arXiv subjects

Yanjun Xu

Publications and source records attributed to Yanjun Xu.

41 records · Page 3Linked to original sources

arXiv2016

Thickness dependence of spin Hall magnetoresistance in FeMn/Pt bilayers

We investigated spin Hall magnetoresistance in FeMn/Pt bilayers, which was found to be one order of magnitude larger than that of heavy metal and insulating ferromagnet or antiferromagnet bilayer systems, and comparable to that of NiFe/Pt bilayers. The spin Hall magnetoresistance shows a non-monotonic dependence on the thicknesses of both FeMn and Pt. The former can be accounted for by the thickness dependence of net magnetization in FeMn thin films, whereas the latter is mainly due to spin accumulation and diffusion in Pt. Through analysis of the Pt thickness dependence, the spin Hall angle, spin diffusion length of Pt and the real part of spin mixing conductance were determined to be 0.2, 1.1 nm, and $5.5 * 10^{14} Ω^{-1} m^{-2}$, respectively. The results corroborate the spin orbit torque effect observed in this system recently.

cond-mat.mes-hall↗

arXiv2016

Field-like spin orbit torque in ultra-thin polycrystalline FeMn films

Field-like spin orbit torque in FeMn/Pt bilayers with ultra-thin polycrystalline FeMn has been characterized through planar Hall effect measurements. A large effective field is obtained for FeMn in the thickness range of 2 to 5 nm. The experimental observations can be reasonably accounted for by using a macro-spin model under the assumption that the FeMn layer is composed of two spin sublattices with unequal magnetizations. The large effective field corroborates the spin Hall origin of the effective field considering the much smaller uncompensated net moments in FeMn as compared to NiFe. The effective absorption of spin current by FeMn is further confirmed by the fact that spin current generated by Pt in NiFe/FeMn/Pt trilayers can only travel through the FeMn layer with a thickness of 1 to 4 nm. By quantifying the field-like effective field induced in NiFe, a spin diffusion length of 2 nm is estimated in FeMn, in consistence with values reported in literature by ferromagnetic resonance and spin-pumping experiments.

cond-mat.mes-hall↗

arXiv2016

Detection and localization of continuous gravitational waves with pulsar timing arrays: the role of pulsar terms

A pulsar timing array is a Galactic-scale detector of nanohertz gravitational waves (GWs). Its target signals contain two components: the `Earth term' and the `pulsar term' corresponding to GWs incident on the Earth and pulsar respectively. In this work we present a Frequentist method for the detection and localization of continuous waves that takes into account the pulsar term and is significantly faster than existing methods. We investigate the role of pulsar terms by comparing a full-signal search with an Earth-term-only search for non-evolving black hole binaries. By applying the method to synthetic data sets, we find that (i) a full-signal search can slightly improve the detection probability (by about five percent); (ii) sky localization is biased if only Earth terms are searched for and the inclusion of pulsar terms is critical to remove such a bias; (iii) in the case of strong detections (with signal-to-noise ratio $\gtrsim$ 30), it may be possible to improve pulsar distance estimation through GW measurements.

astro-ph.IM↗

arXiv2016

Self-current induced spin-orbit torque in FeMn/Pt multilayers

Extensive efforts have been devoted to the study of spin-orbit torque in ferromagnetic metal/heavy metal bilayers and exploitation of it for magnetization switching using an in-plane current. As the spin-orbit torque is inversely proportional to the thickness of the ferromagnetic layer, sizable effect has only been realized in bilayers with an ultrathin ferromagnetic layer. Here we demonstrate that, by stacking ultrathin Pt and FeMn alternately, both ferromagnetic properties and current induced spin-orbit torque can be achieved in FeMn/Pt multilayers without any constraint on its total thickness. The critical behavior of these multilayers follows closely three-dimensional Heisenberg model with a finite Curie temperature distribution. The spin torque effective field is about 4 times larger than that of NiFe/Pt bilayer with a same equivalent NiFe thickness. The self-current generated spin torque is able to switch the magnetization reversibly without the need for an external field or a thick heavy metal layer. The removal of both thickness constraint and necessity of using an adjacent heavy metal layer opens new possibilities for exploiting spin-orbit torque for practical applications.

cond-mat.mtrl-sci↗

arXiv2015

Electrical Oscillation in Pt/VO2 Bilayer Strips

We report on the observation of stable electrical oscillation in Pt/VO2 bilayer strips, in which the Pt overlayer serves the dual purposes of heating up the VO2 and weakening the electric field in the VO2 layer. Systematic measurements in an ultrahigh vacuum nanoprobe system show that the oscillation frequency increases with the bias current and/or with decreasing device dimension. In contrast to most VO2-based oscillators reported to date, which are electrically triggered, current-induced Joule heating in the Pt overlayer is found to play a dominant role in the generation of oscillation in Pt/VO2 bilayers. A simple model involving thermally triggered transition of VO2 on a heat sink is able to account for the experimental observations. The results in this work provide an alternative view of the triggering mechanism in VO2-based oscillators.

cond-mat.str-el↗