arXiv subjects

Yuimaru Kubo

Publications and source records attributed to Yuimaru Kubo.

8 recordsLinked to original sources

arXiv2026

Controlling the Inhomogeneous Broadening and Impedance Matching of a Spin Ensemble

We control the spectral distribution of a spin ensemble by applying a magnetic field gradient using an anti-Helmholtz coil inside a dilution refrigerator, and demonstrate impedance matching between the ensemble and a transmission line, achieving -50 dB absorption of incident radiation. This represents a first step toward a spin-ensemble-based quantum memory for itinerant microwave photons. We further model the spectral distribution under the applied gradient to predict the spin-resonator response, and use the device to systematically tune the weak-to-strong coupling transition in both continuous-wave and time-domain pulsed measurements.

quant-ph↗

arXiv2025

A near-quantum-limited diamond maser amplifier operating at millikelvin temperatures

Microwave quantum technologies require amplification of weak signals with minimal added noise at millikelvin temperatures. This stringent demand has been met with superconducting parametric amplifiers. While masers offer another fundamental approach, their dependence on cryogenic operation has historically posed challenges for classical communication technologies -- a barrier that does not apply to microwave quantum technologies. In this work, we demonstrate an ultra-low-noise maser amplifier utilizing impurity spins in diamond at millikelvin temperatures. We achieve power gains exceeding $\mathrm{30\,dB}$, a minimum noise temperature of $\mathrm{0.86\,K}$ (corresponding to $2.2$ noise photons), and a maximum $\mathrm{1\,\text{dB}}$ output compression point of $\mathrm{-63\,dBm}$ at $\mathrm{6.595\,\text{GHz}}$. Our results establish masers as viable components of microwave quantum technologies.

quant-ph↗

arXiv2025

Stabilizing an optical cavity containing a bulk diamond crystal at millikelvin temperatures in a cryogen-free dilution refrigerator

We successfully stabilized a Fabry-P\'erot optical cavity incorporating a bulk diamond crystal at millikelvin temperatures in a cryogen-free dilution refrigerator with the pulse-tube cryocooler running. In stark contrast to previous demonstrations where lasers were locked to the cavities, our setup locks the cavity to a laser. Our measurements of cavity length fluctuation suggest that the setup could stabilize a cavity up to a finesse of $1.2\times 10^4$ without the diamond and $5.8 \times10^3$ with the diamond crystal. The finesse with a diamond crystal of approximately 90 is primarily limited by the absorption loss inside the diamond.

quant-ph↗

arXiv2024

Dielectric microwave resonator with large optical apertures for spin-based quantum devices

Towards a spin-based quantum microwave-optical photon transducer, we demonstrate a low-loss dielectric microwave resonator with an internal quality factor of $2.30\times10^4$ while accommodating optical apertures with a diameter of $8\, \mathrm{mm}$. The two seemingly conflicting requirements, high quality factor and large optical apertures, are satisfied thanks to the large dielectric constant of rutile ($\mathrm{TiO_2}$). The quality factor is limited by radiation loss, and we confirmed by numerical simulation that this dielectric resonator can achieve a quality factor exceeding $10^6$ by extending the height of the resonator enclosure. Using this resonator, we performed both continuous-wave (cw) and pulse electron spin resonance (ESR) spectroscopy on 2,2-diphenyl-1-picrylhydrazyl (DPPH) crystalline powder and P1 centers in a diamond crystal in a dilution refrigerator. The cw ESR spectroscopy demonstrated high-cooperativity and strong spin-resonator coupling with the DPPH and P1 centers respectively, while the pulse ESR spectroscopy successfully measured longitudinal and transverse relaxation times.

quant-ph↗

arXiv2018

Loop-gap Microwave Resonator for Hybrid Quantum Systems

We designed a loop-gap microwave resonator for applications of spin-based hybrid quantum systems, and tested it with impurity spins in diamond. Strong coupling with ensembles of nitrogen-vacancy (NV) centers and substitutional nitrogen (P1) centers was observed. These results show that loop-gap resonators are viable in the prospect of spin-based hybrid quantum systems, especially for an ensemble quantum memory or a quantum transducer.

quant-ph↗

arXiv2014

Flux Qubits with Long Coherence Times for Hybrid Quantum Circuits

We present measurements of superconducting flux qubits embedded in a three dimensional copper cavity. The qubits are fabricated on a sapphire substrate and are measured by coupling them inductively to an on-chip superconducting resonator located in the middle of the cavity. At their flux-insensitive point, all measured qubits reach an intrinsic energy relaxation time in the 6-20 microseconds range and a pure dephasing time comprised between 3 and 10 microseconds. This significant improvement over previous works opens the way to the coherent coupling of a flux-qubit to individual spins.

cond-mat.mes-hall↗

arXiv2013

Macroscopic quantum tunneling and phase diffusion in a La$_{2-x}$Sr$_x$CuO$_4$ intrinsic Josephson junction stack

We performed measurements of switching current distribution in a submicron La$_{2-x}$Sr$_x$CuO$_4$ (LSCO) intrinsic Josephson junction (IJJ) stack in a wide temperature range. The escape rate saturates below approximately 2\,K, indicating that the escape event is dominated by a macroscopic quantum tunneling (MQT) process with a crossover temperature $T^{*}\approx2\,$K. We applied the theory of MQT for IJJ stacks, taking into account dissipation and the phase re-trapping effect in the LSCO IJJ stack. The theory is in good agreement with the experiment both in the MQT and in the thermal activation regimes.

cond-mat.supr-con↗

arXiv2011

Fabrication of submicron La$_{2-x}$Sr$_{x}$CuO$_{4}$ intrinsic Josephson junction stacks

Intrinsic Josephson junction (IJJ) stacks of cuprate superconductors have potential to be implemented as intrinsic phase qubits working at relatively high temperatures. We report success in fabricating submicron La$_{2-x}$Sr$_{x}$CuO$_{4}$ (LSCO) IJJ stacks carved out of single crystals. We also show a new fabrication method in which argon ion etching is performed after focused ion beam etching. As a result, we obtained an LSCO IJJ stack in which resistive multi-branches appeared. It may be possible to control the number of stacked IJJs with an accuracy of a single IJJ by developing this method.

cond-mat.supr-con↗