Youri Sharabian | Searcharxiv

arXiv2021

Determination of two-photon exchange via $e^+p/e^-p$ Scattering with CLAS12

The proton elastic form factor ratio shows a discrepancy between measurements using the Rosenbluth technique in unpolarized beam and target experiments and measurements using polarization degrees of freedom. The proposed explanation of this discrepancy is uncorrected hard two-photon exchange (TPE), a type of radiative correction that is conventionally neglected. The effect size and agreement with theoretical predictions has been tested recently by three experiments. While the results support the existence of a small two-photon exchange effect, they cannot establish that theoretical treatments are valid. At larger momentum transfers, theory remains untested. This proposal aims to measure two-photon exchange over an extended and so far largely untested $Q^2$ and $\varepsilon$ range with high precision using the {\tt CLAS12} experiment. Such data are crucial to clearly confirm or rule out TPE as the driver for the discrepancy as well as test several theoretical approaches, believed valid in different parts of the tested $Q^2$ range.

nucl-ex↗

arXiv2015

The Heavy Photon Search Test Detector

The Heavy Photon Search (HPS), an experiment to search for a hidden sector photon in fixed target electroproduction, is preparing for installation at the Thomas Jefferson National Accelerator Facility (JLab) in the Fall of 2014. As the first stage of this project, the HPS Test Run apparatus was constructed and operated in 2012 to demonstrate the experiment's technical feasibility and to confirm that the trigger rates and occupancies are as expected. This paper describes the HPS Test Run apparatus and readout electronics and its performance. In this setting, a heavy photon can be identified as a narrow peak in the e$^+$e$^-$ invariant mass spectrum, above the trident background or as a narrow invariant mass peak with a decay vertex displaced from the production target, so charged particle tracking and vertexing are needed for its detection. In the HPS Test Run, charged particles are measured with a compact forward silicon microstrip tracker inside a dipole magnet. Electromagnetic showers are detected in a PbW0$_{4}$ crystal calorimeter situated behind the magnet, and are used to trigger the experiment and identify electrons and positrons. Both detectors are placed close to the beam line and split top-bottom. This arrangement provides sensitivity to low-mass heavy photons, allows clear passage of the unscattered beam, and avoids the spray of degraded electrons coming from the target. The discrimination between prompt and displaced e$^+$e$^-$ pairs requires the first layer of silicon sensors be placed only 10~cm downstream of the target. The expected signal is small, and the trident background huge, so the experiment requires very large statistics. Accordingly, the HPS Test Run utilizes high-rate readout and data acquisition electronics and a fast trigger to exploit the essentially 100% duty cycle of the CEBAF accelerator at JLab.

physics.ins-det↗