arXiv subjects

W. Hartung

Publications and source records attributed to W. Hartung.

12 recordsLinked to original sources

arXiv2025

Plasma Processing of FRIB Low-Beta Cryomodules using Higher-Order-Modes

Improvement in SRF accelerator performance after in-tunnel plasma processing has been seen at SNS and CEBAF. Plasma processing development for FRIB quarter-wave and half-wave resonators (QWRs, HWRs) was initiated in 2020. Plasma processing on individual QWRs (beta = 0.085) and HWRs (beta = 0.53) has been found to significantly reduce field emission. A challenge for the FRIB cavities is the relatively weak fundamental power coupler (FPC) coupling strength (chosen for efficient continuous-wave acceleration), which produces a lot of mismatch during plasma processing at room temperature. For FRIB QWRs, driving the plasma with higher-order modes (HOMs) is beneficial to reduce the FPC mismatch and increase the plasma density. The first plasma processing trial on a spare FRIB QWR cryomodule was done in January 2024, with before-and-after bunker tests and subsequent installation into the linac tunnel. The first in-tunnel plasma processing trial was completed in September 2025. For both cryomodules, before-and-after cold tests showed a significant increase in the average accelerating gradient for field emission onset after plasma processing for some cavities. In parallel with the cryomodule trials, the use of dual-drive plasma is being explored with the goal of improving the effectiveness of plasma processing.

physics.acc-ph↗

arXiv2023

Advanced surface treatments for medium-velocity superconducting RF cavities for high accelerating gradient continuous-wave operation

Nitrogen-doping and furnace-baking are advanced high-Q0 recipes developed for 1.3 GHz TESLA-type cavities. These treatments will significantly benefit the high-Q0 linear accelerator community if they can be successfully adapted to different cavity styles and frequencies. Strong frequency- and geometry- dependence of these recipes makes the technology transfer amongst different cavity styles and frequencies far from straightforward, and requires rigorous study. Upcoming high-Q0 continuous-wave linear accelerator projects, such as the proposed Michigan State University Facility for Rare Isotope Beam Energy Upgrade, and the underway Fermilab's Proton Improvement Plan-II, could benefit enormously from adapting these techniques to their beta_opt = 0.6 ~650 MHz 5-cell elliptical superconducting rf cavities, operating at an accelerating gradient of around ~17 MV/m. This is the first investigation of the adaptation of nitrogen doping and medium temperature furnace baking to prototype 644 MHz beta_opt = 0.65 cavities, with the aim of demonstrating the high-Q0 potential of these recipes in these novel cavities for future optimization as part of the FRIB400 project R&D. We find that nitrogen-doping delivers superior Q0, despite the sub-GHz operating frequency of these cavities, but is sensitive to the post-doping electropolishing removal step and experiences elevated residual resistance. Medium temperature furnace baking delivers reasonable performance with decreased residual resistance compared to the nitrogen doped cavity, but may require further recipe refinement. The gradient requirement for the FRIB400 upgrade project is comfortably achieved by both recipes.

physics.acc-ph↗

arXiv2016

Beam Induced Electron Cloud Resonances in Dipole Magnetic Fields

The buildup of low energy electrons in an accelerator, known as electron cloud, can be severely detrimental to machine performance. Under certain beam conditions, the beam can become resonant with the cloud dynamics, accelerating the buildup of electrons. This paper will examine two such effects: multipacting resonances, in which the cloud development time is resonant with the bunch spacing, and cyclotron resonances, in which the cyclotron period of electrons in a magnetic field is a multiple of bunch spacing. Both resonances have been studied directly in dipole fields using retarding field analyzers installed in the Cornell Electron Storage Ring (CESR). These measurements are supported by both analytical models and computer simulations.

physics.acc-ph↗

arXiv2015

Measurement of Electron Trapping in the CESR Storage Ring

The buildup of low-energy electrons has been shown to affect the performance of a wide variety of particle accelerators. Of particular concern is the persistence of the cloud between beam bunch passages, which can impose limitations on the stability of operation at high beam current. We have obtained measurements of long-lived electron clouds trapped in the field of a quadrupole magnet in a positron storage ring, with lifetimes much longer than the revolution period. Based on modeling, we estimate that about 7% of the electrons in the cloud generated by a 20-bunch train of 5.3 GeV positrons with 16-ns spacing and $1.3x10^{11}$ population survive longer than 2.3 $μ$s in a quadrupole field of gradient 7.4 T/m. We have observed a non-monotonic dependence of the trapping effect on the bunch spacing. The effect of a witness bunch on the measured signal provides direct evidence for the existence of trapped electrons. The witness bunch is also observed to clear the cloud, demonstrating its effectiveness as a mitigation technique.

physics.acc-ph↗

arXiv2014

Measurements of Electron Cloud Growth and Mitigation in Dipole, Quadrupole, and Wiggler Magnets

Retarding field analyzers (RFAs), which provide a localized measurement of the electron cloud, have been installed throughout the Cornell Electron Storage Ring (CESR), in different magnetic field environments. This paper describes the RFA designs developed for dipole, quadrupole, and wiggler field regions, and provides an overview of measurements made in each environment. The effectiveness of electron cloud mitigations, including coatings, grooves, and clearing electrodes, are assessed with the RFA measurements.

physics.acc-ph↗

arXiv2014

Measurement and Modeling of Electron Cloud in a Field Free Environment Using Retarding Field Analyzers

As part of the CESR-TA program at Cornell, diagnostic devices to measure and quantify the electron cloud effect have been installed throughout the CESR ring. One such device is the Retarding Field Analyzer (RFA), which provides information on the local electron cloud density and energy distribution. In a magnetic field free environment, RFA measurements can be directly compared with simulation to study the growth and dynamics of the cloud on a quantitative level. In particular, the photoemission and secondary emission characteristics of the instrumented chambers can be determined simultaneously.

physics.acc-ph↗

arXiv2014

Comparison of Electron Cloud Mitigating Coatings Using Retarding Field Analyzers

In 2008, the Cornell Electron Storage Ring (CESR) was reconfigured to serve as a test accelerator (CESR-TA) for next generation lepton colliders, in particular for the ILC damping ring. A significant part of this program has been the installation of diagnostic devices to measure and quantify the electron cloud effect, a potential limiting factor in these machines. One such device is the Retarding Field Analyzer (RFA), which provides information on the local electron cloud density and energy distribution. Several different styles of RFAs have been designed, tested, and deployed throughout the CESR ring. They have been used to study the growth of the cloud in different beam conditions, and to evaluate the efficacy of different mitigation techniques. This paper will provide an overview of RFA results obtained in a magnetic field free environment.

physics.acc-ph↗

arXiv2014

Measurement and Compensation of Horizontal Crabbing at the Cornell Electron Storage Ring Test Accelerator

In storage rings, horizontal dispersion in the rf cavities introduces horizontal-longitudinal (xz) coupling, contributing to beam tilt in the xz plane. This coupling can be characterized by a "crabbing" dispersion term ζa that appears in the normal mode decomposition of the 1-turn transfer matrix. ζa is proportional to the rf cavity voltage and the horizontal dispersion in the cavity. We report experiments at the Cornell Electron Storage Ring Test Accelerator (CesrTA) where xz coupling was explored using three lattices with distinct crabbing properties. We characterize the xz coupling for each case by measuring the horizontal projection of the beam with a beam size monitor. The three lattice configurations correspond to a) 16 mrad xz tilt at the beam size monitor source point, b) compensation of the ζa introduced by one of two pairs of RF cavities with the second, and c) zero dispersion in RF cavities, eliminating ζa entirely. Additionally, intrabeam scattering (IBS) is evident in our measurements of beam size vs. rf voltage.

physics.acc-ph↗

arXiv2013

Intrabeam Scattering Studies at CesrTA

Intrabeam scattering (IBS) limits the emittance and single-bunch current that can be achieved in electron or positron storage ring colliders, damping rings, and light sources. Much theoretical work on IBS exists, and while the theories have been validated in hadron and ion machines, the presence of strong damping makes IBS in lepton machines a different phenomenon. We present the results of measurements at CesrTA of IBS dominated beams, and compare the data with theory. The beams we study have parameters typical of those specified for the next generation of wiggler dominated storage rings: low emittance, small bunch length, and few GeV energy. Our measurements are in good agreement with IBS theory, provided a tail-cut procedure is applied.

physics.acc-ph↗

arXiv2013

Secondary Electron Yield Measurements of Fermilab's Main Injector Vacuum Vessel

We discuss the progress made on a new installation in Fermilab's Main Injector that will help investigate the electron cloud phenomenon by making direct measurements of the secondary electron yield (SEY) of samples irradiated in the accelerator. In the Project X upgrade the Main Injector will have its beam intensity increased by a factor of three compared to current operations. This may result in the beam being subject to instabilities from the electron cloud. Measured SEY values can be used to further constrain simulations and aid our extrapolation to Project X intensities. The SEY test-stand, developed in conjunction with Cornell and SLAC, is capable of measuring the SEY from samples using an incident electron beam when the samples are biased at different voltages. We present the design and manufacture of the test-stand and the results of initial laboratory tests on samples prior to installation.

physics.acc-ph↗

arXiv2004

Niobium Quarter-Wave Resonator Development for The Rare Isotope Accelerator

Two superconducting quarter-wave resonator (QWR) prototypes have been fabricated and tested. They operate at 80.5 MHz and 161 MHz and are optimised for beta = 0.085 and beta = 0.16, respectively. The prototypes are simplified versions without integrated helium vessels. In the first RF tests, the beta = 0.085 QWR reached a peak surface electric field (Ep) in excess of 30 MV/m, with an intrinsic quality factor (Q0) in excess of 1E9 at the design field of Ep = 20 MV/m. The beta = 0.16 QWR reached Ep = 20 MV/m with Q0 = 2.5E9. It is suspected that the performance of the latter cavity can be improved via better cooling of the Nb tuning plate and a better RF contact between the plate and the outer conductor.

physics.acc-ph↗

arXiv2003

Status Report on Multi-Cell Superconducting Cavity Development for Medium-Velocity Beams

Three prototype 6-cell superconducting cavities for acceleration in the velocity range of 0.40 to 0.53 times the speed of light have been fabricated. The quality factor (Q) of the first prototype cavity was above 1E10 for accelerating gradients up to 11 MV/m. The highest gradient reached was about 16 MV/m; the Q was about 3E9 at the maximum gradient.

physics.acc-ph↗