arXiv subjects

W. Clay

Publications and source records attributed to W. Clay.

8 recordsLinked to original sources

arXiv2024

Modeling the refractive index profile n(z) of polar ice for ultra-high energy neutrino experiments

We have developed an in-situ index of refraction profile n(z) for cold polar ice, using the transit times of radio signals broadcast from an englacial transmitter to 2-5 km distant radio-frequency receivers, deployed at depths up to 200 m. For propagation through a non-uniform medium, Maxwell's equations generally admit two ray propagation solutions from a given transmitter, corresponding to a direct path (D) and a refracted or reflected path (R); the measured D vs. R timing differences (dt(D,R)) are determined by the refractive index profile. We constrain n(z) near South Pole, where the Askaryan Radio Array (ARA) neutrino observatory is located, by simulating D and R ray paths via ray tracing and comparing simulations to measured dt(D,R) values. Using previous ice density data as a proxy for n(z), we demonstrate that our data strongly favors a glaciologically-motivated three-phase densification model rather than a single exponential scale height model. Effective volume simulations for a detector of ARA station antenna depths yield a 14\% increase in neutrino sensitivity over a range of $10^{17} - 10^{21}$ eV using the three-phase model compared to a single exponential.

astro-ph.IM↗

arXiv2023

Calibration and Physics with ARA Station 1: A Unique Askaryan Radio Array Detector

The Askaryan Radio Array Station 1 (A1), the first among five autonomous stations deployed for the ARA experiment at the South Pole, is a unique ultra-high energy neutrino (UHEN) detector based on the Askaryan effect that uses Antarctic ice as the detector medium. Its 16 radio antennas (distributed across 4 strings, each with 2 Vertically Polarized (VPol), 2 Horizontally Polarized (HPol) receivers), and 2 strings of transmitting antennas (calibration pulsers, CPs), each with 1 VPol and 1 HPol channel, are deployed at depths less than 100 m within the shallow firn zone of the 2.8 km thick South Pole (SP) ice. We apply different methods to calibrate its Ice Ray Sampler second generation (IRS2) chip for timing offset and ADC-to-Voltage conversion factors using a known continuous wave input signal to the digitizer, and achieve a precision of sub-nanoseconds. We achieve better calibration for odd, compared to even samples, and also find that the HPols under-perform relative to the VPol channels. Our timing calibrated data is subsequently used to calibrate the ADC-to-Voltage conversion as well as precise antenna locations, as a precursor to vertex reconstruction. The calibrated data will then be analyzed for UHEN signals in the final step of data compression. The ability of A1 to scan the firn region of SP ice sheet will contribute greatly towards a 5-station analysis and will inform the design of the planned IceCube Gen-2 radio array.

astro-ph.IM↗

arXiv2022

A low-threshold ultrahigh-energy neutrino search with the Askaryan Radio Array

In the pursuit of the measurement of the still-elusive ultrahigh-energy (UHE) neutrino flux at energies of order EeV, detectors using the in-ice Askaryan radio technique have increasingly targeted lower trigger thresholds. This has led to improved trigger-level sensitivity to UHE neutrinos. Working with data collected by the Askaryan Radio Array (ARA), we search for neutrino candidates at the lowest threshold achieved to date, leading to improved analysis-level sensitivities. A neutrino search on a data set with 208.7~days of livetime from the reduced-threshold fifth ARA station is performed, achieving a 68\% analysis efficiency over all energies on a simulated mixed-composition neutrino flux with an expected background of $0.10_{-0.04}^{+0.06}$ events passing the analysis. We observe one event passing our analysis and proceed to set a neutrino flux limit using a Feldman-Cousins construction. We show that the improved trigger-level sensitivity can be carried through an analysis, motivating the Phased Array triggering technique for use in future radio-detection experiments. We also include a projection using all available data from this detector. Finally, we find that future analyses will benefit from studies of events near the surface to fully understand the background expected for a large-scale detector.

astro-ph.HE↗

arXiv2021

Triboelectric Backgrounds to radio-based UHE Neutrino Exeperiments

The proposed IceCube-Gen2 (ICG2) seeks to instrument ~500 sq. km of Antarctic ice near the geographic South Pole with radio antennas, in order to observe the highest energy (E>1 EeV) neutrinos in the Universe. To this end, ICG2 will use the impulsive radio-frequency (RF) signal produced by neutrino interactions in polar ice caps. In such experiments, rare single event candidates must be unambiguously separated from background; to date, signal identification strategies primarily reject thermal noise and anthropogenic backgrounds. Here, we consider the possibility that fake neutrino signals may also be naturally generated via the 'triboelectric effect'. This broadly includes any process in which force applied at a boundary layer results in displacement of surface charge, generating a potential difference {\Delta}V. Wind blowing over granular surfaces such as snow can induce such a {\Delta}V, with subsequent discharge. Discharges over nanosecond-timescales can then lead to RF emissions at characteristic MHz-GHz frequencies. We find that such backgrounds are evident in the several neutrino experiments considered, and are generally characterized by: a) a threshold wind velocity which likely depends on the experimental signal trigger threshold and layout; for the experiments considered herein, this value is typically O(10 m/s), b) frequency spectra generally shifted to the low-end of the frequency regime to which current radio experiments are typically sensitive (100-200 MHz), c) for the strongest background signals, an apparent preference for discharges from above-surface structures, although the presence of more isotropic, lower amplitude triboelectric discharges cannot be excluded.

astro-ph.IM↗

arXiv2019

Constraints on the Diffuse Flux of Ultra-High Energy Neutrinos from Four Years of Askaryan Radio Array Data in Two Stations

The Askaryan Radio Array (ARA) is an ultra-high energy (UHE, $>10^{17}$ eV) neutrino detector designed to observe neutrinos by searching for the radio waves emitted by the relativistic products of neutrino-nucleon interactions in Antarctic ice. In this paper, we present constraints on the diffuse flux of ultra-high energy neutrinos between $10^{16}-10^{21}$ eV resulting from a search for neutrinos in two complementary analyses, both analyzing four years of data (2013-2016) from the two deep stations (A2, A3) operating at that time. We place a 90 % CL upper limit on the diffuse all flavor neutrino flux at $10^{18}$ eV of $EF(E)=5.6\times10^{-16}$ $\textrm{cm}^{-2}$$\textrm{s}^{-1}$$\textrm{sr}^{-1}$. This analysis includes four times the exposure of the previous ARA result, and represents approximately 1/5 the exposure expected from operating ARA until the end of 2022.

astro-ph.HE↗

arXiv2019

Long-baseline horizontal radio-frequency transmission through polar ice

We report on analysis of englacial radio-frequency (RF) pulser data received over horizontal baselines of 1--5 km, based on broadcasts from two sets of transmitters deployed to depths of up to 1500 meters at the South Pole. First, we analyze data collected usingtwo RF bicone transmitters 1400 meters below the ice surface, and frozen into boreholes drilled for the IceCube experiment in 2011. Additionally, in Dec., 2018, a fat-dipole antenna, fed by one of three high-voltage (~1 kV), fast (~(1-5 ns)) signal generators was lowered into the 1700-m deep icehole drilled for the South Pole Ice Core Experiment (SPICE), approximately 3 km from the geographic South Pole. Signals from transmitters were recorded on the five englacial multi-receiver ARA stations, with receiver depths between 60--200 m. We confirm the long, >1 km RF electric field attenuation length, test our observed signal arrival timing distributions against models, and measure birefringent asymmetries at the 0.15% level.

astro-ph.IM↗

arXiv2009

Hardware Trojan by Hot Carrier Injection

This paper discusses how hot carrier injection (HCI) can be exploited to create a trojan that will cause hardware failures. The trojan is produced not via additional logic circuitry but by controlled scenarios that maximize and accelerate the HCI effect in transistors. These scenarios range from manipulating the manufacturing process to varying the internal voltage distribution. This new type of trojan is difficult to test due to its gradual hardware degradation mechanism. This paper describes the HCI effect, detection techniques and discusses the possibility for maliciously induced HCI trojans.

cs.AR↗

arXiv2009

Exploiting Semiconductor Properties for Hardware Trojans

This paper discusses the possible introduction of hidden reliability defects during CMOS foundry fabrication processes that may lead to accelerated wearout of the devices. These hidden defects or hardware Trojans can be created by deviation from foundry design rules and processing parameters. The Trojans are produced by exploiting time-based wearing mechanisms (HCI, NBTI, TDDB and EM) and/or condition-based triggers (ESD, Latchup and Softerror). This class of latent damage is difficult to test due to its gradual degradation nature. The paper describes life-time expectancy results for various Trojan induced scenarios. Semiconductor properties, processing and design parameters critical for device reliability and Trojan creation are discussed.

cs.AR↗