arXiv subjects

Y. J. Sun

Publications and source records attributed to Y. J. Sun.

10 recordsLinked to original sources

arXiv2025

Spin relaxation and transport behaviors in altermagnetic systems

The D'yakonov-Perel' (DP) spin-relaxation mechanism has traditionally been associated with either relativistic spin-orbit coupling, which breaks space-inversion symmetry, or inhomogeneous magnetization, which breaks both time-reversal and translational symmetries. Here, we investigate spin relaxation mechanism in altermagnetic systems which possess novel magnetic states characterized by sublattices connected through crystal-rotation symmetries and opposite spins with zero overall net magnetization and absence of spin-orbit coupling. We find that altermagnetic states exhibit DP-type spin relaxations in both strong- and weak-scattering regimes, with the spin relaxation rate decreasing to zero as the temperature approaches the critical temperature of the altermagnetic phase transition. However, the scattering time involved in this spin relaxation mechanism is not the momentum relaxation time, in contrast to the conventional DP spin relaxation. Using a kinetic approach incorporating rigorous microscopic scattering, we demonstrate that the spin Hall current is highly anisotropic and proportional to the degree of altermagnetic order.

cond-mat.mes-hall↗

arXiv2022

A feasibility study of the reflection readout method of Resistive-Plate Chambers

The conventional readout method of the RPC detector uses two sets of orthogonal readout strips placed at the both sides of the gas gap to collect signals of opposite polarities to obtain space points. A new readout method utilizing the reflected signals is proposed which only requires one set of readout strips. The reflection readout method utilizes the differences in the arrival time of the direct and reflected signals to determine the hit position. Customized transmission cables are introduced to extend the propagation distance of reflected signals to ensure sufficient separation of the two signals. Because only one side of the readout panel is connected to the FEE boards, reflection readout method can increase the geometrical acceptance and save the readout channels. Experimental setup and test results of this novel readout method is shown in this paper. It is demonstrated that a spatial resolution of sub centimeter can be achieved by processing the rising edges of the original and reflected pulses with commonly used electronics.

physics.ins-det↗

arXiv2022

Acceleration of 60 MeV proton beams in the commissioning experiment of SULF-10 PW laser

We report the experimental results of the commissioning phase in the 10 PW laser beamline of Shanghai Superintense Ultrafast Laser Facility (SULF). The peak power reaches 2.4 PW on target without the last amplifying during the experiment. The laser energy of 72\pm 9 J is directed to a focal spot of ~6 μm diameter (FWHM) in 30 fs pulse duration, yielding a focused peak intensity around 2.0 \times 10^{21} W/cm^2. First laser-proton acceleration experiment is performed using plain copper and plastic targets. High-energy proton beams with maximum cut-off energy up to 62.5 MeV are achieved using copper foils at the optimum target thickness of 4 μm via target normal sheath acceleration (TNSA). For plastic targets of tens of nanometers thick, the proton cut-off energy is approximately 20 MeV, showing ring-like or filamented density distributions. These experimental results reflect the capabilities of the SULF-10 PW beamline, e.g., both ultrahigh intensity and relatively good beam contrast. Further optimization for these key parameters is underway, where peak laser intensities of 10^{22}-10^{23} W/cm^2 are anticipated to support various experiments on extreme field physics.

physics.plasm-ph↗

arXiv2021

Antinodal kink in the band dispersion of electron-doped cuprate ${\rm La}_{2-x}{\rm Ce}_x{\rm CuO}_{4\pmδ}$

Angle-resolved photoemission spectroscopy (ARPES) measurements have established the phenomenon of kink in band dispersion of high-$T_{\rm c}$ cuprate superconductors. However, systematic studies of the kink in electron-doped cuprates are still lacking experimentally. We performed $in$-$situ$ ARPES measurements on ${\rm La}_{2-x}{\rm Ce}_x{\rm CuO}_{4\pmδ}$ (LCCO) thin films over a wide electron doping ($n$) range from 0.05 to 0.23. While the nodal kink is nearly invisible, an antinodal kink around 45 meV, surviving above 200 K, is observed for $n\sim0.05-0.19$, whose position is roughly independent of doping. The fact that the antinodal kink observed at high temperatures and in the highly overdoped region favors the phonon mechanism with contributions from the Cu-O bond-stretching mode and the out-of-plane oxygen buckling mode. Our results also suggest that the antinodal kink of LCCO is only weakly coupled to its superconductivity.

cond-mat.supr-con↗

arXiv2021

Suppression of Antiferromagnetism in Electron-Doped Cuprate $T'$-${\rm La}_{2-x}{\rm Ce}_x\rm {CuO}_{4\pmδ}$

We performed systematic angle-resolved photoemission spectroscopy measurements $in$-$situ$ on $T'$-${\rm La}_{2-x}{\rm Ce}_x\rm {CuO}_{4\pmδ}$ (LCCO) thin films over the extended doping range prepared by the refined ozone/vacuum annealing method. Electron doping level ($n$), estimated from the measured Fermi surface volume, varies from 0.05 to 0.23, which covers the whole superconducting dome. We observed an absence of the insulating behavior around $n \sim$ 0.05 and the Fermi surface reconstruction shifted to $n \sim$ 0.11 in LCCO compared to that of other electron-doped cuprates at around 0.15, suggesting that antiferromagnetism is strongly suppressed in this material. The possible explanation may lie in the enhanced -$t'$ /$t$ in LCCO for the largest $\rm{La^{3+}}$ ionic radius among all the Lanthanide elements.

cond-mat.supr-con↗

arXiv2020

Layout and Performance of HPK Prototype LGAD Sensors for the High-Granularity Timing Detector

The High-Granularity Timing Detector is a detector proposed for the ATLAS Phase II upgrade. The detector, based on the Low-Gain Avalanche Detector (LGAD) technology will cover the pseudo-rapidity region of $2.4<|η|<4.0$ with two end caps on each side and a total area of 6.4 $m^2$. The timing performance can be improved by implanting an internal gain layer that can produce signal with a fast rising edge, which improve significantly the signal-to-noise ratio. The required average timing resolution per track for a minimum-ionising particle is 30 ps at the start and 50 ps at the end of the HL-LHC operation. This is achieved with several layers of LGAD. The innermost region of the detector would accumulate a 1 MeV-neutron equivalent fluence up to $2.5 \times 10^{15} cm^{-2}$ before being replaced during the scheduled shutdowns. The addition of this new detector is expected to play an important role in the mitigation of high pile-up at the HL-LHC. The layout and performance of the various versions of LGAD prototypes produced by Hamamatsu (HPK) have been studied by the ATLAS Collaboration. The breakdown voltages, depletion voltages, inter-pad gaps, collected charge as well as the time resolution have been measured and the production yield of large size sensors has been evaluated.

physics.ins-det↗

arXiv2018

Continuous doping of a cuprate surface: new insights from in-situ ARPES

The cuprate superconductors distinguish themselves from the conventional superconductors in that a small variation in the carrier doping can significantly change the superconducting transition temperature (T_c), giving rise to a superconducting dome where a pseudogap (ref. 1,2) emerges in the underdoped region and a Fermi liquid appears in the overdoped region. Thus a systematic study of the properties over a wide doping range is critical for understanding the superconducting mechanism. Here, we report a new technique to continuously dope the surface of Bi2Sr2CaCu2O8+x through an ozone/vacuum annealing method. Using in-situ ARPES, we obtain precise quantities of energy gaps and the coherent spectral weight over a wide range of doping. We discover that the d-wave component of the quasiparticle gap is linearly proportional to the Nernst temperature that is the onset of superconducting vortices (ref. 3), strongly suggesting that the emergence of superconducting pairing is concomitant with the onset of free vortices, with direct implications for the onset of superconducting phase coherence at T_c and the nature of the pseudogap phenomena.

cond-mat.supr-con↗

arXiv2014

Test of High Time Resolution MRPC with Different Readout Modes

In order to further enhance the particle identification capability of the Beijing Spectrometer (BESIII), it is proposed to upgrade the current end-cap time-of-flight (eTOF) detector with multi-gap resistive plate chamber (MRPC). The prototypes, together with the front end electronics (FEE) and time digitizer (TDIG) module have been tested at the E3 line of Beijing Electron Positron Collider (BEPCII) to study the difference between the single and double-end readout MRPC designs. The time resolutions (sigma) of the single-end readout MRPC are 47/53 ps obtained by 600 MeV/c proton/pion beam, while that of the double-end readout MRPC is 40 ps (proton beam). The efficiencies of three MRPC modules tested by both proton and pion beam are better than 98%. For the double-end readout MRPC, no incident position dependence is observed.

physics.ins-det↗

arXiv2014

Calibration and performance of the STAR Muon Telescope Detector using cosmic rays

We report the timing and spatial resolution from the Muon Telescope Detector (MTD) installed in the STAR experiment at RHIC. Cosmic ray muons traversing the STAR detector have an average transverse momentum of 6 GeV/c. Due to their very small multiple scattering, these cosmic muons provide an ideal tool to calibrate the detectors and measure their timing and spatial resolution. The values obtained were ~100 ps and ~1-2 cm, respectively. These values are comparable to those obtained from cosmic-ray bench tests and test beams.

physics.ins-det↗

arXiv2008

New Prototype Multi-gap Resistive Plate Chambers with Long Strips

A new kind of Multi-gap Resistive Plate Chamber (MRPC) has been built for the large-area Muon Telescope Detector (MTD) for the STAR experiment at RHIC. These long read-out strip MRPCs (LMRPCs) have an active area of 87.0 x 17.0 cm2 and ten 250 um-thick gas gaps arranged as a double stack. Each read-out strip is 2.5 cm wide and 90 cm long. The signals are read-out at both ends of each strip. Cosmic ray tests indicate a time resolution of ~70 ps and a detection efficiency of greater than 95%. Beam tests performed at T963 at Fermilab indicate a time resolution of 60-70 ps and a spatial resolution of ~1 cm along the strip direction.

physics.ins-det↗