Zhuangyi Zhou | Searcharxiv

arXiv2026

What enables GaOx as hole transport layer for a 16 percent 1.0 eV CuInSe2 Bottom Cells with VOC above 550 mV?

Among the highly efficient photovoltaic technologies, that do not rely on epitaxy, only chalcopyrites have a bandgap tunable down to 1.00 eV, the ideal for tandem applications. This is obtained with a pure CuInSe2 absorber without Ga. GaOx has been shown to be an efficient hole transport layer that prevents recombination at the metallic back contact. On the other hand, GaOx has proven detrimental, when it forms on In containing transparent back contacts in bifacial solar cells. Here, we investigate the conditions that make the GaOx layer conductive. We employ a GaOx hole transport layer that is formed through ion exchange during co-evaporation of the low band gap absorber layer. We find that no additional Cu is needed, and that Na is not necessary for a conductive GaOx. Nor did we find a systematic influence of oxygen flow during the sputtering process of the oxide layer. The GaOx layer is partly crystalline. The optimized passivating hole transport layer enables a CuInSe2 bottom solar cell, without any addition of Ag or heavy alkalis, with an active area efficiency above 16% and a record-certified open-circuit voltage VOC of 552meV

cond-mat.mtrl-sci↗

arXiv2026

ALD Zinc Tin Oxide Buffers for Chalcopyrite Solar Cells: Electrical Barriers and Conduction Band Cliffs

Sulfide chalcopyrite, Cu(In,Ga)S2, having wide bandgap (larger than 1.5 eV), favorable optoelectronic properties, and high stability, is a promising top-cell absorber for tandem applications. Adapting device structures optimized for 1.0 - 1.2 eV absorbers to wide bandgap absorbers requires modification of the buffer layer. This work investigates atomic layer deposition of ZnSnO as an alternative buffer layer to conventional CdS. A critical parameter for bufferperformance is the conduction band offsets on both sides of the buffer. To investigate these buffers we electrically characterize solar cells utilizing different compositions of ZnSnO. The Sn/(Sn+Zn) atomic ratio is controlled by the ratio of ZnO to SnO cycles during atomic layer deposition. Solar cells were fabricated utilizing CuInSe2, Cu(In,Ga)Se2, and Cu(In,Ga)S2 absorbers, allowing cross-comparison with a variety of conduction band minimum energies. Buffer variation has two primary effects on cell performance: 1. Low tin buffers decrease the activation energy of interface recombination, reducing open circuit voltage. These observations indicates a cliff, a decrease of the conduction band minimum from absorber to buffer. 2. High tin buffers reduce the fill factor for all measured cells, and reduce the short circuit current under certain conditions. This observation indicates an electron transport barrier, conduction band offsets which limit the transport of electrons across the buffer, in either direction. We conclude that tin content correlates positively with the conduction band minimum of these buffers. Comparing different absorbers, cliffs occurs at lower Sn contents and the effects of barriers are more dramatic for absorbers with lower conduction band minima.

cond-mat.mtrl-sci↗