arXiv subjects

Zhijia Sun

Publications and source records attributed to Zhijia Sun.

12 recordsLinked to original sources

arXiv2026

Development of Readout Electronics for a High-Speed Event-Driven Neutron Imaging Detector Based on Timepix4

As the Chinese Spallation Neutron Source enters Phase II, the increase in proton beam power will lead to a further boost in the intensity of pulsed neutron beams. To address the demand for higher event-rate readout electronics for energy-resolved neutron imaging detectors, we have developed a high-performance readout electronics system based on the Timepix4 chip. The prototype electronics system comprises a Timepix4 chip board and a high-performance digital board, which are interconnected through a custom FMC interface. The advantage of this system is its ability to achieve the full bandwidth readout of 160 Gbps for a single Timepix4 chip. The electronics system, based solely on a single ZYNQ-MPSOC chip, is capable of fully meeting the required performance specifications within a compact form factor of 8 cm x 30 cm. Furthermore, the system features a high-capacity external SODIMM memory interface (supporting up to 32 GB), which ensures stable data readout through a single 40 Gbps QSFP+ interface. As of the present moment, notable progress has been achieved, including the successful establishment of 16 data channels between Timepix4 and FPGA that operate error-free and stably at a speed of 5.12 Gbps, which is half of the maximum theoretical speed of 10.24 Gbps. The threshold standard deviation across all pixels is less than 50 e- after equalization. And the clear structural results obtained from X-ray experiments indicate that the functionality is essentially complete, allowing further testing.

physics.ins-det↗

arXiv2026

CTPX1: A Highly Integrated and High-Throughput Data-Driven Camera Based on Timepix4

The upgrade of the China Spallation Neutron Source (CSNS-II) will raise the proton beam power to 500 kW. Consequently, the existing Timepix3-based detector systems, limited to a count rate of 80 Mhits/s, will encounter severe saturation challenges. To address the demand of the Energy-Resolved Neutron Imaging instrument (ERNI) for next-generation higher count-rate electronics, this paper presents CTPX1, a high-performance data-driven camera system based on the Timepix4 ASIC. The system adopts a compact modular architecture, integrating readout electronics, a precision high-voltage bias unit, and a TEC temperature control subsystem. To fully exploit the readout potential of the Timepix4 ASIC's 16 high-speed serial links, this paper proposes a two-stage parallel processing architecture. This architecture achieves real-time data aggregation with a total bandwidth of up to 81.92 Gbps. Over a continuous 12-hour operation period, temperature fluctuations were kept within 0.1 °C while the high-voltage output noise remained below 1 mV. High-flux X-ray testing indicates that the system achieves a peak event readout rate of 1.17 Ghits/s, approaching the limit of the configured link speed. In-beam neutron verification at CSNS confirms that the camera successfully resolves fine spatial structures, achieving an imaging performance consistent with the 55 μm pixel pitch of the sensor. Furthermore, the clear observation of spectral features in the Time of flight (TOF) spectrum of a γ-Fe sample validates the system's good time resolution. This camera effectively addresses the data readout saturation challenges, validates the feasibility of Timepix4 technology for neutron imaging, and provides a viable solution for next-generation high-performance neutron imaging instruments.

physics.ins-det↗

arXiv2025

Flavor Physics at the CEPC: a General Perspective

We discuss the landscape of flavor physics at the Circular Electron-Positron Collider (CEPC), based on the nominal luminosity outlined in its Technical Design Report. The CEPC is designed to operate in multiple modes to address a variety of tasks. At the $Z$ pole, the expected production of 4 Tera $Z$ bosons will provide unique and highly precise measurements of $Z$ boson couplings, while the substantial number of boosted heavy-flavored quarks and leptons produced in clean $Z$ decays will facilitate investigations into their flavor physics with unprecedented precision. We investigate the prospects of measuring various physics benchmarks and discuss their implications for particle theories and phenomenological models. Our studies indicate that, with its highlighted advantages and anticipated excellent detector performance, the CEPC can explore beauty and $τ$ physics in ways that are superior to or complementary with the Belle II and Large-Hadron-Collider-beauty experiments, potentially enabling the detection of new physics at energy scales of 10 TeV and above. This potential also extends to the observation of yet-to-be-discovered rare and exotic processes, as well as testing fundamental principles such as lepton flavor universality, lepton and baryon number conservation, etc., making the CEPC a vibrant platform for flavor physics research. The $WW$ threshold scan, Higgs-factory operation and top-pair productions of the CEPC further enhance its merits in this regard, especially for measuring the Cabibbo-Kobayashi-Maskawa matrix elements, and Flavor-Changing-Neutral-Current physics of Higgs boson and top quarks. We outline the requirements for detector performance and considerations for future development to achieve the anticipated scientific goals.

hep-ex↗

arXiv2021

Characterization of Low-Pressure MWPC from 1E3 to 1E5 Pa

The LPMWPC can be used as the ΔE detector for the low-energy charged particle detection. In order to increase the transmittance, the wires were adopted as the cathode. This work investigated the LPMWPC signal characteristics of this configuration and measured the gas gain with a mixture of 90%Ar and 10% CO2 from 1E3 to 1E5 Pa. From the test, the second pulse after the avalanche signal was observed, which proved to be caused by the ions' drifting near the cathode wire.

physics.ins-det↗

arXiv2021

A novel energy resolved neutron imaging detector based on TPX3Cam for the CSNS

The China Spallation Neutron Source (CSNS) operates in pulsed mode and has a high neutron flux. This provides opportunities for energy resolved neutron imaging by using the TOF (Time Of Flight) approach. An Energy resolved neutron imaging instrument (ERNI) is being built at the CSNS but significant challenges for the detector persist because it simultaneously requires a spatial resolution of less than 100 μm, as well as a microsecond-scale timing resolution. This study constructs a prototype of an energy resolved neutron imaging detector based on the fast optical camera, TPX3Cam coupled with an image intensifier. To evaluate its performance, a series of proof of principle experiments were performed in the BL20 at the CSNS to measure the spatial resolution and the neutron wavelength spectrum, and perform neutron imaging with sliced wavelengths and Bragg edge imaging of the steel sample. A spatial resolution of 57 μm was obtained for neutron imaging by using the centroiding algorithm, the timing resolution was on the microsecond scale and the measured wavelength spectrum was identical to that measured by a beam monitor. In addition, any wavelengths can be selected for the neutron imaging of the given object, and the detector can be used for Bragg edge imaging. The results show that our detector has good performances and can satisfy the requirements of ERNI for detectors at the CSNS

physics.ins-det↗

arXiv2020

A sealed ceramic GEM-based neutron detector

The GEM-based neutron detector has flourished in the past decade. However almost all the GEM-based neutron detectors work in the flow-gas mode, and the long-term performances of the detectors may be unstable due to the dynamic changes of atmospheric pressure and ambient temperature. In this paper, a sealed ceramic GEM-based neutron detector was developed at China Spallation Neutron Source (CSNS) and its sensitive area was 100 mm * 100 mm. The characterizations of the detector were presented and discussed, which included the plateau curve, the neutron beam profile, the neutron wavelength spectrum, the spatial resolution (FWHM: 2.77 mm), the two-dimensional (2D) imaging ability, the neutron detection efficiency and the counting rate instability (Relative Standard Deviation (RSD): 0.7%). The results show that the detector has good performances in sealed mode, and it can be used for the measurement of the direct neutron beam at CSNS.

physics.ins-det↗

arXiv2020

Measurement of the neutron beam profile of the Back-n white neutron facility at CSNS with a Micromegas detector

The Back-n white neutron beam line, which uses back-streaming white neutrons from the spallation target of the China Spallation Neutron Source, is used for nuclear data measurements. A Micromegas-based neutron detector with two variants was specially developed to measure the beam spot distribution for this beam line. In this article, the design, fabrication, and characterization of the detector are described. The results of the detector performance tests are presented, which include the relative electron transparency, the gain and the gain uniformity, and the neutron beam profile reconstruction capability. The result of the first measurement of the Back-n neutron beam spot distribution is also presented.

physics.ins-det↗

arXiv2019

Measurements of differential and angle-integrated cross sections for the $^{10}$B($n, α$)$^{7}$Li reaction in the neutron energy range from 1.0 eV to 2.5 MeV

Differential and angle-integrated cross sections for the $^{10}$B($n, α$)$^{7}$Li, $^{10}$B($n, α$$_{0}$)$^{7}$Li and $^{10}$B($n, α$$_{1}$)$^{7}$Li$^{*}$ reactions have been measured at CSNS Back-n white neutron source. Two enriched (90%) $^{10}$B samples 5.0 cm in diameter and ~85.0 $μ$g/cm$^{2}$ in thickness each with an aluminum backing were prepared, and back-to-back mounted at the sample holder. The charged particles were detected using the silicon-detector array of the Light-charged Particle Detector Array (LPDA) system. The neutron energy E$_{n}$ was determined by TOF (time-of-flight) method, and the valid $α$ events were extracted from the E$_{n}$-Amplitude two-dimensional spectrum. With 15 silicon detectors, the differential cross sections of $α$-particles were measured from 19.2° to 160.8°. Fitted with the Legendre polynomial series, the ($n, α$) cross sections were obtained through integration. The absolute cross sections were normalized using the standard cross sections of the $^{10}$B($n, α$)$^{7}$Li reaction in the 0.3 - 0.5 MeV neutron energy region. The measurement neutron energy range for the $^{10}$B($n, α$)$^{7}$Li reaction is 1.0 eV $\le$ En < 2.5 MeV (67 energy points), and for the $^{10}$B($n, α$$_{0}$)$^{7}$Li and $^{10}$B($n, α$$_{1}$)$^{7}$Li$^{*}$ reactions is 1.0 eV $\le$ En < 1.0 MeV (59 energy points). The present results have been analyzed by the resonance reaction mechanism and the level structure of the $^{11}$B compound system, and compared with existing measurements and evaluations.

nucl-ex↗

arXiv2019

Cross interface model for the thermal transport across interface between overlapped boron nitride nanoribbons

The application of low-dimensional materials for heat dissipation requires a comprehensive understanding of the thermal transport at the cross interface, which widely exists in various composite materials and electronic devices. In this work, we proposed an analytical model, named as cross interface model (CIM), to accurately reveal the essential mechanism of the two-dimensional thermal transport at the cross interface. The applicability of CIM is validated through the comparison of the analytical results with molecular dynamics simulations for a typical cross interface of two overlapped boron nitride nanoribbons. Besides, it is figured out that the factor (η) has important influence on the thermal transport besides the thermal resistance inside and between the materials, which is found to be determined by two dimensionless parameters from its expression. Our investigations deepen the understanding of the thermal transport at the cross interface and also facilitate to guide the applications of low-dimensional materials in thermal management.

cond-mat.mes-hall↗

arXiv2019

Thermal conductivity of molybdenum disulfide nanotube from molecular dynamics simulations

Single layer molybdenum disulfide (SLMoS2), a semiconductor possesses intrinsic bandgap and high electron mobility, has attracted great attention due to its unique electronic, optical, mechanical and thermal properties. Although thermal conductivity of SLMoS2 has been widely investigated recently, less studies focus on molybdenum disulfide nanotube (MoS2NT). Here, the comprehensive temperature, size and strain effect on thermal conductivity of MoS2NT are investigated. A chirality-dependent strain effect is identified in thermal conductivity of zigzag nanotube, in which the phonon group velocity can be significantly reduced by strain. Besides, results show that thermal conductivity has a ~T-1 and a ~L\b{eta} relation with temperature from 200 to 400 K and length from 10 to 320 nm, respectively. This work not only provides feasible strategies to modulate the thermal conductivity of MoS2NT, but also offers useful insights into the fundamental mechanisms that govern the thermal conductivity, which can be used for the thermal management of low dimensional materials in optical, electronic and thermoelectrical devices. Introduction.

cond-mat.mes-hall↗

arXiv2018

Design of TDC ASIC based on Temperature Compensation

.On the basis of requirement of CSNS, we designed a TDC chip with temperature compensation function in this paper, which employed TSMC 180nm process. Using delay unit bufx8 as the major method, delay lines in each level delayed input signal line through the bufx8 unit to realize fundamental measurement function. The time intervals of two fixed delay standard pulses did not change with temperature variation via intra-chip phase-locked loop. After that, the two standard pulses were sent to TDC internal delay line and measured their values. Then the measured values and standard values were compared. According to the result of comparing and decision switch, the structure of delay lines was reconstructed and their levels were recorded at the same time. We could ensure that the total length of the effective delay line were close to clock cycle as much as possible under the current temperature. The chip was tested after the completion of design. It was found that the time resolution of TDC ASIC was 73ps under 1.8V power supply at room temperature while the time resolutions were 103ps and 62ps at 85$^\circ$ and 0$^\circ$, respectively.

physics.ins-det↗

arXiv2017

Experimental Study of Boron-coated Straws with a Neutron Source

Multiple types of high quality neutron detectors are proposed for the first phase of the China Spallation Neutron Source (CSNS), which will be commissioned in 2018. Considering the shortage of 3He supply, a detector module composed of 49 boron-coated straws (BCS) was developed by Proportional Technologies Inc. (PTI). Each straw has a length of 1000 mm and a diameter of 7.5 mm. Seven straws are tightly packed in a tube, and seven tubes are organized in a row to form a detector module. The charge division method is used for longitudinal positioning. A specific readout system was utilized to output the signal and simultaneously encode each straw. The performance of this detector module was studied using a moderated 252Cf source at the Institute of High Energy Physics (IHEP). The signal amplitude spectrum indicates its n-gamma discrimination capability. Despite the complex readout method, a longitudinal resolution of 6.1-0.5 mm was obtained. The three-dimensional positioning ability qualifies this BCS detector module as a promising neutron scattering spectrometer detector.

physics.ins-det↗