Searcharxiv⌕ Search

arXiv subjects

Yi Jin

Publications and source records attributed to Yi Jin.

At least 109 records · Page 6Linked to original sources
arXiv2016

Large production rate of new $B^0_s π^{\pm}$ and $D^{\pm}_s π^{\pm}$ states in high energy multi-production process

The production rate of the X(5568) observed by D0 collabotation is quite large and can not be understood by various general hadronization mechanism. We propose an inclusive resonance production formulation to calculate the cross section and extract the value of the effective wave function at origin. Based on these results we suspect X($D_s π^{\pm}$) can be copiously produced and observable at high enenrgy scatterings (the relative production ratio to D_s is larger than 10 %). In the updated version the discussions on cluster model and FI are added. Both cases can not give large rate. Then we show that pion in X(5568) decay can only gain a very small momentum. In the pseudo-rapidity region [2,5], large part of the signal pions will be dismissed by the detector since the transverse mometum is too small and/or total momentum too small. If further requirement on pion tranverse mometum larger than 1GeV/c added, almost all signal pions are rejected. But for the charm partner, this problem does not exist since the charm partner can give a larger boost factor. A 3D distribution of signal pions are added

hep-ph↗
arXiv2014

Keeping speed and distance for aligned motion

The cohesive collective motion (flocking, swarming) of autonomous agents is ubiquitously observed and exploited in both natural and man-made settings, thus, minimal models for its description are essential. In a model with continuous space and time we find that if two particles arrive symmetrically in a plane at a large angle, then (i) radial repulsion and (ii) linear self-propelling toward a fixed preferred speed are sufficient for them to depart at a smaller angle. For this local gain of momentum explicit velocity alignment is not necessary, nor are adhesion/attraction, inelasticity or anisotropy of the particles, or nonlinear drag. With many particles obeying these microscopic rules of motion we find that their spatial confinement to a square with periodic boundaries (which is an indirect form of attraction) leads to stable macroscopic ordering. After varying the density of particles at constant system size and varying the size of the system with constant particle density we predict that in the infinite system size (or density) limit the hysteresis loop disappears and the transition becomes continuous. We note that animals, humans, drones, etc. tend to move asynchronously and are often more responsive to motion than positions. Thus, for them velocity-based continuous models can provide higher precision than coordinate-based models. An additional characteristic and realistic feature of the model is that convergence to the ordered state is fastest at a finite density, which is in contrast to models applying (discontinuous) explicit velocity alignments and discretized time. In summary, we find that the investigated model can provide a minimal description of flocking.

cond-mat.stat-mech↗
arXiv2014

Plasmonic and Metamaterial Structures as Electromagnetic Absorbers

Electromagnetic absorbers have drawn increasing attention in many areas. A series of plasmonic and metamaterial structures can work as efficient narrow band absorbers due to the excitation of plasmonic or photonic resonances, providing a great potential for applications in designing selective thermal emitters, bio-sensing, etc. In other applications such as solar energy harvesting and photonic detection, the bandwidth of light absorbers is required to be quite broad. Under such a background, a variety of mechanisms of broadband/multiband absorption have been proposed, such as mixing multiple resonances together, exciting phase resonances, slowing down light by anisotropic metamaterials, employing high loss materials and so on.

physics.optics↗
arXiv2014

Search for doubly charmed hadron at B factory

The doubly charmed hadron production at B factories is of special importance for the study of the hadron structure and the color connections before hadronization. To suppress the combination background fluctuations of the reconstructed hadron mass spectra, we suggest a three-jet event shape trigger. After these three jets are identified by their energy and angular distributions, it is found that: 1) The background process $e^+ e^- \to c\bar {c} \to h's$ in consideration of the final hadron system $Λ_c^+K^-π^+ +X$ are significantly suppressed. 2) For the selected events, about half of the particles, $Λ_c^+$, $K^-$, $π^+$, which obviously can not belong to the decay products of doubly charmed hadron, can be vetoed. The relevant hadronization is investigated.

hep-ph↗
arXiv2014

Colour connections of four quark $Q\bar{Q}Q'\bar{Q}'$ system and doubly heavy baryon production in $e^{+}e^{-}$ annihilation

The hadronization effects induced by various colour connections of the four quark system in $e^{+}e^{-}$ annihilation are briefly reviewed. A special colour connection of four heavy quark system without colour-separation favours the production of doubly heavy baryons. For the related three-jet case, the corresponding hadronization has not been considered. We argue that it can be effectively described as two string fragmentation besides the leading heavy diquark fragmentation. The production rate and the properties of final state hadron systems are discussed. Emphasis is on the string effect as a finger print of this hadronization procedure.

hep-ph↗
arXiv2014

Compositional Belief Update

In this paper we explore a class of belief update operators, in which the definition of the operator is compositional with respect to the sentence to be added. The goal is to provide an update operator that is intuitive, in that its definition is based on a recursive decomposition of the update sentences structure, and that may be reasonably implemented. In addressing update, we first provide a definition phrased in terms of the models of a knowledge base. While this operator satisfies a core group of the benchmark Katsuno-Mendelzon update postulates, not all of the postulates are satisfied. Other Katsuno-Mendelzon postulates can be obtained by suitably restricting the syntactic form of the sentence for update, as we show. In restricting the syntactic form of the sentence for update, we also obtain a hierarchy of update operators with Winsletts standard semantics as the most basic interesting approach captured. We subsequently give an algorithm which captures this approach; in the general case the algorithm is exponential, but with some not-unreasonable assumptions we obtain an algorithm that is linear in the size of the knowledge base. Hence the resulting approach has much better complexity characteristics than other operators in some situations. We also explore other compositional belief change operators: erasure is developed as a dual operator to update; we show that a forget operator is definable in terms of update; and we give a definition of the compositional revision operator. We obtain that compositional revision, under the most natural definition, yields the Satoh revision operator.

cs.AI↗
arXiv2011

Ultra-broadband Microwave Metamaterial Absorber

A microwave ultra-broadband polarization-independent metamaterial absorber is demonstrated. It is composed of a periodic array of metal-dielectric multilayered quadrangular frustum pyramids. These pyramids possess resonant absorption modes at multi-frequencies, of which the overlapping leads to the total absorption of the incident wave over an ultra-wide spectral band. The experimental absorption at normal incidence is above 90% in the frequency range of 7.8-14.7GHz, and the absorption is kept large when the incident angle is smaller than 60 degrees. The experimental results agree well with the numerical simulation.

physics.optics↗
arXiv2011

Ultra-broadband Light Absorption by a Sawtooth Anisotropic Metamaterial Slab

We present an ultra broadband thin-film infrared absorber made of saw-toothed anisotropic metamaterial. Absorbtivity of higher than 95% at normal incidence is supported in a wide range of frequencies, where the full absorption width at half maximum is about 86%. Such property is retained well at a very wide range of incident angles too. Light of shorter wavelengths are harvested at upper parts of the sawteeth of smaller widths, while light of longer wavelengths are trapped at lower parts of larger tooth widths. This phenomenon is explained by the slowlight modes in anisotropic metamaterial waveguide. Our study can be applied in the field of designing photovoltaic devices and thermal emitters.

physics.optics↗
arXiv2011

A Thin Film Broadband Absorber Based on Multi-sized Nanoantennas

We experimentally demonstrate an infrared broadband absorber for TM polarized light based on an array of nanostrip antennas of several different sizes. The broadband property is due to the collective effect of magnetic responses excited by these nano-antennas at distinct wavelengths. By manipulating the differences of the nanostrip widths, the measured spectra clearly validate our design for the purpose of broadening the absorption band. The present broadband absorber works very well in a wide angular range.

physics.optics↗
arXiv2010

Abnormal enhancement of electric field inside a thin permittivity-near-zero object in free space

It is found that the electric field can be enhanced strongly inside a permittivity-near-zero object in free space, when the transverse cross section of the object is small and the length along the propagation direction of the incident wave is large enough as compared with the wavelength. The physical mechanism is explained in details. The incident electromagnetic energy can only flow almost normally through the outer surface into or out of the permittivity-near-zero object, which leads to large energy stream density and then strong electric field inside the object. Meanwhile, the magnetic field inside the permittivity-near-zero object may be smaller than that of the incident wave, which is also helpful for enhancing the electric field. Two permittivity-near-zero objects of simple shapes, namely, a thin cylindrical shell and a long thin rectangular bar, are chosen for numerical illustration. The enhancement of the electric field becomes stronger when the permittivity-near-zero object becomes thinner. The physical mechanism of the field enhancement is completely different from the plasmonic resonance enhancement at a metal surface.

physics.optics↗
arXiv2010

Enhancing and suppressing radiation with some permeability-near-zero structures

Using some special properties of a permeability-near-zero material, the radiation of a line current is greatly enhanced by choosing appropriately the dimension of a dielectric domain in which the source lies and that of a permeability-near-zero shell. The radiation of the source can also be completely suppressed by adding appropriately another dielectric domain or an arbitrary perfect electric conductor (PEC) inside the shell. Enhanced directive radiation is also demonstrated by adding a PEC substrate.

physics.optics↗
arXiv2010

Unitarity and Entropy Change in Exclusive Quark Combination Models

Entropy change in exclusive quark combination models is not an isolated problem. Contrary to adding and tuning some parameters to the relevant model(s) to fix the entropy, we show that it relates to the most general principles. Unitarity of the combination model is demonstrated to play the central rôle that guarantees the non-decrease of the entropy in the exclusive combination process.

hep-ph↗
arXiv2010

An Investigation of Hadronization Mechanism at $Z^{0}$ Factory

We briefly review the hadronization pictures adopted in the LUND String Fragmentation Model(LSFM), Webber Cluster Fragmentation Model(WCFM) and Quark Combination Model(QCM), respectively. Predictions of hadron multiplicity, baryon to meson ratios and baryon-antibaryon flavor correlations, especially related to heavy hadrons at $Z^0$ factory obtained by LSFM and QCM are reported.

hep-ph↗
arXiv2010

Squeezing electromagnetic energy with a dielectric split ring inside a permeability-near-zero metamaterial

A novel electromagnetic energy squeezing mechanism is proposed based on the special properties of permeability-near-zero metamaterials. Nearly no energy stream can enter a conventional dielectric region positioned inside a permeability-near-zero material. When a source is surrounded by a dielectric split ring (encloser with a gap opened), the electromagnetic energy generated by the source is forced to propagate through the gap. When the gap is narrow, the energy stream density becomes very large and makes the magnetic field enhanced drastically in the gap. The narrow gap can be long and bended. This provides us a method to obtain strong magnetic field without using resonance enhancement.

physics.optics↗
arXiv2009

Inverse Transformation Optics and Reflection Analysis for Two-Dimensional Finite Embedded Coordinate Transformation

Inverse transformation optics is introduced, and used to calculate the reflection at the boundary of a transformation medium under consideration. The transformation medium for a practical device is obtained from a two-dimensional (2D) finite embedded coordinate transformation (FECT) which is discontinuous at the boundary. For an electromagnetic excitation of particular polarization, many pairs of original medium (in a virtual space V') and inverse transformation can give exactly the same anisotropic medium through the conventional procedure of transformation optics. Non-uniqueness of these pairs is then exploited for the analysis and calculation of the boundary reflection. The reflection at the boundary of the anisotropic FECT medium (associated with the corresponding vacuum virtual space V) is converted to the simple reflection between two isotropic media in virtual space V' by a selected inverse transformation continuous at the boundary. A reflectionless condition for the boundary of the FECT medium is found as a special case. The theory is verified numerically with the finite element method.

physics.optics↗
arXiv2009

Omni-directional, broadband and polarization-insensitive thin absorber in the terahertz regime

A nearly omni-directional THz absorber for both transverse electric (TE) and transverse magnetic (TM) polarizations is proposed. Through the excitation of magnetic polariton in a metal-dielectric layer, the incident light is perfectly absorbed in a thin thickness which is about 25 times smaller than the resonance wavelength. By simply stacking several such structural layers with different geometrical dimensions, the bandwidth of this strong absorption can be effectively enhanced due to the hybridization of magnetic polaritons in different layers.

physics.optics↗
arXiv2009

Enhanced transmission of transverse electric waves through subwavelength slits in a thin metallic film

y coating a cover layer with metallization of cut wire array, the transmission of transverse electric waves (TE; the electric field is parallel to the slits) through subwavelength slits in a thin metallic film is significantly enhanced. An 800-fold enhanced transmission is obtained compared to the case without the cut wires. It is demonstrated that a TE incident wave is highly confined by the cut wires due to the excitation of the electric dipole-like resonance, and then effectively squeezed into and through the subwavelength slits.

physics.optics↗