arXiv subjects

Xingfen Jiang

Publications and source records attributed to Xingfen Jiang.

3 recordsLinked to original sources

arXiv2026

Development of Readout Electronics for a High-Speed Event-Driven Neutron Imaging Detector Based on Timepix4

As the Chinese Spallation Neutron Source enters Phase II, the increase in proton beam power will lead to a further boost in the intensity of pulsed neutron beams. To address the demand for higher event-rate readout electronics for energy-resolved neutron imaging detectors, we have developed a high-performance readout electronics system based on the Timepix4 chip. The prototype electronics system comprises a Timepix4 chip board and a high-performance digital board, which are interconnected through a custom FMC interface. The advantage of this system is its ability to achieve the full bandwidth readout of 160 Gbps for a single Timepix4 chip. The electronics system, based solely on a single ZYNQ-MPSOC chip, is capable of fully meeting the required performance specifications within a compact form factor of 8 cm x 30 cm. Furthermore, the system features a high-capacity external SODIMM memory interface (supporting up to 32 GB), which ensures stable data readout through a single 40 Gbps QSFP+ interface. As of the present moment, notable progress has been achieved, including the successful establishment of 16 data channels between Timepix4 and FPGA that operate error-free and stably at a speed of 5.12 Gbps, which is half of the maximum theoretical speed of 10.24 Gbps. The threshold standard deviation across all pixels is less than 50 e- after equalization. And the clear structural results obtained from X-ray experiments indicate that the functionality is essentially complete, allowing further testing.

physics.ins-det↗

arXiv2026

CTPX1: A Highly Integrated and High-Throughput Data-Driven Camera Based on Timepix4

The upgrade of the China Spallation Neutron Source (CSNS-II) will raise the proton beam power to 500 kW. Consequently, the existing Timepix3-based detector systems, limited to a count rate of 80 Mhits/s, will encounter severe saturation challenges. To address the demand of the Energy-Resolved Neutron Imaging instrument (ERNI) for next-generation higher count-rate electronics, this paper presents CTPX1, a high-performance data-driven camera system based on the Timepix4 ASIC. The system adopts a compact modular architecture, integrating readout electronics, a precision high-voltage bias unit, and a TEC temperature control subsystem. To fully exploit the readout potential of the Timepix4 ASIC's 16 high-speed serial links, this paper proposes a two-stage parallel processing architecture. This architecture achieves real-time data aggregation with a total bandwidth of up to 81.92 Gbps. Over a continuous 12-hour operation period, temperature fluctuations were kept within 0.1 {\deg}C while the high-voltage output noise remained below 1 mV. High-flux X-ray testing indicates that the system achieves a peak event readout rate of 1.17 Ghits/s, approaching the limit of the configured link speed. In-beam neutron verification at CSNS confirms that the camera successfully resolves fine spatial structures, achieving an imaging performance consistent with the 55 {\mu}m pixel pitch of the sensor. Furthermore, the clear observation of spectral features in the Time of flight (TOF) spectrum of a {\gamma}-Fe sample validates the system's good time resolution. This camera effectively addresses the data readout saturation challenges, validates the feasibility of Timepix4 technology for neutron imaging, and provides a viable solution for next-generation high-performance neutron imaging instruments.

physics.ins-det↗

arXiv2021

A novel energy resolved neutron imaging detector based on TPX3Cam for the CSNS

The China Spallation Neutron Source (CSNS) operates in pulsed mode and has a high neutron flux. This provides opportunities for energy resolved neutron imaging by using the TOF (Time Of Flight) approach. An Energy resolved neutron imaging instrument (ERNI) is being built at the CSNS but significant challenges for the detector persist because it simultaneously requires a spatial resolution of less than 100 μm, as well as a microsecond-scale timing resolution. This study constructs a prototype of an energy resolved neutron imaging detector based on the fast optical camera, TPX3Cam coupled with an image intensifier. To evaluate its performance, a series of proof of principle experiments were performed in the BL20 at the CSNS to measure the spatial resolution and the neutron wavelength spectrum, and perform neutron imaging with sliced wavelengths and Bragg edge imaging of the steel sample. A spatial resolution of 57 μm was obtained for neutron imaging by using the centroiding algorithm, the timing resolution was on the microsecond scale and the measured wavelength spectrum was identical to that measured by a beam monitor. In addition, any wavelengths can be selected for the neutron imaging of the given object, and the detector can be used for Bragg edge imaging. The results show that our detector has good performances and can satisfy the requirements of ERNI for detectors at the CSNS

physics.ins-det↗