SearcharxivSearch

arXiv subjects

Y. T. Zhu

Publications and source records attributed to Y. T. Zhu.

15 recordsLinked to original sources

Nonreciprocity enhanced Quantum Gyroscopes based on Surface Acoustic Waves

Surface acoustic waves (SAWs), as Rayleigh waves generated by elastic media, have been used in gyroscopes for over 40 years due to their unique propagation characteristics. However, their working principle, based on Coriolis effects, has become increasingly ineffective for addressing modern sensing challenges in complex scenarios. Fortunately, recent advancements in quantized SAWs offer a promising solution: SAWs operating at extremely low pump powers (approximately at the single-phonon level) can exhibit substantial quantum coherence, enabling investigations into the fundamental limits of SAW gyroscopes as constrained by the Heisenberg uncertainty relation. In particular, when multiple SAWs couple to a common waveguide at distinct locations, the nonlocality arising from the spatial separation among coupling points induces directional coupling between the SAWs. To elucidate this directionality, we propose a quantum gyroscope characterized by multiplepoint couplings. Unlike traditional single-point coupling designs, our gyroscope exhibits distinctive time-delayed dynamics that depend on the system's topologies. We emphasize that these dynamics invalidate the Markovian approximation, even when the time delay is relatively small. Through a comprehensive analysis of all possible topologies, we observe that the directional coupling implies an inherent nonreciprocal transfer. This nonreciprocity confers signiffcant advantages to our gyroscope compared to traditional designs, notably enhancing both the signal-to-noise ratio and sensitivity. Speciffcally, it enables the extraction of output signals that would otherwise be obscured by noise. Consequently, our ffndings suggest that systems with multiple-point couplings and the associated nonreciprocity can serve as valuable resources for advancing quantum sensing technologies.

quant-ph

A high-contrast coronagraph for earth-like exoplanet direct imaging: design and test

The high-contrast coronagraph for direct imaging earth-like exoplanet at the visible needs a contrast of 10^(-10) at a small angular separation of 4 lambda/D or less. Here we report our recent laboratory experiment that is close to the limits. The test of the high-contrast imaging coronagraph is based on our step-transmission apodized filter. To achieve the goal, we use a liquid crystal array (LCA) as a phase corrector to create a dark hole based on our dedicated focal dark algorithm. We have suppressed the diffracted and speckle noise near the star point image to a level of 1.68 x 10^(-9) at 4 lambda/D, which can be immediately used for the direct imaging of Jupiter like exoplanets. This demonstrates that high-contrast coronagraph telescope in space has the potentiality to detect and characterize earth-like planets.

astro-ph.IM

Enhancement of Critical Current Density in low level Al-doped MgB2

Two sets of MgB2 samples doped with up to 5 at. % of Al were prepared in different laboratories using different procedures. Decreases in the a and c lattice parameters were observed with Al doping confirming Al substitution onto the Mg site. The critical temperature (Tc) remained largely unchanged with Al doping. For 1 - 2.5 at.% doping, at 20K the in-field critical current densities (Jc's) were enhanced, particularly at lower fields. At 5K, in-field Jc was markedly improved, e.g. at 5T Jc was enhanced by a factor of 20 for a doping level of 1 at.% Al. The improved Jcs correlate with increased sample resistivity indicative of an increase in the upper critical field, Hc2, through alloying.

cond-mat.supr-con

Large field generation with Hot Isostatically Pressed Powder-in-Tube MgB2 coil at 25 K

We present the fabrication and test results of Hot-Isostatic-Pressed (HIPed) Powder-in-Tube (PIT) MgB$_2$ coils. The coils properties were measured by transport and magnetization at different applied fields ($H$) and temperatures ($T$). The engineering critical current ($J_e$) value is the largest reported in PIT MgB$_2$ wires or tapes. At 25 K our champion 6-layer coil was able to generate a field of 1 T at self-field ($I_c >$ 220 A, $J_e \sim 2.8 \times 10^4$ A/cm$^2$). At 4 K this coil generated 1.6 T under an applied field of 1.25 T ($I_c \sim350$ A, $J_e \sim 4.5 \times 10^4$ A/cm$^2$). These magnetic fields are high enough for a superconducting transformer or magnet applications such as MRI. A SiC doped MgB$_2$ single layer coil shows a promising improvement at high fields and exhibits $J_c > 10^4$ A/cm$^2$ at 7 T.

cond-mat.supr-con

The influence of structural defects on intra-granular critical currents of bulk MgB2

Bulk MgB2 samples were prepared under different synthesis conditions and analyzed by scanning and transmission electron microscopy. The critical current densities were determined from the magnetization versus magnetic field curves of bulk and powder-dispersed-in-epoxy samples. Results show that through a slow cooling process, the oxygen dissolved in bulk MgB2 at high synthesis temperatures can segregate and form nanometer-sized coherent precipitates of Mg(B,O)2 in the MgB2 matrix. Magnetization measurements indicate that these precipitates act as effective flux pinning centers and therefore significantly improve the intra-grain critical current density and its field dependence.

cond-mat.mtrl-sci

Microwave performance of high-density bulk MgB2

We have performed microwave measurements on superconducting hot-isostatically- pressed (HIPed) bulk MgB2 using a parallel-plate resonator technique. The high density and strength of the HIPed material allowed preparation of samples with mirror-like surfaces for microwave measurements. The microwave surface resistance decreased by about 40% at 20 K when the root-mean-square surface roughness was reduced from 220 nm to 110 nm through surface-polishing and ion-milling. The surface resistance was independent of surface microwave magnetic field at least up to 4 Oe and below 30 K. We attribute this behavior, and the overall low surface resistance (~0.8 mOhms at 10 GHz and 20 K), to the high density of our samples and the absence of weak links between grains.

cond-mat.supr-con

Hot isostatic pressing of powder in tube MgB2 wires

The critical current density (Jc) of hot isostatic pressed (HIPed) MgB2 wires, measured by d.c. transport and magnetization, is compared with that of similar wires annealed at ambient pressure. The HIPed wires have a higher Jc than the annealed wires, especially at high temperatures and magnetic fields, and higher irreversibility field (Hirr). The HIPed wires are promising for applications, with Jc>106 A/cm2 at 5 K and zero field and >104 A/cm2 at 1.5 T and 26.5 K, and Hirr ~ 17 T at 4 K. The improvement is attributed to a high density of structural defects, which are the likely source of vortex pinning. These defects, observed by transmission electron microscopy, include small angle twisting, tilting, and bending boundaries, resulting in the formation of sub-grains within MgB2 crystallites.

cond-mat.mtrl-sci

Defect structures in MgB2 wires introduced by hot isostatic pressing

The microstructures of MgB2 wires prepared by the powder-in-tube technique and subsequent hot isostatic pressing were investigated using transmission electron microscopy. Large amount of crystalline defects including small angle twisting, tilting, and bending boundaries, in which high densities of dislocations reside, were found forming sub-grains within MgB2 grains. It is believed that these defects resulted from particle deformation during the hot isostatic pressing process and are effective flux pinning centers that contribute to the high critical current densities of the wires at high temperatures and at high fields.

cond-mat.mtrl-sci

Mg(B,O)2 precipitation in MgB2

MgB2 samples prepared by solid-state reaction were investigated using high-resolution transmission electron microscopy (HREM), X-ray energy-dispersive spectroscopy (EDX), electron energy-loss spectroscopy (EELS), and energy-filtered imaging. Large amounts of coherent precipitates with a size range from about 5 nm up to about 100 nm were found in the MgB2 crystallite matrices. The precipitates are of different shapes including sphere, ellipsoid, and faceted polyhedron depending on the size of the precipitates. EDX and EELS analyses confirm that smaller precipitates contain magnesium, boron and oxygen while larger faceted precipitates contain mainly magnesium and oxygen, implying that the oxygen content increases with precipitate size. HREM and electron diffraction investigations found that the precipitates have the same crystal lattice structure as that of MgB2 but with various composition modulations depending on the composition of the precipitates. The precipitates transform to the MgO phase after long exposure to residual oxygen in flowing Ar gas at high temperatures. The effect of the precipitates in different size ranges on flux pinning is discussed.

cond-mat.mtrl-sci

Microstructure and high critical current of powder in tube MgB2

We report dc transport and magnetization measurements of Jc in MgB2 wires fabricated by the powder-in-tube method, using commercial MgB2 powder with 5 %at Mg powder added as an additional source of magnesium, and stainless steel as sheath material. By appropriate heat treatments, we have been able to increase Jc by more than one order of magnitude from that of the as-drawn wire. We show that one beneficial effect of the annealing is the elimination of most of the micro-cracks, and we correlate the increase in Jc with the disappearance of the weak-link-type behavior.

cond-mat.mtrl-sci

The degradation of MgB2 under ambient environment

The superconductivities of samples prepared by several procedures were found to degrade under ambient environment. The degradation mechanism was studied by measuring the change of surface chemical composition of dense MgB2 pellets (prepared by hot isostatic pressure, HIPed) under atmospheric exposure using X-ray Photoelectron Spectroscopy (XPS). Results showed that samples with poor connectivity between grains and with smaller grain sizes degrade with time when exposed to ambient conditions. In these samples, the Tc did not change with time, but the superconducting transition became broader and the Meissner fraction decreased. In contrast, our well-sintered and the HIPed samples remained stable for several months under ambient condition. The degradation was found to be related to surface decomposition as observed by XPS. We observed the formation of oxidized Mg, primarily in the form of a Mg hydroxide, the increase of C and O contents, and the reduction of B concentration in the surface layer of MgB2 samples.

cond-mat.mtrl-sci

Observation of coherent oxide precipitates in polycrystalline MgB2

Here we describe the results of an atomic resolution study of oxygen incorporation into bulk MgB2. We find that ~20-100 nm sized precipitates are formed by ordered substitution of oxygen atoms onto boron lattice sites, while the basic bulk MgB2 crystal structure and orientation is preserved. The periodicity of the oxygen ordering is dictated by the oxygen concentration in the precipitates and primarily occurs in the (010) plane. The presence of these precipitates correlates well with an improved critical current density and superconducting transition behavior, implying that they act as pinning centers.

cond-mat.supr-con

The influence of microstructures and crystalline defects on the superconductivity of MgB2

This work studies the influence of microstructures and crystalline defects on the superconductivity of MgB2, with the objective to improve its flux pinning. A MgB2 sample pellet that was hot isostatic pressed (HIPed) was found to have significantly increased critical current density (Jc) at high fields than its un-HIPed counterpart. The HIPed sample had a Jc of 10000 A/cm2 in 50000 Oe (5 T) at 5K. This was 20 times higher than that of the un-HIPed sample, and the same as the best Jc reported by other research groups. Microstructures observed in scanning and transmission electron microscopy indicate that the HIP process eliminated porosity present in the MgB2 pellet resulting in an improved intergrain connectivity. Such improvement in intergrain connectivity was believed to prevent the steep Jc drop with magnetic field H that occurred in the un-HIPed MgB2 pellet at H > 45000 Oe (4.5 T) and T = 5 K. The HIP process was also found to disperse the MgO that existed at the grain boundaries of the un-HIPed MgB2 pellet and to generate more dislocations in the HIPed the pellets. These dispersed MgO particles and dislocations improved flux pinning also at H<45000 Oe. The HIPing process was also found to lower the resistivity at room temperature.

cond-mat.mtrl-sci

Synthesis, characterization and ageing of MgB2

We studied the influence of sample preparation and defects in the superconducting properties samples using atomic ratios of Mg:B=1:1 and Mg:B=1:2. Samples were characterized by SEM, and XRD, and the magnetization properties were examined in a SQUID magnetometer. The presence of Mg vacancies was determined by Rietveld analysis. Most of the samples exhibited sharp superconducting transitions with Tcs between 37- 39 K. We found a strong correlation between the crystal strain and the Tc. This strain was related to the presence of Mg vacancies. In addition, results showed that some samples degraded with time when exposed to ambient conditions. In these samples the Tc did not change with time, but the superconducting transition became broader and the Meissner fraction decreased. This effect was only present in samples with poor connectivity between grains and smaller grain sizes. The degradation was related to a surface decomposition as observed by X-ray Photoelectron Spectroscopy. No correlation was found between this effect and the presence of Mg vacancies.

cond-mat.mtrl-sci

Effect of lattice strain and defects on the superconductivity of MgB2

The influence of lattice strain and Mg vacancies on the superconducting properties of MgB2 samples has been investigated. High quality samples with sharp superconducting transitions were synthesized. The variation in lattice strain and Mg vacancy concentrations were obtained by varying the synthesis conditions. It was found that high strain (~1%) and the presence of Mg vacancies (~ 5 %) resulted in lowering the Tc by only 2 K.

cond-mat.mtrl-sci