used.

cond-mat.supr-con↗

arXiv2018

Room temperature deposition of superconducting Niobium Nitride films by ion beam assisted sputtering

We use room temperature ion beam assisted sputtering (IBAS) to deposit niobium nitride thin films. Electrical and structural characterizations were performed by electric transport and magnetization measurements at variable temperatures, X-ray diffraction and atomic force microscopy. Compared to reactive sputtering of NbN, films sputtered in presence of an ion beam show remarkable increase in the superconducting critical temperature T$_{\rm{c}}$, while exhibiting lower sensitivity to nitrogen concentration during deposition. Thickness dependence of the superconducting critical temperature is comparable to films prepared by conventional methods at high substrate temperatures and is consistent with behavior driven by quantum size effects or weak localization.

cond-mat.supr-con↗

arXiv2018

Optical Characterization of the SPT-3G Focal Plane

The third-generation South Pole Telescope camera is designed to measure the cosmic microwave background across three frequency bands (95, 150 and 220 GHz) with ~16,000 transition-edge sensor (TES) bolometers. Each multichroic pixel on a detector wafer has a broadband sinuous antenna that couples power to six TESs, one for each of the three observing bands and both polarization directions, via lumped element filters. Ten detector wafers populate the focal plane, which is coupled to the sky via a large-aperture optical system. Here we present the frequency band characterization with Fourier transform spectroscopy, measurements of optical time constants, beam properties, and optical and polarization efficiencies of the focal plane. The detectors have frequency bands consistent with our simulations, and have high average optical efficiency which is 86%, 77% and 66% for the 95, 150 and 220 GHz detectors. The time constants of the detectors are mostly between 0.5 ms and 5 ms. The beam is round with the correct size, and the polarization efficiency is more than 90% for most of the bolometers

astro-ph.IM↗