Yuyao Shen | Searcharxiv

arXiv2025

RIS- and Multi-Snapshot-Enabled SISO 3D Position and Velocity Estimation With Single Base Station

Reconfigurable intelligent surface (RIS) panels can act as cost-effective anchors for radio localization, complementing conventional base station (BS) anchors. This paper investigates joint three-dimensional position and velocity estimation (3D-JPVE) in single-input single-output (SISO) systems with only one BS available. We first theoretically show that 3D-JPVE is infeasible when relying solely on a single RIS or on multiple snapshots alone. To address this, we propose combining RIS deployment with multi-snapshot utilization to enable realizable 3D-JPVE. A two-stage method is developed for multi-snapshot channel parameter estimation, comprising a tensor-based coarse estimation step followed by a maximum likelihood refinement step. In particular, we introduce a third-order tensor formulation to decompose the challenging 3D joint angle-of-departure and Doppler shift estimation (3D-JADE) into two tractable subproblems, which are jointly solved via a low-complexity alternating optimization approach. Building on the channel parameter estimates, we further design a two-stage low-complexity method for optimal 3D-JPVE: coarse estimation is obtained from differential measurements through linear equations, and the preliminary results are refined iteratively using the original measurements. Moreover, we derive the closed-form Cramer-Rao lower bound (CRLB) and show that the proposed 3D-JPVE method approaches CRLB-level accuracy. Simulation results confirm the statistical efficiency of the proposed estimators and demonstrate substantial 3D-JPVE performance gains when deploying active RIS compared to passive RIS.

cs.IT↗

arXiv2024

Structured Tensor Decomposition Based Channel Estimation and Double Refinements for Active RIS Empowered Broadband Systems

Channel parameter recovery is critical for the next-generation reconfigurable intelligent surface (RIS)-empowered communications and sensing. Tensor-based mechanisms are particularly effective, inherently capturing the multi-dimensional nature of wireless channels. However, existing studies assume either a line-of-sight (LOS) scenario or a blocked TX-RX channel. This paper solves a novel problem: tensor-based channel parameter estimation for active RIS-aided multiple-antenna broadband connections in fully multipath environments with the TX-RX link. System settings are customized to construct a fifth-order canonical polyadic (CP) signal tensor that matches the five-dimensional channel. Four tensor factors contain redundant columns, rendering the classical Kruskal's condition for decomposition uniqueness unsatisfied. The fifth-order Vandermonde structured CP decomposition (VSCPD) is developed to address this challenge, making the tensor factorization problem solvable using only linear algebra and offering a relaxed general uniqueness condition. With VSCPD as a perfect decoupling scheme, a sequential triple-stage channel estimation algorithm is proposed based on one-dimensional parameter estimation. The first stage enables multipath identification and algebraic coarse estimation. The following two stages offer optional successive refinements at the cost of increased complexity. The closed-form Cramer-Rao lower bound (CRLB) is derived to assess the estimation performance. Herein, the noise covariance matrix depends on multipath parameters in our active-RIS scenario. Numerical results are provided to verify the effectiveness of proposed algorithms under various evaluation metrics. Our results also show that active RIS can significantly improve channel estimation performance compared to passive RIS.

cs.IT↗