arXiv subjects

Wanchun Liu

Publications and source records attributed to Wanchun Liu.

41 records · Page 3Linked to original sources

arXiv2017

Backscatter Multiplicative Multiple-Access Systems: Fundamental Limits and Practical Design

In this paper, we consider a novel ambient backscatter multiple-access system, where a receiver (Rx) simultaneously detects the signals transmitted from an active transmitter (Tx) and a backscatter Tag. Specifically, the information-carrying signal sent by the Tx arrives at the Rx through two wireless channels: the direct channel from the Tx to the Rx, and the backscatter channel from the Tx to the Tag and then to the Rx. The received signal from the backscatter channel also carries the Tag's information because of the multiplicative backscatter operation at the Tag. This multiple-access system introduces a new channel model, referred to as multiplicative multiple-access channel (M-MAC). We analyze the achievable rate region of the M-MAC, and prove that its region is strictly larger than that of the conventional time-division multiple-access scheme in many cases, including, e.g., the high SNR regime and the case when the direct channel is much stronger than the backscatter channel. Hence, the multiplicative multiple-access scheme is an attractive technique to improve the throughput for ambient backscatter communication systems. Moreover, we analyze the detection error rates for coherent and noncoherent modulation schemes adopted by the Tx and the Tag, respectively, in both synchronous and asynchronous scenarios, which further bring interesting insights for practical system design.

cs.IT↗

arXiv2017

Full-Duplex Backscatter Interference Networks Based on Time-Hopping Spread Spectrum

Future Internet-of-Things (IoT) is expected to wirelessly connect billions of low-complexity devices. For wireless information transfer (WIT) in IoT, high density of IoT devices and their ad hoc communication result in strong interference which acts as a bottleneck on WIT. Furthermore, battery replacement for the massive number of IoT devices is difficult if not infeasible, making wireless energy transfer (WET) desirable. This motivates: (i) the design of full-duplex WIT to reduce latency and enable efficient spectrum utilization, and (ii) the implementation of passive IoT devices using backscatter antennas that enable WET from one device (reader) to another (tag). However, the resultant increase in the density of simultaneous links exacerbates the interference issue. This issue is addressed in this paper by proposing the design of full-duplex backscatter communication (BackCom) networks, where a novel multiple-access scheme based on time-hopping spread-spectrum (TH-SS) is designed to enable both one-way WET and two-way WIT in coexisting backscatter reader-tag links. Comprehensive performance analysis of BackCom networks is presented in this paper, including forward/backward bit-error rates and WET efficiency and outage probabilities, which accounts for energy harvesting at tags, non-coherent and coherent detection at tags and readers, respectively, and the effects of asynchronous transmissions.

cs.IT↗

arXiv2017

A Novel Receiver Design with Joint Coherent and Non-Coherent Processing

In this paper, we propose a novel splitting receiver, which involves joint processing of coherently and non-coherently received signals. Using a passive RF power splitter, the received signal at each receiver antenna is split into two streams which are then processed by a conventional coherent detection (CD) circuit and a power-detection (PD) circuit, respectively. The streams of the signals from all the receiver antennas are then jointly used for information detection. We show that the splitting receiver creates a three-dimensional received signal space, due to the joint coherent and non-coherent processing. We analyze the achievable rate of a splitting receiver, which shows that the splitting receiver provides a rate gain of $3/2$ compared to either the conventional (CD-based) coherent receiver or the PD-based non-coherent receiver in the high SNR regime. We also analyze the symbol error rate (SER) for practical modulation schemes, which shows that the splitting receiver achieves asymptotic SER reduction by a factor of at least $\sqrt{M}-1$ for $M$-QAM compared to either the conventional (CD-based) coherent receiver or the PD-based non-coherent receiver.

cs.IT↗

arXiv2016

Energy Harvesting Wireless Sensor Networks: Delay Analysis Considering Energy Costs of Sensing and Transmission

Energy harvesting (EH) provides a means of greatly enhancing the lifetime of wireless sensor nodes. However, the randomness inherent in the EH process may cause significant delay for performing sensing operation and transmitting the sensed information to the sink. Unlike most existing studies on the delay performance of EH sensor networks, where only the energy consumption of transmission is considered, we consider the energy costs of both sensing and transmission. Specifically, we consider an EH sensor that monitors some status environmental property and adopts a harvest-then-use protocol to perform sensing and transmission. To comprehensively study the delay performance, we consider two complementary metrics and analytically derive their statistics: (i) update age - measuring the time taken from when information is obtained by the sensor to when the sensed information is successfully transmitted to the sink, i.e., how timely the updated information at the sink is, and (ii) update cycle - measuring the time duration between two consecutive successful transmissions, i.e., how frequently the information at the sink is updated. Our results show that the consideration of sensing energy cost leads to an important tradeoff between the two metrics: more frequent updates result in less timely information available at the sink.

cs.IT↗

arXiv2015

Secure Communication with a Wireless-Powered Friendly Jammer

In this paper, we propose to use a wireless-powered friendly jammer to enable secure communication between a source node and destination node, in the presence of an eavesdropper. We consider a two-phase communication protocol with fixed-rate transmission. In the first phase, wireless power transfer is conducted from the source to the jammer. In the second phase, the source transmits the information-bearing signal under the protection of a jamming signal sent by the jammer using the harvested energy in the first phase. We analytically characterize the long-time behavior of the proposed protocol and derive a closed-form expression for the throughput. We further optimize the rate parameters for maximizing the throughput subject to a secrecy outage probability constraint. Our analytical results show that the throughput performance differs significantly between the single-antenna jammer case and the multi-antenna jammer case. For instance, as the source transmit power increases, the throughput quickly reaches an upper bound with single-antenna jammer, while the throughput grows unbounded with multi-antenna jammer. Our numerical results also validate the derived analytical results.

cs.IT↗