arXiv subjects

X. Bonnin

Publications and source records attributed to X. Bonnin.

10 recordsLinked to original sources

arXiv2026

White paper on the relevance of the European Solar Telescope (EST) for the French heliophysics

The project of the European Solar Telescope aims to provide a state-of-the art infrastructure to study the Sun and its interactions with Earth and the heliosphere. This 4.2m aperture telescope will be equipped with multi conjugate adaptive optics, light-polarisation analyser, imaging spectrograph and integral field unit spectrographs. It will provide unprecedented observations of the solar photosphere and chromosphere and of the dynamical events and features that pertains to the low solar atmosphere. The EST project is presently in a phase of crystallisation, aiming at the creation of an European Research Infrastructure Consortium. While the French community has continuously been associated with the development of the EST project, some specific scientific aspects are more particularly relevant for the French astrophysics and heliophysics communities. The present review highlights the scientific research axes of high interest from the French community that shall strongly benefit from EST. The later will not only advance numerous topics of solar physics, as well as solar adaptive optics developments, but will also provide unrivaled datasets of high interest in the framework of space weather. This review also aims to highlight the space weather use that can be done with future EST observations, that will be particularly relevant for French heliophysicists.

astro-ph.IM↗

arXiv2024

Access and sustainment of ELMy H-mode operation for ITER Pre-Fusion Power Operation plasmas using JINTRAC

In the initial stages of ITER operation, ELM mitigation systems need to be commissioned. This requires controlled flat-top operation in type-I ELMy H-mode regimes. Hydrogen or helium plasma discharges are used exclusively in these stages to ensure negligible production of neutrons from fusion reactions. With the expected higher L-H power threshold of hydrogen and helium plasmas compared to corresponding D and D/T plasmas, it is uncertain whether available auxiliary power systems are sufficient to operate in stable type-I ELMy H-mode. This has been investigated using integrated core and edge/SOL/divertor modelling with JINTRAC. Assuming that the L-H power threshold is well captured by the Martin08 scaling law, the presented simulations have found that 30 MW of ECRH power is likely required for the investigated hydrogen plasma scenarios, rather than the originally planned 20 MW in the 2016 Staged Approach ITER Baseline. However, past experiments have shown that a small helium fraction (~10 %) can considerably reduce the hydrogen plasma L-H power threshold. Assuming that these results extrapolate to ITER operation regimes, the 7.5MA/2.65T hydrogen plasma scenario is likely to access stable type-I ELMy H-mode operation also at 20 MW of ECRH.

physics.plasm-ph↗

arXiv2024

Numerical simulation of a helium Plasma-Material Interaction experiment in GyM linear device through SOLPS-ITER and ERO2.0 codes

Learning how to safely handle Plasma-Material Interaction (PMI) is a key challenge towards the commercialisation of energy from nuclear fusion. In this respect, linear plasma devices are ideal experimental testbeds, and numerical codes play a crucial complementary role. In this paper, a numerical investigation of PMI-relevant helium plasma experimental discharges in GyM linear device is presented, in which SOLPS-ITER and ERO2.0 codes are coupled for plasma background generation and material erosion investigation respectively, with the aim to support the interpretation and complement the available experimental dataset. On the plasma side, simulated profiles are validated against experimental data to provide a realistic plasma background, and the role of He metastable states is assessed for the first time in SOLPS simulations. On the material side, the erosion and deposition effects due to the introduction of the sample-holder in the simulation volume are investigated, now considering also the real stainless steel composition as wall material.

physics.plasm-ph↗

arXiv2022

Impact of the improved parallel kinetic coefficients on the helium and neon transport in SOLPS-ITER for ITER

New Grad's-Zhdanov module is implemented in the SOLPS-ITER code and applied to ITER impurity transport simulations. Significant difference appears in the helium transport due to improved parallel kinetic coefficients. As a result 30\% decrease of the separatrix-averaged helium relative concentration is observed for the constant helium source and pumping speed. Change of the impurity behaviour is discussed. For the neon changes are less pronounced. For the first time the ion distribution functions are studied in the ITER Scrape-off layer conditions to reveal the origin of the kinetic coefficient improvements and theory limitations.

physics.plasm-ph↗

arXiv2021

Whistler waves observed by Solar Orbiter / RPW between 0.5 AU and 1 AU

The goal of our study is to detect and characterize the electromagnetic waves that can modify the electron distribution functions, with a special attention to whistler waves. We analyse in details the electric and magnetic field fluctuations observed by the Solar Orbiter spacecraft during its first orbit around the Sun between 0.5 and 1 AU. Using data of the Search Coil Magnetometer and electric antenna, both parts of the Radio and Plasma Waves (RPW) instrumental suite, we detect the electromagnetic waves with frequencies above 3 Hz and determine the statistical distribution of their amplitudes, frequencies, polarization and k-vector as a function of distance. We also discuss relevant instrumental issues regarding the phase between the electric and magnetic measurements and the effective length of the electric antenna. An overwhelming majority of the observed waves are right hand circularly polarized in the solar wind frame and identified as outward propagating and quasi parallel whistler waves. Their occurrence rate increases by a least a factor two from 1 AU to 0.5 AU. These results are consistent with the regulation of the heat flux by the whistler heat flux instability. Near 0.5 AU, whistler waves are found to be more field-aligned and to have smaller normalized frequency ($f/f_{ce}$), larger amplitude, and larger bandwidth than at 1 AU.

astro-ph.SR↗

arXiv2021

Simulations of radio-wave anisotropic scattering to interpret type III radio bursts measurements by Solar Orbiter, Parker Solar Probe, STEREO and Wind

We use multi-spacecraft observations of invididual type III radio bursts in order to calculate the directivity of the radio emission, to be compared to the results of ray-tracing simulations of the radio-wave propagation and probe the plasma properties of the inner heliosphere. Ray-tracing simulations of radio-wave propagation with anisotropic scattering on density inhomogeneities are used to study the directivity of radio emissions. Simultaneous observations of type III radio bursts by four widely-separated spacecraft are used to calculate the directivity and position of the radio sources. The shape of the directivity pattern deduced for individual events is compared to the directivity pattern resulting from the ray-tracing simulations. We show that simultaneous observations of type radio III bursts by 4 different probes provide the opportunity to estimate the radio source positions and the directivity of the radio emission. The shape of the directivity varies from one event to another, and is consistent with anisotropic scattering of the radio-waves.

astro-ph.SR↗

arXiv2021

Solar Orbiter/RPW antenna calibration in the radio domain and its application to type III burst observations

In order to allow for a comparison with the measurements from other antenna systems, the voltage power spectral density measured by the Radio and Plasma waves receiver (RPW) on board Solar Orbiter needs to be converted into physical quantities that depend on the intrinsic properties of the radiation itself.The main goal of this study is to perform a calibration of the RPW dipole antenna system that allows for the conversion of the voltage power spectral density measured at the receiver's input into the incoming flux density. We used space observations from the Thermal Noise Receiver (TNR) and the High Frequency Receiver (HFR) to perform the calibration of the RPW dipole antenna system. Observations of type III bursts by the Wind spacecraft are used to obtain a reference radio flux density for cross-calibrating the RPW dipole antennas. The analysis of a large sample of HFR observations (over about ten months), carried out jointly with an analysis of TNR-HFR data and prior to the antennas' deployment, allowed us to estimate the reference system noise of the TNR-HFR receivers. We obtained the effective length of the RPW dipoles and the reference system noise of TNR-HFR in space, where the antennas and pre-amplifiers are embedded in the solar wind plasma. The obtained $l_{eff}$ values are in agreement with the simulation and measurements performed on the ground. By investigating the radio flux intensities of 35 type III bursts simultaneously observed by Solar Orbiter and Wind, we found that while the scaling of the decay time as a function of the frequency is the same for the Waves and RPW instruments, their median values are higher for the former. This provides the first observational evidence that Type III radio waves still undergo density scattering, even when they propagate from the source, in a medium with a plasma frequency that is well below their own emission frequency.

astro-ph.SR↗

arXiv2021

Equations and improved coefficients for paralleltransport in multicomponent collisional plasmas: method and application for tokamak modelling

New analytical expressions for parallel transport coefficients in multicomponent collisional plasmas are presented in this paper. They are improved versions of the expressions written in [V. M. Zhdanov. Transport Processes in Multicomponent Plasma, vol. 44. 10 2002.], based on Grad's 21N-moment method. Both explicit and approximate approaches for transport coefficients calculation are considered. Accurate application of this closure for the Braginskii transport equations is discussed. Viscosity dependence on the heat flux is taken into account. Improved expressions are implemented into the SOLPS-ITER code and tested for deuterium and neon ITER cases. Some typos found in [V. M. Zhdanov. Transport Processes in Multicomponent Plasma, vol. 44. 10 2002.] are corrected.

physics.plasm-ph↗

arXiv2020

The Solar Orbiter Science Activity Plan: translating solar and heliospheric physics questions into action

Solar Orbiter is the first space mission observing the solar plasma both in situ and remotely, from a close distance, in and out of the ecliptic. The ultimate goal is to understand how the Sun produces and controls the heliosphere, filling the Solar System and driving the planetary environments. With six remote-sensing and four in-situ instrument suites, the coordination and planning of the operations are essential to address the following four top-level science questions: (1) What drives the solar wind and where does the coronal magnetic field originate? (2) How do solar transients drive heliospheric variability? (3) How do solar eruptions produce energetic particle radiation that fills the heliosphere? (4) How does the solar dynamo work and drive connections between the Sun and the heliosphere? Maximising the mission's science return requires considering the characteristics of each orbit, including the relative position of the spacecraft to Earth (affecting downlink rates), trajectory events (such as gravitational assist manoeuvres), and the phase of the solar activity cycle. Furthermore, since each orbit's science telemetry will be downloaded over the course of the following orbit, science operations must be planned at mission level, rather than at the level of individual orbits. It is important to explore the way in which those science questions are translated into an actual plan of observations that fits into the mission, thus ensuring that no opportunities are missed. First, the overarching goals are broken down into specific, answerable questions along with the required observations and the so-called Science Activity Plan (SAP) is developed to achieve this. The SAP groups objectives that require similar observations into Solar Orbiter Observing Plans (SOOPs), resulting in a strategic, top-level view of the optimal opportunities for science observations during the mission lifetime.

astro-ph.SR↗

arXiv2018

Simulating Jupiter-satellite decametric emissions with ExPRES: a parametric study

The high latitude radio emissions produced by the Cyclotron Maser Instability (CMI) in Jupiter's magnetosphere extend from a few kHz to 40 MHz. Part of the decametric emissions is of auroral origin, and part is driven by the moons Io, Europa and Ganymede. After summarizing the method used to identify Jupiter-satellite radio emissions, which consists in comparing space- and ground-based radio observations to ExPRES simulations of CMI-driven emissions in the time-frequency plane, we present a parametric study of the free parameters required by the ExPRES code (electron distribution function and resonant energy, magnetic field model, lead angle, and altitude of the ionospheric cut-off) in order to assess the accuracy of our simulations in the Io-Jupiter case. We find that Io-DAM arcs are fairly modeled by loss-cone driven CMI with electrons of 1-10 keV energy, using the ISaAC, VIPAL or VIP4 magnetic field model and a simple sinusoidal lead angle model. The altitude of the ionospheric cut-off has a marginal impact on the simulations. We discuss the impact of our results on the identification of Europa-DAM and Ganymede-DAM emissions.

astro-ph.EP↗