arXiv subjects

Yuta Michimura

Publications and source records attributed to Yuta Michimura.

At least 73 records · Page 4Linked to original sources

arXiv2019

Design and experimental demonstration of a laser modulation system for future gravitational-wave detectors

Detuning the signal-recycling cavity length from a cavity resonance significantly improves the quantum noise beyond the standard quantum limit, while there is no km-scale gravitational-wave detector successfully implemented the technique. The detuning technique is known to introduce great excess noise, and such noise can be reduced by a laser modulation system with two Mach-Zehnder interferometers in series. This modulation system, termed Mach-Zehnder Modulator (MZM), also makes the control of the gravitational-wave detector more robust by introducing the third modulation field which is non-resonant in any part of the main interferometer. On the other hand, mirror displacements of the Mach-Zehnder interferometers arise a new kind of noise source coupled to the gravitational-wave signal port. In this paper, the displacement noise requirement of the MZM is derived, and also results of our proof-of-principle experiment is reported.

astro-ph.IM↗

arXiv2019

Influence of non-uniformity in sapphire substrates for a gravitational wave telescope

Construction of a large-scale cryogenic gravitational-wave telescope KAGRA has been completed and the four sapphire test masses have been installed in cryostat vacuum chambers. It recently turned out that a sapphire substrate used for one of the input test masses shows a characteristic strcuture in its transmission map due to non-uniformity of the crystal. We performed an interferometer simulation to see the influence of the non-uniformity using measured transmission/reflection maps.

astro-ph.IM↗

arXiv2019

Mirror actuation design for the interferometer control of the KAGRA gravitational wave telescope

KAGRA is a 3-km cryogenic interferometric gravitational wave telescope located at an underground site in Japan. In order to achieve its target sensitivity, the relative positions of the mirrors of the interferometer must be finely adjusted with attached actuators. We have developed a model to simulate the length control loops of the KAGRA interferometer with realistic suspension responses and various noises for mirror actuation. Using our model, we have designed the actuation parameters to have sufficient force range to acquire lock as well as to control all the length degrees of freedom without introducing excess noise.

physics.ins-det↗

arXiv2019

Prospects for improving the sensitivity of KAGRA gravitational wave detector

KAGRA is a new gravitational wave detector which aims to begin joint observation with Advanced LIGO and Advanced Virgo from late 2019. Here, we present KAGRA's possible upgrade plans to improve the sensitivity in the decade ahead. Unlike other state-of-the-art detectors, KAGRA requires different investigations for the upgrade since it is the only detector which employs cryogenic cooling of the test mass mirrors. In this paper, investigations on the upgrade plans which can be realized by changing the input laser power, increasing the mirror mass, and injecting frequency dependent squeezed vacuum are presented. We show how each upgrade affects to the detector frequency bands and also discuss impacts on gravitational-wave science. We then propose an effective progression of upgrades based on technical feasibility and scientific scenarios.

gr-qc↗

arXiv2019

Prospects for gravitational-wave polarization test from compact binary mergers with future ground-based detectors

There exist six possible polarization modes of gravitational waves in general metric theory of gravity, while two tensor polarization modes are allowed in general relativity. The properties and number of polarization modes depend on gravity theories. The number of the detectors needs to be equal to the number of the polarization modes of the gravitational waves for separation of polarizations basically. However, a single detector having great sensitivity at lower frequency could be effectively regarded as a virtual detector network including a set of detectors along its trajectory due to a long GW signal from a compact binary and the Earth's rotation. Thus, time-varying antenna pattern functions can help testing the polarizations of gravitational waves. We study the effects of the Earth's rotation on the polarization test and show a possibility to test the non-tensorial polarization modes from future observations of compact binary mergers with ground-based gravitational detectors such as Einstein telescope and Cosmic Explorer.

gr-qc↗

arXiv2019

Torsion-bar antenna: a ground-based mid-frequency and low-frequency gravitational wave detector

Expanding the observational frequency of gravitational waves is important for the future of astronomy. Torsion-Bar Antenna (TOBA) is a mid-frequency and low-frequency gravitational wave detector using a torsion pendulum. The low resonant frequency of the rotational mode of the torsion pendulum enables ground-based observations. The overview of TOBA, including the past and present status of the prototype development is summarized in this paper.

physics.ins-det↗

arXiv2018

Particle swarm optimization of the sensitivity of a cryogenic gravitational wave detector

Cryogenic cooling of the test masses of interferometric gravitational wave detectors is a promising way to reduce thermal noise. However, cryogenic cooling limits the incident power to the test masses, which limits the freedom of shaping the quantum noise. Cryogenic cooling also requires short and thick suspension fibers to extract heat, which could result in the worsening of thermal noise. Therefore, careful tuning of multiple parameters is necessary in designing the sensitivity of cryogenic gravitational wave detectors. Here, we propose the use of particle swarm optimization to optimize the parameters of these detectors. We apply it for designing the sensitivity of the KAGRA detector, and show that binary neutron star inspiral range can be improved by 10%, just by retuning seven parameters of existing components. We also show that the sky localization of GW170817-like binaries can be further improved by a factor of 1.6 averaged across the sky. Our results show that particle swarm optimization is useful for designing future gravitational wave detectors with higher dimensionality in the parameter space.

gr-qc↗

arXiv2018

Axion Search with Ring Cavity Experiment

We suggest a novel experimental method to search for axion dark matter with an optical ring cavity. Our cavity measures the difference of the resonant frequencies between two circular-polarizations of the laser beam. Its technical design adopts double-pass configuration to realize a null experiment and reject environmental common-mode noises. We reveal that it can probe the axion-photon coupling constant with a broad range of axion mass $10^{-17} \text{eV} \lesssim m \lesssim 10^{-10} \text{eV}$, up to several orders of magnitude beyond the current limits. We expect that this cavity experiment establishes a new window to develop the axion research.

physics.ins-det↗

arXiv2018

Optical Ring Cavity Search for Axion Dark Matter

We propose a novel experiment to search for axion dark matter which differentiates the phase velocities of the left and right-handed polarized photons. Our optical cavity measures the difference of the resonant frequencies between two circular-polarizations of the laser beam. The design of our cavity adopts double-pass configuration to realize a null experiment and give a high common mode rejection of environmental disturbances. We estimate the potential sensitivity to the axion-photon coupling constant $g_{aγ}$ for the axion mass $m \lesssim 10^{-10}$ eV. In a low mass range $m \lesssim 10^{-15}$ eV, we can achieve $g_{aγ} \lesssim 3\times 10^{-16} ~\text{GeV}^{-1}$ which is beyond the current bound by several orders of magnitude.

astro-ph.CO↗

arXiv2018

Demonstration of displacement sensing of a mg-scale pendulum for mm- and mg- scale gravity measurements

Gravity generated by large masses has been observed using a variety of probes from atomic interferometers to torsional balances. However, gravitational coupling between small masses has never been observed so far. Here, we demonstrate sensitive displacement sensing of the Brownian motion of an optically trapped 7-mg pendulum motion whose natural quality factor is increased to $10^8$ through dissipation dilution. The sensitivity for an integration time of one second corresponds to the displacement generated by the gravitational coupling between the probe and a mm separated 100 mg mass, whose position is modulated at the pendulum mechanical resonant frequency. Development of such a sensitive displacement sensor using a mg-scale device will pave the way for a new class of experiments where gravitational coupling between small masses in quantum regimes can be achieved.

quant-ph↗

arXiv2018

Polarization test of gravitational waves from compact binary coalescences

Gravitational waves have only two polarization modes in General Relativity. However, there are six possible modes of polarization in metric theory of gravity in general. The tests of gravitational waves polarization can be tools for pursuing the nature of space-time structure. The observations of gravitational waves with a world-wide network of interferometric detectors such as Advanced LIGO, Advanced Virgo and KAGRA will make it possible to obtain the information of gravitational wave polarization from detector signals. We study the separability of the polarization modes for the inspiral gravitational waves from the compact binary coalescences systematically. Unlike other waveforms such as burst, the binary parameters need to be properly considered. We show that the three polarization modes of the gravitational waves would be separable with the global network of three detectors to some extent, depending on signal-to-noise ratio and the duration of the signal. We also show that with four detectors the three polarization modes would be more easily distinguished by breaking a degeneracy of the polarization modes and even the four polarization modes would be separable.

gr-qc↗

arXiv2018

Seismic Cross-coupling Noise in Torsion Pendulums

Detection of low frequency gravitational waves around 0.1 Hz is one of the important targets for future gravitational wave observation. One of the main sources of the expected signals is gravi- tational waves from binary intermediate-mass black hole coalescences which is proposed as one of the formation scenarios of supermassive black holes. By using a torsion pendulum, which can have a resonance frequency of a few millihertz, such signals can be measured on the ground since its rotational motion can act as a free mass down to 0.01 Hz. However, sensitivity of a realistic tor- sion pendulum will suffer from torsional displacement noise introduced from translational ground motion in the main frequency band of interest. Such noise is called seismic cross-coupling noise and there have been little research on it. In this paper, systematic investigation is performed to identify routes of cross-coupling transfer for standard torsion pendulums. Based on the results this paper also proposes reduction schemes of cross-coupling noise, and they were demonstrated experimen- tally in agreement with theory. This result establishes a basic way to reduce seismic noise in torsion pendulums for the most significant coupling routes.

physics.ins-det↗

arXiv2018

A Direct Approach for the Fluctuation-Dissipation Theorem under Non-Equilibrium Steady-State Conditions

The test mass suspensions of cryogenic gravitational-wave detectors such as the KAGRA project are tasked with extracting the heat deposited on the optics. Thus these suspensions have a non-uniform temperature, requiring the calculation of thermal noise in non-equilibrium conditions. While it is not possible to describe the whole suspension system with one temperature, the local temperature anywhere in the system is still well defined. We therefore generalize the application of the fluctuation-dissipation theorem to mechanical systems, pioneered by Saulson and Levin, to non-equilibrium conditions in which a temperature can only be defined locally. The result is intuitive in the sense that the temperature-averaging relevant for the thermal noise in the observed degree of freedom is given by averaging the temperature field, weighted by the dissipation density associated with that particular degree of freedom. After proving this theorem we apply the result to examples of increasing complexity: a simple spring, the bending of a pendulum suspension fiber, as well as a model of the KAGRA cryogenic suspension. We conclude by outlining the application to non-equilibrium thermo-elastic noise.

gr-qc↗

arXiv2017

Optical Levitation of a Mirror for Reaching the Standard Quantum Limit

We propose a new method to optically levitate a macroscopic mirror with two vertical Fabry-P{é}rot cavities linearly aligned. This configuration gives the simplest possible optical levitation in which the number of laser beams used is the minimum of two. We demonstrate that reaching the standard quantum limit (SQL) of a displacement measurement with our system is feasible with current technology. The cavity geometry and the levitated mirror parameters are designed to ensure that the Brownian vibration of the mirror surface is smaller than the SQL. Our scheme provides a promising tool for testing macroscopic quantum mechanics.

quant-ph↗

arXiv2016

Direct measurement of the optical trap-induced decoherence

Thermal decoherence is a major obstacle to the realization of quantum coherence for massive mechanical oscillators. Although optical trapping has been used to reduce the thermal decoherence rate for such oscillators, it also increases the rate by subjecting the oscillator to stochastic forces resulting from the frequency fluctuations of the optical field, thereby setting a fundamental limit on the reduction. This is analogous to the noise penalty in an active feedback system. Here, we directly measure the rethermalizaton process for an initially cooled and optically trapped suspended mirror, and identify the current limiting decoherence rate as due to the optical trap. Our experimental study of the trap-induced decoherence rate will enable future advances in the probing of fundamental quantum mechanics in the bad cavity regime, such as testing of deformed commutators.

quant-ph↗

arXiv2016

Higher order test of Lorentz invariance with an optical ring cavity

We have developed an apparatus to search for the higher-order Lorentz violation in photons by measuring the resonant frequency difference between two counterpropagating directions of an asymmetric optical ring cavity. From the year-long data taken between 2012 and 2013, we found no evidence for the light speed anisotropy at the level of $δc/c \lesssim 10^{-15}$. Limits on the dipole components of the anisotropy are improved by more than an order of magnitude, and limits on the hexapole components are obtained for the first time. An overview of our apparatus and the data analysis in the framework of the spherical harmonics decomposition of anisotropy are presented. We also present the status of the recent upgrade of the apparatus.

gr-qc↗

arXiv2015

5-mg suspended mirror driven by measurement-induced back-action

Quantum mechanics predicts superposition of position states even for macroscopic objects. Recently, the use of a quasi-freely suspended mirror combined with laser was proposed to prepare such states, by Müller-Ebhardt et al. [Phys.Rev.Lett.100, 013601 (2008)]. One of the key milestones towards this goal is the preparation of the mechanical oscillator mainly driven by quantum back-action, which identifies the connection between the object and quantumness of the light. Here, we describe development of a suspended 5-mg mirror driven by quantum back-action larger than thermal fluctuating force by a factor of 1.4$\pm$0.2 at 325 Hz,which is confirmed by using a triangular optical cavity.

quant-ph↗

arXiv2014

An optically trapped mirror for reaching the standard quantum limit

The preparation of a mechanical oscillator driven by quantum back-action is a fundamental requirement to reach the standard quantum limit (SQL) for force measurement, in optomechanical systems. However, thermal fluctuating force generally dominates a disturbance on the oscillator. In the macroscopic scale, an optical linear cavity including a suspended mirror has been used for the weak force measurement, such as gravitational-wave detectors. This configuration has the advantages of reducing the dissipation of the pendulum (i.e., suspension thermal noise) due to a gravitational dilution by using a thin wire, and of increasing the circulating laser power. However, the use of the thin wire is weak for an optical torsional anti-spring effect in the cavity, due to the low mechanical restoring force of the wire. Thus, there is the trade-off between the stability of the system and the sensitivity. Here, we describe using a triangular optical cavity to overcome this limitation for reaching the SQL. The triangular cavity can provide a sensitive and stable system, because it can optically trap the mirror's motion of the yaw, through an optical positive torsional spring effect. To show this, we demonstrate a measurement of the torsional spring effect caused by radiation pressure forces.

physics.optics↗