arXiv subjects

Yancheng Yu

Publications and source records attributed to Yancheng Yu.

4 recordsLinked to original sources

arXiv2018

The study of a new time reconstruction method for MRPC read out by waveform digitizer

The measurement of the $K^{\pm}$ production in the Semi-Inclusive Deep Inelastic Scattering (SIDIS) can provide further knowledge about the structure of nucleon, and thus it is purposed in the Solenoidal Large Intensity Device(SoLID) at Jefferson Lab(JLab). In this experiment, the identification of the kaons is planed to be accomplished with the Multi-gap Resistive Plate Chambers(MRPC), and the requirement for the time resolution is around 20 $\rm ps$. This is very challenging for the present MRPC systems (typical resolution 60 $\rm ps$), while in this paper, it is proved that the performance can be improved largely if the signal waveform is obtained and analyzed with a neural network method. In a cosmic ray experiment, the time resolution of a 6-gap 0.25$\rm mm$-thick MRPC reaches 36 $\rm ps$ with this method, and a even better performance is expected with a thinner MRPC.

physics.ins-det↗

arXiv2018

Status of technology of MRPC time of flight system

Time of flight system (TOF) based on MRPC technology is widely used in modern physics experiments, and it also plays an important role in particle identification. With the increase of accelerator energy and luminosity, TOF system is required to indentify definite particles precisely under high rate environment. The MRPC technology TOF system can be defined as three generations. The first generation TOF is based on float glass MRPC and its time resolution is around 80ps, but the rate is relatively low (typically lower than 100Hz/cm2). The typical systems are TOF of RHIC-STAR, LHC-ALICE and BES III endcap. For the second generation TOF, its time resolution is in the same order with the first generation, but the rate capability is much higher. Its rate capability can reach 30kHz/cm2. The typical experiment with this high rate TOF is FAIR-CBM. The biggest challenge is on the third generation TOF. For example, the momentum upper limit of K/PI separation is around 7GeV/c for JLab-SoLID TOF system under high particle rate as high as 20kHz/cm2, the time requirement is around 20ps. The readout electronics of first two generations is based on time over threshold method and pulse shape sampling technology will be used in the third generation TOF. In the same time, the machine learning technology is also designed to analysis the time performance. In this paper, we will describe the evolution of MRPC TOF technology and key technology of each generation TOF.

physics.ins-det↗

arXiv2018

A neural network based algorithm for MRPC time reconstruction

Multi-gap Resistive Plate Chamber(MRPC) is a widely used timing detector with a typical time resolution of about 60 ps. This makes MRPC an optimal choice for the time of flight(ToF) system in many large physics experiments. The prior work on improving the time resolution is mainly focused on altering the detector geometry, and therefore the improvement of the data analysis algorithm has not been fully explored. This paper proposes a new time reconstruction algorithm based on the deep neural networks(NN) and improves the MRPC time resolution by about 10 ps. Since the development of the high energy physics experiments has pushed the timing requirements for the MRPC to a higher level, this algorithm could become a potential substitution of the time over threshold(ToT) method to achieve a time resolution below 30 ps.

physics.ins-det↗

arXiv2018

A standalone simulation framework of the MRPC detector read out in waveforms

Dedicated detector simulations are very important for the success of high energy physics experiments. They not only bring benefits to the optimization of the detectors, but can also improve the precision of the physics results. To design a Multi-gap Resistive Plate Chamber (MRPC) with a very good time resolution, a detailed monte-carlo simulation of the detector is needed and described in this paper. The simulation can produce detector signal waveforms which contain a complete information about the events. The detector performance filled with different gas mixtures is studied, and comparison between simulation and experimental results show a good agreement.

physics.ins-det↗