arXiv subjects

Zhaorui Wang

Publications and source records attributed to Zhaorui Wang.

29 records · Page 2Linked to original sources

arXiv2023

Scaling Law Analysis for Covariance Based Activity Detection in Cooperative Multi-Cell Massive MIMO

This paper studies the covariance based activity detection problem in a multi-cell massive multiple-input multiple-output (MIMO) system, where the active devices transmit their signature sequences to multiple base stations (BSs), and the BSs cooperatively detect the active devices based on the received signals. The scaling law of covariance based activity detection in the single-cell scenario has been thoroughly analyzed in the literature. This paper aims to analyze the scaling law of covariance based activity detection in the multi-cell massive MIMO system. In particular, this paper shows a quadratic scaling law in the multi-cell system under the assumption that the exponent in the classical path-loss model is greater than 2, which demonstrates that in the multi-cell MIMO system the maximum number of active devices that can be correctly detected in each cell increases quadratically with the length of the signature sequence and decreases logarithmically with the number of cells (as the number of antennas tends to infinity). This paper also characterizes the distribution of the estimation error in the multi-cell scenario.

cs.IT↗

arXiv2022

Quick and Reliable LoRa Physical-layer Data Aggregation through Multi-Packet Reception

This paper presents a Long Range (LoRa) physical-layer data aggregation system (LoRaPDA) that aggregates data (e.g., sum, average, min, max) directly in the physical layer. In particular, after coordinating a few nodes to transmit their data simultaneously, the gateway leverages a new multi-packet reception (MPR) approach to compute aggregate data from the phase-asynchronous superimposed signal. Different from the analog approach which requires additional power synchronization and phase synchronization, our MRP-based digital approach is compatible with commercial LoRa nodes and is more reliable. Different from traditional MPR approaches that are designed for the collision decoding scenario, our new MPR approach allows simultaneous transmissions with small packet arrival time offsets, and addresses a new co-located peak problem through the following components: 1) an improved channel and offset estimation algorithm that enables accurate phase tracking in each symbol, 2) a new symbol demodulation algorithm that finds the maximum likelihood sequence of nodes' data, and 3) a soft-decision packet decoding algorithm that utilizes the likelihoods of several sequences to improve decoding performance. Trace-driven simulation results show that the symbol demodulation algorithm outperforms the state-of-the-art MPR decoder by 5.3$\times$ in terms of physical-layer throughput, and the soft decoder is more robust to unavoidable adverse phase misalignment and estimation error in practice. Moreover, LoRaPDA outperforms the state-of-the-art MPR scheme by at least 2.1$\times$ for all SNRs in terms of network throughput, demonstrating quick and reliable data aggregation.

eess.SP↗

arXiv2022

Semantic Communication-Empowered Physical-layer Network Coding

In a two-way relay channel (TWRC), physical-layer network coding (PNC) doubles the system throughput by turning superimposed signals transmitted simultaneously by different end nodes into useful network-coded information (known as PNC decoding). Prior works indicated that the PNC decoding performance is affected by the relative phase offset between the received signals from different nodes. In particular, some "bad" relative phase offsets could lead to huge performance degradation. Previous solutions to mitigate the relative phase offset effect were limited to the conventional bit-oriented communication paradigm, aiming at delivering a given information stream as quickly and reliably as possible. In contrast, this paper puts forth the first semantic communication-empowered PNC-enabled TWRC to address the relative phase offset issue, referred to as SC-PNC. Despite the bad relative phase offsets, SC-PNC directly extracts the semantic meaning of transmitted messages rather than ensuring accurate bit stream transmission. We jointly design deep neural network (DNN)-based transceivers at the end nodes and propose a semantic PNC decoder at the relay. Taking image delivery as an example, experimental results show that the SC-PNC TWRC achieves high and stable reconstruction quality for images under different channel conditions and relative phase offsets, compared with the conventional bit-oriented counterparts.

cs.NI↗

arXiv2022

PNC Enabled IIoT: A General Framework for Channel-Coded Asymmetric Physical-Layer Network Coding

This paper investigates the application of physical-layer network coding (PNC) to Industrial Internet-of-Things (IIoT) where a controller and a robot are out of each other's transmission range, and they exchange messages with the assistance of a relay. We particularly focus on a scenario where the controller has more transmitted information, and the channel of the controller is stronger than that of the robot. To reduce the communication latency, we propose an asymmetric transmission scheme where the controller and robot transmit different amount of information in the uplink of PNC simultaneously. To achieve this, the controller chooses a higher order modulation. In addition, the both users apply channel codes to guarantee the reliability. A problem is a superimposed symbol at the relay contains different amount of source information from the two end users. It is thus hard for the relay to deduce meaningful network-coded messages by applying the current PNC decoding techniques which require the end users to transmit the same amount of information. To solve this problem, we propose a lattice-based scheme where the two users encode-and-modulate their information in lattices with different lattice construction levels. Our design is versatile on that the two end users can freely choose their modulation orders based on their channel power, and the design is applicable for arbitrary channel codes.

cs.IT↗

arXiv2022

Covariance-Based Joint Device Activity and Delay Detection in Asynchronous mMTC

In this letter, we study the joint device activity and delay detection problem in asynchronous massive machine-type communications (mMTC), where all active devices asynchronously transmit their preassigned preamble sequences to the base station (BS) for device identification and delay detection. We first formulate this joint detection problem as a maximum likelihood estimation problem, which depends on the received signal only through its sample covariance, and then propose efficient coordinate descent type of algorithms to solve the formulated problem. Our proposed covariance-based approach is sharply different from the existing compressed sensing (CS) approach for the same problem. Numerical results show that our proposed covariance-based approach significantly outperforms the CS approach in terms of the detection performance since our proposed approach can make better use of the BS antennas than the CS approach.

cs.IT↗

arXiv2022

Massive MIMO Communication with Intelligent Reflecting Surface

This paper studies the feasibility of deploying intelligent reflecting surfaces (IRSs) in massive MIMO (multiple-input multiple-output) systems to improve the performance of users in the service dead zone. To reduce the channel training overhead, we advocate a novel protocol for the uplink communication in the IRS-assisted massive MIMO systems. Under this protocol, the IRS reflection coefficients are optimized based on the channel covariance matrices, which are generally fixed for many coherence blocks, to boost the long-term performance. Then, given the IRS reflecting coefficients, the BS beamforming vectors are designed in each coherence block based on the effective channel of each user, which is the superposition of its direct and reflected user-IRS-BS channels, to improve the instantaneous performance. Since merely the user effective channels are estimated in each coherence block, the training overhead of this protocol is the same as that in the legacy wireless systems without IRSs. Moreover, in the asymptotic regime that the numbers of IRS elements and BS antennas both go to infinity with a fixed ratio, we manage to first characterize the minimum mean-squared error (MMSE) estimators of the user effective channels and then quantify the closed-form user achievable rates as functions of channel covariance matrices with channel training overhead and estimation error taken into account. Interestingly, it is shown that the properties of channel hardening and favorable propagation still hold for the user effective channels, and satisfactory user rates are thus achievable even if simple BS beamforming solutions, e.g., maximal-ratio combining, are employed. Finally, thanks to the rate characterization, we design a low-complexity algorithm to optimize the IRS reflection coefficients based on channel covariance matrices.

cs.IT↗

arXiv2020

Channel Estimation for Intelligent Reflecting Surface Assisted Multiuser Communications: Framework, Algorithms, and Analysis

In intelligent reflecting surface (IRS) assisted communication systems, the acquisition of channel state information (CSI) is a crucial impediment for achieving the beamforming gain of IRS because of the considerable overhead required for channel estimation. Specifically, under the current beamforming design for IRS-assisted communications, $KMN+KM$ channel coefficients should be estimated, where $K$, $N$ and $M$ denote the numbers of users, IRS reflecting elements, and antennas at the base station (BS), respectively. To accurately estimate such a large number of channel coefficients within a short time interval, we propose a novel three-phase pilot-based channel estimation framework in this paper for IRS-assisted uplink multiuser communications. Under this framework, we analytically prove that a time duration consisting of $K+N+\max(K-1,\lceil (K-1)N/M \rceil)$ pilot symbols is sufficient for the BS to perfectly recover all the $KMN+KM$ channel coefficients for the case without receiver noise at the BS. In contrast to the channel estimation for conventional uplink communications without IRS where the minimum channel estimation time is independent of the number of receive antennas at the BS, our result reveals the crucial role of massive MIMO (multiple-input multiple-output) in reducing the channel estimation time for IRS-assisted communications. Further, for the case with receiver noise, the user pilot sequences, IRS reflecting coefficients, and BS linear minimum mean-squared error (LMMSE) channel estimators are characterized in closed-form, and the corresponding estimation mean-squared error (MSE) is quantified.

cs.IT↗

arXiv2020

Intelligent Reflecting Surface Assisted Massive MIMO Communications

In a practical massive MIMO (multiple-input multiple-output) system, the number of antennas at a base station (BS) is constrained by the space and cost factors, which limits the throughput gain promised by theoretical analysis. This paper thus studies the feasibility of adopting the intelligent reflecting surface (IRS) to further improve the beamforming gain of the uplink communications in a massive MIMO system. Under such a novel system, the central question lies in whether the IRS is able to enhance the network throughput as expected, if the channel estimation overhead is taken into account. In this paper, we first show that the favorable propagation property for the conventional massive MIMO system without IRS, i.e., the channels of arbitrary two users are orthogonal, no longer holds for the IRS-assisted massive MIMO system, due to its special channel property that each IRS element reflects the signals from all the users to the BS via the same channel. As a result, the maximal-ratio combining (MRC) receive beamforming strategy leads to strong inter-user interference and thus even lower user rates than those of the massive MIMO system without IRS. To tackle this challenge, we propose a novel strategy for zero-forcing (ZF) beamforming design at the BS and reflection coefficients design at the IRS to efficiently null the inter-user interference. Under our proposed strategy, it is rigorously shown that even if the channel estimation overhead is considered, the IRS-assisted massive MIMO system can always achieve higher throughput compared to its counterpart without IRS, despite the fact that the favorable propagation property no longer holds.

cs.IT↗

arXiv2020

Channel Estimation for Intelligent Reflecting Surface Assisted Multiuser Communications

In the intelligent reflecting surface (IRS) assisted communication systems, the acquisition of channel state information (CSI) is a crucial impediment for achieving the passive beamforming gain of IRS because of the considerable overhead required for channel estimation. Specifically, under the current beamforming design for IRS-assisted communications, $KMN+KM$ channel coefficients should be estimated if the passive IRS cannot estimate its channels with the base station (BS) and users due to its lack of radio frequency (RF) chains, where $K$, $N$ and $M$ denote the number of users, reflecting elements of the IRS, and antennas at the BS, respectively. This number can be extremely large in practice considering the current trend of massive MIMO (multiple-input multiple-output), i.e., a large $M$, and massive connectivity, i.e., a large $K$. To accurately estimate such a large number of channel coefficients within a short time interval, we devote our endeavour in this paper to investigating the efficient pilot-based channel estimation method in IRS-assisted uplink communications. Building upon the observation that the IRS reflects the signals from all the users to the BS via the same channels, we analytically verify that a time duration consisting of $K+N+\max(K-1,\lceil (K-1)N/M \rceil)$ pilot symbols is sufficient for the BS to perfectly recover all the $KMN+KM$ channel coefficients in the case without noise. In contrast to the conventional uplink communications without IRS in which the minimum pilot sequence length for channel estimation is independent with the number of receive antennas, our study reveals the significant role of massive MIMO in reducing the channel training time for IRS-assisted communication systems.

cs.IT↗

arXiv2019

Coherent Detection for Short-Packet Physical-Layer Network Coding with FSK Modulation

This paper investigates coherent detection for physical-layer network coding (PNC) with short packet transmissions in a two-way relay channel (TWRC). PNC turns superimposed EM waves into network-coded messages to improve throughput in a relay system. To achieve this, accurate channel information at the relay is a necessity. Much prior work applies preambles to estimate the channel. For long packets, the preamble overhead is low because of the large data payload. For short packets, that is not the case. To avoid excessive overhead, we consider a set-up in which short packets do not have preambles. A key challenge is how the relay can estimate the channel and detect the network-coded messages jointly based on the received signals from the two end users. We design a coherent detector that makes use of a belief propagation (BP) algorithm to do so. For concreteness, we focus on frequency-shift-keying (FSK) modulation. We show how the BP algorithm can be simplified and made practical with Gaussian-mixture passing. In addition, we demonstrate that prior knowledge on the channel distribution is not needed with our framework. Benchmarked against the detector with prior knowledge of the channel distribution, numerical results show that our detector can have nearly the same performance without such prior knowledge.

cs.IT↗

arXiv2018

Noncoherent Detection for Physical-Layer Network Coding

This paper investigates noncoherent detection in a two-way relay channel operated with physical layer network coding (PNC), assuming FSK modulation and short-packet transmissions. For noncoherent detection, the detector has access to the magnitude but not the phase of the received signal. For conventional communication in which a receiver receives the signal from a transmitter only, the phase does not affect the magnitude, hence the performance of the noncoherent detector is independent of the phase. PNC, however, is a multiuser system in which a receiver receives signals from multiple transmitters simultaneously. The relative phase of the signals from different transmitters affects the received signal magnitude through constructive-destructive interference. In particular, for good performance, the noncoherent detector in PNC must take into account the influence of the relative phase on the signal magnitude. Building on this observation, this paper delves into the fundamentals of PNC noncoherent detector design. To avoid excessive overhead, we do away from preambles. We show how the relative phase can be deduced directly from the magnitudes of the received data symbols. Numerical results show that our detector performs nearly as well as a "fictitious" optimal detector that has perfect knowledge of the channel gains and relative phase.

cs.IT↗