SearcharxivSearch

arXiv subjects

Zhong Ouyang

Publications and source records attributed to Zhong Ouyang.

2 recordsLinked to original sources

Adaptive Feedforward Neural Network Control with an Optimized Hidden Node Distribution

Composite adaptive radial basis function neural network (RBFNN) control with a lattice distribution of hidden nodes has three inherent demerits: 1) the approximation domain of adaptive RBFNNs is difficult to be determined a priori; 2) only a partial persistence of excitation (PE) condition can be guaranteed; and 3) in general, the required number of hidden nodes of RBFNNs is enormous. This paper proposes an adaptive feedforward RBFNN controller with an optimized distribution of hidden nodes to suitably address the above demerits. The distribution of the hidden nodes calculated by a K-means algorithm is optimally distributed along the desired state trajectory. The adaptive RBFNN satisfies the PE condition for the periodic reference trajectory. The weights of all hidden nodes will converge to the optimal values. This proposed method considerably reduces the number of hidden nodes, while achieving a better approximation ability. The proposed control scheme shares a similar rationality to that of the classical PID control in two special cases, which can thus be seen as an enhanced PID scheme with a better approximation ability. For the controller implemented by digital devices,the proposed method, for a manipulator with unknown dynamics, potentially achieves better control performance than model-based schemes with accurate dynamics.Simulation results demonstrate the effectiveness of the proposed scheme. This result provides a deeper insight into the coordination of the adaptive neural network control and the deterministic learning theory.

eess.SY

Development of a Tendon Driven Variable Stiffness Continuum Robot with Layer Jamming

The purpose of this research is to design, fabricate and test a tendon driven a continuum soft robot with three modular segments, each of which has a tunable stiffness enabled by layer jamming technology. Compared with previous studies, the robotic arm design of this project has a modular structure, which means the length of the robotic arm can be adjusted by addition of extra arm modules/segments to the existing robotic prototype. Furthermore, the new arm prototype supports motion within a 3-dimensional space. To achieve the goals, the design and fabrication for the variable stiffness robotic arm with compliant main structure and layer jamming mechanism has already been finished. Design and fabrication of the connector has also been finished to integrate several link modules into one robotic arm with multiple segments. The actuator located at the base of the arm has already been designed and tested. Finally, a stiffness test of one arm segment was conducted to verifying the load carrying capacity of the variable stiffness robotic arm, then the stiffness ratio of the layer jammed structure was calculated to analyze the stiffness improvement compared with unstiffened soft robot.

cs.RO