arXiv subjects

Yaoliang Song

Publications and source records attributed to Yaoliang Song.

6 recordsLinked to original sources

arXiv2025

Machine Learning-based Near-field Emitter Location Sensing via Grouped Hybrid Analog and Digital XL-MIMO Receive Array

As a green MIMO structure, the partially-connected hybrid analog and digital (PC-HAD) structure has been widely used in the far-field (FF) scenario for it can significantly reduce the hardware cost and complexity of large-scale or extremely large-scale MIMO (XL-MIMO) array. Recently, near-field (NF) emitter localization including direction-of-arrival (DOA) and range estimations has drawn a lot of attention, but is rarely explored via PC-HAD structure. In this paper, we first analyze the impact of PC-HAD structure on the NF emitter localization and observe that the phase ambiguity (PA) problem caused by PC-HAD structure can be removed inherently with low-latency in the NF scenario. To obtain the exact NF DOA estimation results, we propose a grouped PC-HAD structure, which is capable of dividing the NF DOA estimation problem into multiple FF DOA estimation problems via partitioning the large-scale PC-HAD array into small-scale groups. An angle calibration method is developed to address the inconsistency among these FF DOA estimation problems. Then, to eliminate PA and improve the NF emitter localization performance, we develop three machine learning (ML)-based methods, i.e., two low-complexity data-driven clustering-based methods and one model-driven regression method, namely RegNet. Furthermore, the Cramer-Rao lower bound (CRLB) of NF emitter localization for the proposed grouped PC-HAD structure is derived and reveals that localization performance will decrease with the increasing of the number of groups. The simulation results show that the proposed methods can achieve CRLB at different SNR regions, the RegNet has great performance advantages at low SNR regions and the clustering-based methods have much lower computation complexity.

eess.SP↗

arXiv2025

DNN-based Enhanced DOA Sensing via Massive MIMO Receiver with Switches-based Hybrid Architecture

Switches-based hybrid architecture has attracted much attention, especially in directional-of-arrival (DOA) sensing, due to its ability of significantly reducing the hardware cost by compressing massive multiple-input multiple-output (MIMO) arrays with switching networks. However, this structure will lead to a degradation in the degrees of freedom (DOF) and accuracy of DOA estimation. To address these two issues, we first propose a switches-based sparse hybrid array (SW-SHA). In this method, we design a dynamic switching network to form a synthesized sparse array, i.e., SW-SHA, that can enlarge the virtual aperture obtained by the difference co-array, thereby significantly enhancing the DOF. Second, in order to improve the DOA estimation accuracy of switches-based hybrid arrays, a deep neural network (DNN)-based method called ASN-DNN is proposed. It includes an antenna selection network (ASN) for optimizing the switch connections based on the criterion of minimizing the Cramer-Rao lower bound (CRLB) under the peak sidelobe level (PSL) constraint and a DNN for DOA estimation. Then by integrating ASN and DNN into an iterative process, the ASN-DNN is obtained. Furthermore, the closed-form expression of CRLB for DOA estimation is derived to evaluate the performance lower bound of switches-based hybrid arrays and provide a benchmark for ASN-DNN. The simulation results show the proposed ASN-DNN can achieve a greater performance than traditional methods, especially in the low signal-to-noise ratio (SNR) regions.

eess.SP↗

arXiv2024

A Novel Tree Model-based DNN to Achieve a High-Resolution DOA Estimation via Massive MIMO receive array

To satisfy the high-resolution requirements of direction-of-arrival (DOA) estimation, conventional deep neural network (DNN)-based methods using grid idea need to significantly increase the number of output classifications and also produce a huge high model complexity. To address this problem, a multi-level tree-based DNN model (TDNN) is proposed as an alternative, where each level takes small-scale multi-layer neural networks (MLNNs) as nodes to divide the target angular interval into multiple sub-intervals, and each output class is associated to a MLNN at the next level. Then the number of MLNNs is gradually increasing from the first level to the last level, and so increasing the depth of tree will dramatically raise the number of output classes to improve the estimation accuracy. More importantly, this network is extended to make a multi-emitter DOA estimation. Simulation results show that the proposed TDNN performs much better than conventional DNN and root-MUSIC at extremely low signal-to-noise ratio (SNR), and can achieve Cramer-Rao lower bound (CRLB). Additionally, in the multi-emitter scenario, the proposed Q-TDNN has also made a substantial performance enhancement over DNN and Root-MUSIC, and this gain grows as the number of emitters increases.

eess.SP↗

arXiv2023

Machine Learning Methods for Inferring the Number of UAV Emitters via Massive MIMO Receive Array

To provide important prior knowledge for the DOA estimation of UAV emitters in future wireless networks, we present a complete DOA preprocessing system for inferring the number of emitters via massive MIMO receive array. Firstly, in order to eliminate the noise signals, two high-precision signal detectors, square root of maximum eigenvalue times minimum eigenvalue (SR-MME) and geometric mean (GM), are proposed. Compared to other detectors, SR-MME and GM can achieve a high detection probability while maintaining extremely low false alarm probability. Secondly, if the existence of emitters is determined by detectors, we need to further confirm their number. Therefore, we perform feature extraction on the the eigenvalue sequence of sample covariance matrix to construct feature vector and innovatively propose a multi-layer neural network (ML-NN). Additionally, the support vector machine (SVM), and naive Bayesian classifier (NBC) are also designed. The simulation results show that the machine learning-based methods can achieve good results in signal classification, especially neural networks, which can always maintain the classification accuracy above 70\% with massive MIMO receive array. Finally, we analyze the classical signal classification methods, Akaike (AIC) and Minimum description length (MDL). It is concluded that the two methods are not suitable for scenarios with massive MIMO arrays, and they also have much worse performance than machine learning-based classifiers.

eess.SP↗

arXiv2022

Deep Learning Based DOA Estimation for Hybrid Massive MIMO Receive Array with Overlapped Subarrays

To improve the accuracy of direction-of-arrival (DOA) estimation, a deep learning (DL)-based method called CDAE-DNN is proposed for hybrid analog and digital (HAD) massive MIMO receive array with overlapped subarray (OSA) architecture in this paper. In the proposed method, the sample covariance matrix (SCM) is first input to a convolution denoise autoencoder (CDAE) to remove the approximation error, then the output of CDAE is imported to a fully-connected (FC) network to get the estimation result. Based on the simulation results, the proposed CDAE-DNN has great performance advantages over traditional MUSIC algorithm and CNN-based method, especially in the situations with low signal to noise ratio (SNR) and low snapshot numbers. And the OSA architecture has also been shown to significantly improve the estimation accuracy compared to non-overlapped subarray (NOSA) architecture. In addition, the Cramer-Rao lower bound (CRLB) for the HAD-OSA architecture is presented.

eess.SP↗

arXiv2020

Enhanced RSS-based UAV Localization via Trajectory and Multi-base Stations

To improve the localization precision of unmanned aerial vehicle (UAV), a novel framework is established by jointly utilizing multiple measurements of received signal strength (RSS) from multiple base stations (BSs) and multiple points on trajectory. First, a joint maximum likelihood (ML) of exploiting both trajectory information and multi-BSs is proposed. To reduce its high complexity, two low-complexity localization methods are designed. The first method is from BS to trajectory (BST), called LCSL-BST. First, fixing the nth BS, by exploiting multiple measurements along trajectory, the position of UAV is computed by ML rule. Finally, all computed positions of UAV for different BSs are combined to form the resulting position. The second method reverses the order, called LCSL-TBS. We also derive the Cramer-Rao lower boundary (CRLB) of the joint ML method. From simulation results, we can see that the proposed joint ML and separate LCSL-BST methods have made a significant improvement over conventional ML method without use of trajectory knowledge in terms of location performance. The former achieves the joint CRLB and the latter is of low-complexity.

eess.SP↗