arXiv subjects

Xuehui Dong

Publications and source records attributed to Xuehui Dong.

11 recordsLinked to original sources

arXiv2026

Reliability-Constrained Blind Beam Alignment for Backscatter-MIMO mounted Target in Cluttered Multipath Channels

Practical ISAC is constrained by static clutter and NLoS multipath, which obscure target-coupled echoes and induce spurious peaks for beam alignment. Existing receiver-side methods largely model targets as passive scatterers, limiting the structural separability of target echoes from the environment. This paper establishes a structural correspondence between these limitations and target-side Backscatter-MIMO responses: reflection modulation enables waveform-domain separation from unmodulated clutter, while retro-directional passive beamforming concentrates the tagged echo toward the BS-facing direction and suppresses NLoS-induced false-peak locking. To operationalize this correspondence, dual-end spatial locking is required to overcome cascaded backscatter loss and provide beam-domain angular information. We propose a downlink-triggered blind dual-end alignment protocol that jointly selects the BS and Backscatter-MIMO codeword indices from the tagged echo observed at the BS, without pilots, CSI feedback, or target synchronization. We further derive a clutter-aware remodulation waveform robust to fractional timing offsets and construct adjustable-width BS/Backscatter-MIMO codebooks via quadratic phase spoiling. For reliability characterization, we derive closed-form expressions for the coherence-averaged end-to-end success probability. The analysis shows that beam narrowing is not universally beneficial: in NLoS-dominated regimes, enlarging the array aperture may degrade alignment reliability. The optimal beamwidth is instead governed by cross-phase competition between discovery and alignment, yielding a nontrivial feasible region with an analytically characterized boundary. Simulations validate the analysis and demonstrate improved reliability-gated locked-link performance under strong clutter, severe NLoS multipath, and finite coherence time.

cs.IT↗

arXiv2026

Radio-Frequency Inverse Rendering for Wireless Environment Modeling

Neural rendering paradigms have recently emerged as powerful tools for radio frequency (RF). However, by entangling RF sources with scene geometry and material properties, existing approaches limit downstream manipulation of scene geometry, wireless system configuration, and RF reasoning. To address this, we propose a physically grounded RF inverse rendering (RFIR) framework that explicitly decouples RF emission, geometry, and material electromagnetic properties. Our key insight is an RF-aware bidirectional scattering distribution function, embedded into the Gaussian splatting paradigm as an RF rendering equation. Each Gaussian primitive is endowed with intrinsic physical attributes, including surface normals, material electromagnetic parameters, and roughness, and leveraged by a customized ray-tracing scheme to represent RF signal synthesis. The proposed RFIR generalizes three typical RF tasks: radar cross-section synthesis, received signal strength indicator prediction, and wireless scene editability. Experiments demonstrate significant performance advantages, underscoring the potential for wireless world modeling.

eess.SP↗

arXiv2025

Metasurface-Enabled Superheterodyne Transmitter With Decoupled Harmonic-Free Signal Generation and Precoding

The evolution of programmable metasurfaces (PM) from passive beamforming to active information transmission marks a paradigm shift for next-generation wireless systems. However, this transition is hindered by fundamental limitations in conventional metasurface transmitter architectures, including restricted modulation orders, symbol-level spatial inconsistency, and significant harmonic interference. These issues stem from the intrinsic coupling between baseband signal processing and radio-frequency beamforming in monolithic designs reliant on simplistic switching mechanisms. This paper proposes a novel metasurface-enabled superheterodyne architecture (MSA) that fundamentally decouples these functionalities. The MSA introduces a dual-stage up-conversion process, comprising a digital up-conversion module for in-phase/quadrature modulation and baseband-to-intermediate frequency conversion, a precoder module for precoding, and a custom-designed magnitude-phase-decoupled metasurface that acts as a reconfigurable reflective mixer array. This decoupling of harmonic-free waveform generation from spatial precoding overcomes the critical drawbacks of existing approaches. Experimental results from a 5.8 GHz proof-of-concept prototype system validate the MSA's superior performance. The system generates spatially isotropic constellations for arbitrary-order QAM modulations, ensures consistent time-frequency signatures for applications like Doppler-spoofing, and achieves data rates up to 20 Mbps within a linear operating region that minimizes nonlinear distortion. The capability of employing spatial diversity and multi-stream interference cancellation has been demonstrated for the first time in a PM-based transmitter.

cs.IT↗

arXiv2025

Frequency-Space Channel Estimation and Spatial Equalization in Wideband Fluid Antenna System

The Fluid Antenna System (FAS) overcomes the spatial degree-of-freedom limitations of conventional static antenna arrays in wireless communications.This capability critically depends on acquiring full Channel State Information across all accessible ports. Existing studies focus exclusively on narrowband FAS, performing channel estimation solely in the spatial domain. This work proposes a channel estimation and spatial equalization framework for wideband FAS, revealing for the first time an inherent group-sparse structure in aperture-limited FAS channels. First, we establish a group-sparse recovery framework for space-frequency characteristics in FAS, formally characterizing leakage-induced sparsity degradation from limited aperture and bandwidth as a structured group-sparsity problem. By deriving dictionary-adapted group restricted isometry property, we prove tight recovery bounds for a convex $\ell_1/\ell_2$-mixed norm optimization formulation that preserves leakage-aware sparsity patterns. Second, we develop a descending correlation group orthogonal matching pursuit algorithm that systematically relaxes leakage constraints to reduce subcoherence. This approach enables FSC recovery with accelerated convergence and superior performance compared to conventional compressive sensing methods like OMP or GOMP. Third, we formulate spatial equalization as a mixed-integer linear programming problem, complement this with a greedy algorithm maintaining near-optimal performance. Simulation results demonstrate the proposed channel estimation algorithm effectively resolves energy misallocation and enables recovery of weak details, achieving superior recovery accuracy and convergence rate. The SE framework suppresses deep fading phenomena and largely reduces time consumption overhead while maintaining equivalent link reliability.

eess.SP↗

arXiv2024

Metasurface-Enabled Superheterodyne Transmitter for Arbitrary-Order Modulation with Spatially Isotropic Symbol Distribution

Electromagnetically programmable information metasurfaces, as dynamically controllable 2D metamaterials, hold significant promise as low-profile hardware enabling passive wave control and signal generation for backscatter systems. However, current metasurface-based transmitters architecture fundamentally suffer from hardware non-modularization, forcing all transmitter functions onto nonlinear switch-based unit cells, which introduces symbol mapping inconsistency via phase coupling. Moreover, both temporal coding (limited by unit cell diodes) and space-time coding (impaired by symbol anisotropy) exhibit irreducible harmonic interference and entangled control of amplitude, phase, and beam direction. This paper proposes a metasurface-enabled superheterodyne architecture (MSA), comprising a digital up-conversion (DUC) module performing baseband-to-intermediate frequency (IF) conversion, filtering, and digital-to-analog conversion (DAC), and a reconfigurable metasurface featuring programmable unit cells that independently control both the magnitude and phase of the reflection coefficient. Systematically, the architecture leverages a dual-stage up-conversion process, typical of superheterodyne systems, but uniquely employs the metasurface for the final RF conversion stage. Building upon this framework, a proof-of-concept prototype featuring a 5.8 GHz magnitude-phase decoupled (MPD) metasurface (<15 degree phase deviation per state) and a DAC-based DUC module is presented. Extensive validation confirms the metasurface's capability for distortion-free mixing with arbitrary IF signals while maintaining consistent radiation patterns. The prototype successfully implements diverse QAM modulation schemes (4QAM to 256QAM) in mono-static and bi-static configurations, demonstrating symbol isotropy for spatially separated receivers and achieving a data rate of approximately 20 Mbps (at 5 MHz IF)...

eess.SY↗

arXiv2024

Design and Optimization on Successive RIS-assisted Multi-hop Wireless Communications

As an emerging wireless communication technology, reconfigurable intelligent surface (RIS) has become a basic choice for providing signal coverage services in scenarios with dense obstacles or long tunnels through multi-hop configurations. Conventional works of literature mainly focus on alternating optimization or single-beam calculation in RIS phase configuration, which is limited in considering energy efficiency, and often suffers from inaccurate channel state information (CSI), poor convergence, and high computational complexity. This paper addresses the design and optimization challenges for successive RIS-assisted multi-hop systems. Specifically, we establish a general model for multi-hop communication based on the relationship between the input and output electric fields within each RIS. Meanwhile, we derive the half-power beamwidth of the RIS-reflected beams, considering the beam direction. Leveraging these models and derivations, we propose deployment optimization and beam optimization strategies for multi-hop systems, which feature high aperture efficiency and significant gains in signal power. Simulation and prototype experiment results validate the effectiveness and superiority of the proposed systems and methods.

cs.IT↗

arXiv2024

Arbitrary Waveform Generated Metasurface: A New Paradigm for Direct Modulation and Beamforming Decoupling

Information Metasurface, also known as reconfigurable intelligent surface (RIS) has gained significant attention owing to its impressive abilities in electromagnetic (EM) wave manipulation with simple structures. Numerous studies focus on achieving efficient and versatile information transmission using RIS across various fields like wireless communication, radar detection, integrated sensing, and communications, among others. Previous studies demonstrate diverse approaches to achieve reflection modulation by utilizing the superposition of the quantified reflection coefficient (RC) of each unit but suffer from the computing complexity of codebook sequence, the safety of communication, and the flexibility of modulation. To address these challenges, we introduce a novel concept of information metasurface, namely AWG-RIS, which is capable of independently producing arbitrary baseband waveforms and beam patterns through a design that decouples magnitude and phase, without changing the beam pattern. The AWG-RIS functions as a reflection mixer, directly embedding the intended signal into the incoming EM waves. Subsequently, we developed an analysis framework and introduced the waveform factor and beamforming factor into the new model, offering theoretical support for the transition from the control signal to the outgoing electromagnetic wave. Additionally, we unveil the world's first prototype showcasing passive arbitrary waveform generation while maintaining the beam pattern unaltered. Leveraging the decoupling of direct modulation and beamforming, we explore additional applications in several domains relative to traditional RISs. Finally, we present experiments that confirm the generation of arbitrary waveforms and particular spectrograms.

eess.SY↗

arXiv2023

Wireless Communications in Cavity: A Reconfigurable Boundary Modulation based Approach

This paper explores the potential wireless communication applications of Reconfigurable Intelligent Surfaces (RIS) in reverberant wave propagation environments. Unlike in free space, we utilize the sensitivity to boundaries of the enclosed electromagnetic (EM) field and the equivalent perturbation of RISs. For the first time, we introduce the framework of reconfigurable boundary modulation in the cavities . We have proposed a robust boundary modulation scheme that exploits the continuity of object motion and the mutation of the codebook switch, which achieves pulse position modulation (PPM) by RIS-generated equivalent pulses for wireless communication in cavities. This approach achieves around 2 Mbps bit rate in the prototype and demonstrates strong resistance to channel's frequency selectivity resulting in an extremely low bit error rate (BER).

eess.SY↗

arXiv2023

Multi-RIS-aided Wireless Communications in Real-world: Prototyping and Field Trials

The performance of multiple reconfigurable intelligent surfaces (RISs) receives limited attention in previous studies. This article fills this research gap by investigating the capabilities of multiple RISs in real-world networks. We propose a simplified yet highly scalable sandwich architecture for implementing one-bit unit cells, with the flexibility to accommodate multi-bit unit cells. To effectively control multiple RISs, we present a cost-effective remote-controlling scheme and develop a cloud-based RIS management system. Through a series of four field trials, we demonstrate the effectiveness of multi-hop routing schemes in establishing reliable links. Our experiments reveal significant improvements in signal strength and data transmission in multi-RIS-aided Wi-Fi and commercial 5G networks. Furthermore, we investigate the power scaling law of RIS-aided beamforming and provide insights into the roles of the later nodes in multi-hop relay chains.

eess.SY↗

arXiv2022

Transforming RIS-Assisted Passive Beamforming from Tedious to Simple: A Relaxation Algorithm for Rician Channel

This paper investigates the problem of maximizing the signal-to-noise ratio (SNR) in reconfigurable intelligent surface (RIS)-assisted MISO communication systems. The problem will be reformulated as a complex quadratic form problem with unit circle constraints. We proved that the SNR maximizing problem has a closed-form global optimal solution when it is a rank-one problem, whereas the former researchers regarded it as an optimization problem. Moreover, We propose a relaxation algorithm (RA) that relaxes the constraints to that of Rayleigh's quotient problem and then projects the solution back, where the SNR obtained by RA achieves much the same SNR as the upper bound but with significantly low time consumption. Then we asymptotically analyze its performance when the transmitter antennas n_t and the number of units of RIS N grow large together, with N/n_t -> c. Finally, our numerical simulations show that RA achieves over 98% of the performance of the upper bound and takes below 1% time consumption of manifold optimization (MO) and 0.1% of semidefinite relaxation (SDR).

eess.SP↗

arXiv2022

RIS-aided Wireless Communication with $1$-bit Discrete Optimization for Signal Enhancement

In recent years, a brand-new technology, reconfigurable intelligent surface (RIS) has been widely studied for reconfiguring the wireless propagation environment. RIS is an artificial surface of electromagnetic material that is capable of customizing the propagation of the wave impinging upon it. Utilizing RIS for communication service like signal enhancement usually lead to non-convex optimization problems. Existing optimization methods either suffers from scalability issues for $N$ number of RIS elements large, or may lead to suboptimal solutions in some scenario. In this paper, we propose a divide-and-sort (DaS) discrete optimization approach, that is guaranteed to find the global optimal phase shifts for $1$-bit RIS, and has time complexity $\mathcal{O}(N \log(N))$. Numerical experiments show that the proposed approach achieves a better ``performance--complexity tradeoff'' over other methods for $1$-bit RIS.

eess.SP↗