arXiv subjects

Y. Sugimoto

Publications and source records attributed to Y. Sugimoto.

7 recordsLinked to original sources

arXiv2016

Direct penetration of spin-triplet superconductivity into a ferromagnet in Au/SrRuO3/Sr2RuO4 junctions

Efforts have been ongoing to establish superconducting spintronics utilizing ferromagnet/superconductor heterostructures1. Previously reported devices are based on spin-singlet superconductors (SSCs), where the spin degree of freedom is lost. Spin-polarized supercurrent induction in ferromagnetic metals (FMs) is achieved even with SSCs, but only with the aid of interfacial complex magnetic structures, which severely affect information imprinted to the electron spin. Use of spin-triplet superconductors (TSCs) with active spins potentially overcomes this difficulty and further leads to novel functionalities. Here, we report spin-triplet superconductivity induction into a FM SrRuO3 from a leading TSC candidate Sr2RuO4, by fabricating microscopic devices using an epitaxial SrRuO3/Sr2RuO4 hybrid. The differential conductance, exhibiting Andreev-reflection features with multiple energy scales up to around half tesla, indicates the penetration of superconductivity over a considerable distance of 15 nm across the SrRuO3 layer without help of interfacial complex magnetism. This demonstrates the first FM/TSC device exhibiting the spin-triplet proximity effect.

cond-mat.supr-con↗

arXiv2016

Recent status of FPCCD vertex detector R&D

The Fine Pixel CCD (FPCCD) is one of the candidate sensor technologies for the ILC vertex detector. It will be located near interaction point and require high radiation tolerance. It will thus be operated at -40 degree C to improve radiation tolerance. In this paper, we report on the status of neutron radiation tests, on a cooling system using two-phase CO2 with a gas compressor for circulation, and on the mechanical structure of the FPCCD ladders.

physics.ins-det↗

arXiv2011

Impact of lithium composition on the thermoelectric properties of the layered cobalt oxide system LixCoO2

Thermoelectric properties of the layered cobalt oxide system LixCoO2 were investigated in a wide range of Li composition, 0.98 >= x >= 0.35. Single-phase bulk samples of LixCoO2 were successfully obtained through electrochemical deintercalation of Li from the pristine LiCoO2 phase. While LixCoO2 with x >= 0.94 is semiconductive, the highly Li-deficient phase (0.75 >= x >= 0.35) exhibits metallic conductivity. The magnitude of Seebeck coefficient at 293 K (S293K) significantly depends on the Li content (x). The S293K value is as large as +70 ~ +100 uV/K for x >= 0.94, and it rapidly decreases from +90 uV/K to +10 uV/K as x is lowered within a Li composition range of 0.75 >= x >= 0.50. This behavior is in sharp contrast to the results of x <= 0.40 for which the S293K value is small and independent of x (+10 uV/K), indicating that a discontinuous change in the thermoelectric characteristics takes place at x = 0.40 ~ 0.50. The unusually large Seebeck coefficient and metallic conductivity are found to coexist in a narrow range of Li composition at about x = 0.75. The coexistence, which leads to an enhanced thermoelectric power factor, may be attributed to unusual electronic structure of the two-dimensional CoO2 block.

cond-mat.str-el↗

arXiv2011

Fabrication of InP nano pillars by ECR Ar ion irradiation

Regular arrays of InP nano pillars have been fabricated by low energy Electron Cyclotron Resonance (ECR) Ar+ ion irradiation on InP(111) surface. Several scanning electron microscopy (SEM) images have been utilized to invetsigate the width, height, and orientation of these nano pillars on InP(111) surfaces. The average width and length of these nano-pillars are about 50 nm and 500 nm, respectively. The standing angle with respect to the surface of the nano-pillars depend on the incidence angle of the Ar ion irradiation during the fabrication process. Interestingly, the growth direction of the nano pillars are along the reflection direction of the ion beam and the standing angles are nearly same as the ion incidence angle with the surface normal. This nano-pillas are easily transferred from the InP surface to double sided carbon tape without any damage. High Resolution Transmission Electron Microscopy (HRTEM) study of single nano-pillar reveals that this nano-pillar are almost crystalline in nature except 2-4 nm amorphous layer on the outer surface. The transmission electron microscopy combined with energy-dispersive x-ray spectroscopy (TEM-EDS) analysis of these nano pillars exhibit that the ratio of In and P is little higher compared to the bulk InP.

cond-mat.mtrl-sci↗

arXiv2009

Electronic phase diagram of the layered cobalt oxide system, LixCoO2 (0.0 <= x <= 1.0)

Here we report the magnetic properties of the layered cobalt oxide system, LixCoO2, in the whole range of Li composition, 0 <= x <= 1. Based on dc-magnetic susceptibility data, combined with results of 59Co-NMR/NQR observations, the electronic phase diagram of LixCoO2 has been established. As in the related material NaxCoO2, a magnetic critical point is found to exist between x = 0.35 and 0.40, which separates a Pauli-paramagnetic and a Curie-Weiss metals. In the Pauli-paramagnetic regime (x <= 0.35), the antiferromagnetic spin correlations systematically increase with decreasing x. Nevertheless, CoO2, the x = 0 end member is a non-correlated metal in the whole temperature range studied. In the Curie-Weiss regime (x >= 0.40), on the other hand, various phase transitions are observed. For x = 0.40, a susceptibility hump is seen at 30 K, suggesting the onset of static AF order. A magnetic jump, which is likely to be triggered by charge ordering, is clearly observed at Tt = 175 K in samples with x = 0.50 (= 1/2) and 0.67 (= 2/3), while only a tiny kink appears at T = 210 K in the sample with an intermediate Li composition, x = 0.60. Thus, the phase diagram of the LixCoO2 system is complex, and the electronic properties are sensitively influenced by the Li content (x).

cond-mat.str-el↗

arXiv2008

Bunching visibility for correlated photons from single GaAs quantum dots

We study photon bunching phenomena associated with biexciton-exciton cascade in single GaAs self-assembled quantum dots. Experiments carried out with a pulsed excitation source show that significant bunching is only detectable at very low excitation, where the typical intensity of photon streams is less than the half of their saturation value. Our findings are qualitatively understood with a model which accounts for Poissonian statistics in the number of excitons, predicting the height of a bunching peak being determined by the inverse of probability of finding more than one exciton.

cond-mat.mtrl-sci↗

arXiv2005

A Test Facility for the International Linear Collider at SLAC End Station A, for Prototypes of Beam Delivery and IR Components

The SLAC Linac can deliver damped bunches with ILC parameters for bunch charge and bunch length to End Station A. A 10Hz beam at 28.5 GeV energy can be delivered there, parasitic with PEP-II operation. We plan to use this facility to test prototype components of the Beam Delivery System and Interaction Region. We discuss our plans for this ILC Test Facility and preparations for carrying out experiments related to collimator wakefields and energy spectrometers. We also plan an interaction region mockup to investigate effects from backgrounds and beam-induced electromagnetic interference.

physics.ins-det↗