arXiv subjects

W. J. Llope

Publications and source records attributed to W. J. Llope.

11 recordsLinked to original sources

arXiv2018

Particle identification studies with a full-size 4-GEM prototype for the ALICE TPC upgrade

A large Time Projection Chamber is the main device for tracking and charged-particle identification in the ALICE experiment at the CERN LHC. After the second long shutdown in 2019/20, the LHC will deliver Pb beams colliding at an interaction rate of about 50 kHz, which is about a factor of 50 above the present readout rate of the TPC. This will result in a significant improvement on the sensitivity to rare probes that are considered key observables to characterize the QCD matter created in such collisions. In order to make full use of this luminosity, the currently used gated Multi-Wire Proportional Chambers will be replaced. The upgrade relies on continuously operated readout detectors employing Gas Electron Multiplier technology to retain the performance in terms of particle identification via the measurement of the specific energy loss by ionization d$E$/d$x$. A full-size readout chamber prototype was assembled in 2014 featuring a stack of four GEM foils as an amplification stage. The performance of the prototype was evaluated in a test beam campaign at the CERN PS. The d$E$/d$x$ resolution complies with both the performance of the currently operated MWPC-based readout chambers and the challenging requirements of the ALICE TPC upgrade program. Detailed simulations of the readout system are able to reproduce the data.

physics.ins-det↗

arXiv2014

The STAR Vertex Position Detector

The 2x3 channel pseudo Vertex Position Detector (pVPD) in the STAR experiment at RHIC has been upgraded to a 2x19 channel detector in the same acceptance, called the Vertex Position Detector (VPD). This detector is fully integrated into the STAR trigger system and provides the primary input to the minimum-bias trigger in Au+Au collisions. The information from the detector is used both in the STAR Level-0 trigger and offline to measure the location of the primary collision vertex along the beam pipe and the event "start time" needed by other fast-timing detectors in STAR. The offline timing resolution of single detector channels in full-energy Au+Au collisions is ~100 ps, resulting in a start time resolution of a few tens of picoseconds and a resolution on the primary vertex location of ~1 cm.

physics.ins-det↗

arXiv2014

Calibration and performance of the STAR Muon Telescope Detector using cosmic rays

We report the timing and spatial resolution from the Muon Telescope Detector (MTD) installed in the STAR experiment at RHIC. Cosmic ray muons traversing the STAR detector have an average transverse momentum of 6 GeV/c. Due to their very small multiple scattering, these cosmic muons provide an ideal tool to calibrate the detectors and measure their timing and spatial resolution. The values obtained were ~100 ps and ~1-2 cm, respectively. These values are comparable to those obtained from cosmic-ray bench tests and test beams.

physics.ins-det↗

arXiv2009

Perspectives of a Midrapidity Dimuon Program at RHIC: A Novel and Compact Muon Telescope Detector

We propose a large-area, cost-effective Muon Telescope Detector (MTD) for the Solenoidal Tracker at RHIC (STAR) at mid-rapidity and for the next generation of detectors at a possible electron-ion collider. We utilize Multi-gap Resistive Plate Chambers with large modules and long readout strips (Long-MRPC) in the detector design. The results from cosmic ray and beam tests show the intrinsic timing and spatial resolution for a Long-MRPC are 60-70 ps and $\sim1$ cm, respectively. The prototype performance of such a novel muon telescope detector at STAR indicates that muon identification at the transverse momentum of a few GeV/$c$ can be achieved through the combined information of track matching with the MTD, ionization energy loss in the Time Projection Chamber, and time-of-flight measurements. A primary muon over secondary muon ratio of better than 1/3 can be achieved. This provides a promising device for future quarkonium programs and primordial dilepton measurements at RHIC. Simulations of the muon efficiency, the signal-to-background ratio of $J/ψ$, the separation of $Υ$ 1S from 2S+3S states, and the electron-muon correlation from charm pair production in the RHIC environment are presented.

nucl-ex↗

arXiv2008

Simple Front End Electronics for Multigap Resistive Plate Chambers

A simple circuit for the presentation of the signals from Multi-gap Resistive Plate Chambers (MRPCs) to standard existing digitization electronics is described. The circuit is based on "off-the-shelf" discrete components. An optimization of the values of specific components is required to match the aspects of the MRPCs for the given application. This simple circuit is an attractive option for the initial signal processing for MRPC prototyping and bench- or beam-testing efforts, as well as for final implementations of small-area Time-of-Flight systems with existing data acquisition systems.

physics.ins-det↗

arXiv2008

New Prototype Multi-gap Resistive Plate Chambers with Long Strips

A new kind of Multi-gap Resistive Plate Chamber (MRPC) has been built for the large-area Muon Telescope Detector (MTD) for the STAR experiment at RHIC. These long read-out strip MRPCs (LMRPCs) have an active area of 87.0 x 17.0 cm2 and ten 250 um-thick gas gaps arranged as a double stack. Each read-out strip is 2.5 cm wide and 90 cm long. The signals are read-out at both ends of each strip. Cosmic ray tests indicate a time resolution of ~70 ps and a detection efficiency of greater than 95%. Beam tests performed at T963 at Fermilab indicate a time resolution of 60-70 ps and a spatial resolution of ~1 cm along the strip direction.

physics.ins-det↗

arXiv2003

The TOFp/pVPD Time of Flight System for STAR

A time-of-flight system was constructed for the STAR Experiment for the direct identification of hadrons produced in 197Au+197Au collisions at RHIC. The system consists of two separate detector subsystems, one called the pVPD (the "start" detector) and the other called the TOFp tray (the "stop" detector). Each detector is based on conventional scintillator/phototube technology and includes custom high-performance front-end electronics and a common CAMAC-based digitization and read-out. The design of the system and its performance during the 2001 RHIC run will be described. The start resolution attained by the pVPD was 24 ps, implying a pVPD single-detector resolution of 58 ps. The total time resolution of the system averaged over all detector channels was 87 ps, allowing direct pi/K/p discrimination for momenta up to 1.8 GeV/c, and direct (pi+K)/p discrimination up to 3 GeV/c.

nucl-ex↗

arXiv1999

An electronic clock for correlated noise corrections

An inexpensive and portable approach to measure the time an experimental event occurs as measured by a specific electronic clock is presented. The clock resets in active synchronization with the experimental AC-power cycle. This allows an efficient and complete correction for correlated noise contributions to pulse area and time measurements of detector channels equipped with PhotoMultiplier Tubes. The electronic board that was developed will be described. The performance for the treatment of correlated noise in experimental data taken at the BNL-AGS facility, and analyses of spectral decompositions of this noise, will also be described.

nucl-ex↗

arXiv1999

Proton and deuteron distributions as signatures for collective particle dynamics and event shape geometries at the RHIC

We present predictions for the formation of (anti)nuclear bound states in nucleus-nucleus reactions at RHIC energies. he phase space coalescence method is used in combination with RQMD-v2.4 transport calculations to demonstrate the relevance of particle production as well as the longitudinal and transverse flow components. The formation of deuterons follows an approximate scaling law proportional to the relative freeze-out densities of nucleons and produced secondaries. For antideuterons, an additional suppression appears that is proportional to the number of nucleons, pointing toward multiple rescattering and absorption prior to freeze-out.

nucl-th↗

arXiv1999

Deuterons and space-momentum correlations in high energy nuclear collisions

Using a microscopic transport model together with a coalescence after-burner, we study the formation of deuterons in Au + Au central collisions at $\sqrt{s}=200 AGeV$. It is found that the deuteron transverse momentum distributions are strongly affected by the nucleon space-momentum correlations, at the moment of freeze-out, which are mostly determined by the number of rescatterings. This feature is useful for studying collision dynamics at ultrarelativistic energies.

nucl-th↗

arXiv1999

Deuteron production and space-momentum correlations at RHIC

We present predictions for the formation of (anti)nuclear bound states in Au+Au central collisions at $\sqrt{s}=200A$ GeV. The coalescence afterburner was applied to the freeze-out phase space distributions of nucleons provided by the transport model, RQMD version 2.4. We study the sensitivity of the deuteron spectra to space-momentum correlations. It is found that the deuteron transverse momentum distributions are strongly affected by the nucleon space-momentum correlations.

nucl-th↗