Woosong Jeong | Searcharxiv

arXiv2025

10$^{-15}$-level laser stabilization down to fiber thermal noise limit using self-homodyne detection

We demonstrate a self-homodyne detection method to stabilize a continuous-wave 1550-nm laser to a 1-km optical fiber delay line, achieving a frequency instability of 6.3x10 -15 at a 16-ms averaging time. This result, limited by fiber thermal noise, is achieved without the need for a vacuum system, highlighting the potential of our approach for ultra-stable laser systems in non-laboratory environments. The system utilizes only a few passive fiber optic components and a single balanced photodetector, significantly simplifying the laser stabilization process while maintaining high performance. The entire optical setup is compactly packaged in a portable metal air-tight case.

physics.optics↗

arXiv2025

Optical frequency comb integration in radio telescopes: advancing signal generation and phase calibration

Very long baseline interferometry (VLBI) enables high-angular-resolution observations in astronomy and geodesy by synthesizing a virtual telescope with baselines spanning hundreds to thousands of kilometres. Achieving high instrumental phase stability in VLBI relies on the generation of high-quality, atomic-referenced RF local oscillator (LO) and RF-comb signals for the effective downconversion of celestial RF signals and precise phase calibration, respectively. As observing frequencies move into higher ranges with wider bandwidth, conventional electronic methods face significant challenges in maintaining the quality of these signals. Here, we demonstrate that an optical frequency comb (OFC) can be used as a versatile tool to generate and distribute low-noise and atomic-referenced RF-comb and RF-LO signals in the VLBI telescope. Hydrogen maser-stabilized optical pulses are transmitted over a timing-stabilized fibre link from the observatory building to the VLBI receiver system at the telescope, where photodetection converts them into the required RF-comb and RF-LO signals. In VLBI test observation, we successfully detected VLBI fringes and extracted the RF-combs characteristics in a format suitable for VLBI instrumental phase calibration. These results highlight the high potential of OFC-based technology for enhancing next-generation broadband VLBI measurements, advancing astrophysical research and facilitating intercontinental clock comparison.

astro-ph.IM↗