arXiv subjects

Y. K. Kim

Publications and source records attributed to Y. K. Kim.

24 records · Page 2Linked to original sources

arXiv2011

Anisotropic Dirac fermions in a Bi square net of SrMnBi2

We report the highly anisotropic Dirac fermions in a Bi square net of SrMnBi2, based on a first principle calculation, angle resolved photoemission spectroscopy, and quantum oscillations for high-quality single crystals. We found that the Dirac dispersion is generally induced in the (SrBi)+ layer containing a double-sized Bi square net. In contrast to the commonly observed isotropic Dirac cone, the Dirac cone in SrMnBi2 is highly anisotropic with a large momentum-dependent disparity of Fermi velocities of ~ 8. These findings demonstrate that a Bi square net, a common building block of various layered pnictides, provide a new platform that hosts highly anisotropic Dirac fermions.

cond-mat.mtrl-sci↗

arXiv2011

Electronic Structure Studies of Detwinned BaFe$_2$As$_2$ by Photoemission

We performed angle resolved photoelectron spectroscopy (ARPES) studies on mechanically detwinned BaFe2As2. We observe clear band dispersions and the shapes and characters of the Fermi surfaces are identified. Shapes of the two hole pockets around the Γ-point are found to be consistent with the Fermi surface topology predicted in the orbital ordered states. Dirac-cone like band dispersions near the Γ-point are clearly identified as theoretically predicted. At the X-point, split bands remain intact in spite of detwinning, barring twinning origin of the bands. The observed band dispersions are compared with calculated band structures. With a magnetic moment of 0.2 ?B per iron atom, there is a good agreement between the calculation and experiment.

cond-mat.str-el↗

arXiv2009

The Evolution of FTK, a Real-Time Tracker for Hadron Collider Experiments

We describe the architecture evolution of the highly-parallel dedicated processor FTK, which is driven by the simulation of LHC events at high luminosity (1034 cm-2 s-1). FTK is able to provide precise on-line track reconstruction for future hadronic collider experiments. The processor, organized in a two-tiered pipelined architecture, execute very fast algorithms based on the use of a large bank of pre-stored patterns of trajectory points (first tier) in combination with full resolution track fitting to refine pattern recognition and to determine off-line quality track parameters. We describe here how the high luminosity simulation results have produced a new organization of the hardware inside the FTK processor core.

physics.ins-det↗

arXiv2009

Development of FTK architecture: a fast hardware track trigger for the ATLAS detector

The Fast Tracker (FTK) is a proposed upgrade to the ATLAS trigger system that will operate at full Level-1 output rates and provide high quality tracks reconstructed over the entire detector by the start of processing in Level-2. FTK solves the combinatorial challenge inherent to tracking by exploiting the massive parallelism of Associative Memories (AM) that can compare inner detector hits to millions of pre-calculated patterns simultaneously. The tracking problem within matched patterns is further simplified by using pre-computed linearized fitting constants and leveraging fast DSP's in modern commercial FPGA's. Overall, FTK is able to compute the helix parameters for all tracks in an event and apply quality cuts in approximately one millisecond. By employing a pipelined architecture, FTK is able to continuously operate at Level-1 rates without deadtime. The system design is defined and studied using ATLAS full simulation. Reconstruction quality is evaluated for single muon events with zero pileup, as well as WH events at the LHC design luminosity. FTK results are compared with the tracking capability of an offline algorithm.

physics.ins-det↗

arXiv2003

The CDFII Time-Of-Flight Detector and Impact on Beauty Flavor Tagging

The new CDFII detector incorporates a Time-of-Flight detector (TOF), employing plastic scintillator bars and fine-mesh photomultipliers. Since August 2001 the TOF system has been fully instrumented and integrated into the CDFII data acquisition system. With a design goal of $100 ps$ resolution the TOF system will provide at least two standard deviations separation between $K^{\pm}$ and $π^{\pm}$ for momenta $p<1.6 GeV/c$, complementing low momentum particle identification by means of the specific ionization energy loss measured in the drift chamber. We describe the design of the TOF detector and discuss the current status of its calibration and initial performances. Finally we review the expected impact of the TOF detector in the flavor tagging of neutral $B_S$ meson.

hep-ex↗

arXiv2000

Report of the Working Group on Precision Measurements

In the first part of this report, we discuss the prospects for measuring the W mass and width in Run II. The basic techniques used to measure M_W are described and the statistical, theoretical and detector-related uncertainties are discussed in detail. Alternative methods of measuring the W mass at the Tevatron and the prospects for M_W measurements at other colliders are also described. In the second part, we discuss the measurement of the forward backward asymmetry in Drell Yan production in Run II which can be used to determine the effective weak mixing angle. Estimates of the statistical and systematic uncertainties in Run II are given. The third part summarizes the features of the FORTRAN package GAPP which performs a fit to the electroweak observables and extracts the probability distribution function of the Higgs boson mass.

hep-ex↗